Filtern
Erscheinungsjahr
Dokumenttyp
Schlagworte
- Antrodia vaillantii (2)
- Beton (2)
- Betonangriff (2)
- Chelates (2)
- Cluster compounds (2)
- Copper(II) (2)
- Dauerhaftigkeit (2)
- Detoxification (2)
- Disposal (2)
- Laser-GMA-hybrid welding (2)
Organisationseinheit der BAM
The present work shows results on elemental distribution analyses in Cu(In,Ga)Se2 thin films for solar cells performed by use of wavelength-dispersive and energy-dispersive X-ray spectrometry (EDX) in a scanning electron microscope, EDX in a transmission electron microscope, X-ray photoelectron, angle-dependent soft X-ray emission, secondary ion-mass (SIMS), time-of-flight SIMS, sputtered neutral mass, glow-discharge optical emission and glow-discharge mass, Auger electron, and Rutherford backscattering spectrometry, by use of scanning Auger electron microscopy, Raman depth profiling, and Raman mapping, as well as by use of elastic recoil detection analysis, grazing-incidence X-ray and electron backscatter diffraction, and grazing-incidence X-ray fluorescence analysis. The Cu(In,Ga)Se2 thin films used for the present comparison were produced during the same identical deposition run and exhibit thicknesses of about 2 µm. The analysis techniques were compared with respect to their spatial and depth resolutions, measuring speeds, availabilities, and detection limits.
Two new octahedral cluster complexes [Re6S8(3,5-Me2PzH)6]Br2 · 2(3,5-Me2PzH) (1) and [Re6Se8(3,5-Me2PzH)6]Br2 · 2(3,5-Me2PzH) (2), where 3,5-Me2PzH is 3,5-dimethylpyrazole, have been synthesized using reaction of rhenium chalcobromide complexes Cs4[Re6S8Br6] · 2H2O and Cs3[Re6Se8Br6] · H2O, respectively, with molten 3,5-dimethylpyrazole. Both compounds synthesized were characterized by X-ray single-crystal diffraction and chemical analysis, IR and luminescent spectra.
Darstellung und Charakterisierung von Nanopartikeln auf der Basis von [Ti2W10PO40]7- und Chitosan
(2005)
The Keggin type polyoxotungstate [Ti2W10PO40]7- forms stable associates with the biopolymer chitosan in the nanometer size range. The cluster compound crystallizes from aqueous solution as K4H3[Ti2W10PO40] · 15H2O having a tetragonal structure. Both, the cluster compound and the chitosan/[Ti2W10PO40] associates show a high hydrolytic stability at pH 7.4. The associates formed between the cluster anion [Ti2W10PO40]7- with the polyaminosaccharide chitosan have been characterized by photon correlation spectroscopy, scanning electron microscopy, filtration, centrifugation and zeta potential measurements. The size of the associates formed is in the range of ca. 5×101 to 5×102 nm. These particles have a defined stoichiometry with 56 cluster anions bound per molecule chitosan. The isoelectric point determined by zeta potential measurements was found for a cluster anion to chitosan molar ratio of 5.5, indicating the charge neutralization between protonated chitosan and [Ti2W10PO40]7- anions. Cellular uptake studies with [Ti2W10PO40]7- using tumor cell lines FaDu (human squamous carcinoma) and HT-29 (human adenocarcinoma) showed that the tungsten amount inside the cells is remarkably enhanced in the presence of chitosan.
This paper presents the results of an interlaboratory study of the rheological properties of cement paste and ultrasound gel as reference substance. The goal was to quantify the comparability and reproducibility of measurements of the Bingham parameters yield stress and plastic viscosity when measured on one specific paste composition and one particular ultrasound gel in different laboratories using different rheometers and measurement geometries.
The procedures for both in preparing the cement paste and carrying out the rheological measurements on cement paste and ultrasound gel were carefully defined for all of the study’s participants. Different conversion schemes for comparing the results obtained with the different measurement setups are presented here and critically discussed. The procedure proposed in this paper ensured a reasonable comparability of the results with a coefficient of variation for the yield stress of 27% and for the plastic viscosity of 24%, despite the individual measurement series’ having been performed in different labs with different rheometers and measurement geometries.
"Ullmann's Encyclopedia of Industrial Chemistry" is the benchmark reference in chemistry and chemical and life science engineering, covering inorganic and organic chemicals, advanced materials, pharmaceuticals, polymers and plastics, metals and alloys, biotechnology and biotechnological products, food chemistry, process engineering and unit operations, analytical methods, environmental protection, and much more.
The present article is part of the topic collection "Environmental Protection and Industrial Safety". It covers plant and process safety, focusing on hazardous materials and process conditions.