Filtern
Erscheinungsjahr
- 2010 (2) (entfernen)
Dokumenttyp
- Dissertation (2) (entfernen)
Volltext vorhanden
- nein (2)
Gehört zur Bibliographie
- nein (2)
Schlagworte
- Bauakustik (1)
- Finiten Elemente Methode (1)
- Lightweight buildings (1)
- Trittschallmessung (1)
- Vibro-acoustic sources (1)
The work reported in this thesis addresses the problem of structure-borne sound transmission in buildings. Vibrating sources, such as services plant and domestic appliances, transmit vibro-acoustic power, causing noise complaints by occupants in rooms removed from the source room. There is not yet an accepted practical method of predicting the installed power into floors or supporting walls, and thence the resultant sound pressure in rooms.
This study concentrates on the prediction of the installed power from mechanical installations in lightweight buildings composed of framed and ribbed plates. To identify the characteristics of such receiver elements, a field survey has been undertaken, which involved measurement of the point and transfer mobilities of common wall and floor structures. It is shown that the range of measured values of receiver point mobility is surprisingly small and that the constructions investigated often displayed thin plate-like characteristics, with relatively small spatial variations in point mobility. These field measurements give support to the notion of averaging over contacts.
This single equivalent receiver mobility has been assembled both from measured data and from the approximate method and then used in combination with single equivalent source data, to yield an approximate prediction of the installed power. The agreement obtained between the exact and approximate values allowed consideration of a practical implementation of the approximate prediction method, based on a reception plate method which yields the activity and mobility of the tested machine as single equivalent values.
Die Forschung und Entwicklung im Bereich der Bauakustik erfolgt bislang schwerpunktmäßig durch aufwändige messtechnische Parameterstudien. Eine wesentliche Reduzierung dieses Aufwands kann dadurch erreicht werden, dass die Bauteil-Parameterstudien nicht mehr ausschließlich durch Messungen erfolgen, sondern auch anhand von geeigneten Berechnungsmodellen durchgeführt werden. Dazu wurde ein umfassendes Berechnungsmodell erarbeitet und anhand von Messergebnissen validiert. Wesentliche Grundlage für die volumenorientierte akustische Simulation ist dabei die p-Version der Methode der Finiten Elemente. Auf Basis der numerischen Berechnungen wurden die Wechselwirkungen der Deckenkomponenten untersucht und optimierte Konstruktionen erarbeitet. Nach deren messtechnischen Überprüfung konnten die Ergebnisse in Form von Konstruktionshilfen für optimierte Aufbauten zusammengestellt werden.