Filtern
Dokumenttyp
- Zeitschriftenartikel (7) (entfernen)
Schlagworte
- Interface (5)
- Adhäsion (4)
- Haftung (4)
- Reibung (4)
- Verbundwerkstoffe (4)
- Thermoplast (2)
- Thermoplaste (2)
- Verstärkungsfaser (2)
- Adhesion (1)
- Carbon fibers (1)
- Coating (1)
- Composites (1)
- Contact angle (1)
- Dynamic (1)
- Fiber properties (1)
- Films (1)
- Fluorination (1)
- Glass fibre (1)
- Glass transition (1)
- Interphase (1)
- Kristallisation (1)
- Matrix adhesion (1)
- Messmethode (1)
- Photoconduction (1)
- Polymer (1)
- Pull-out (1)
- Scherfestigkeit (1)
- Schubfestigkeit (1)
- Surface area (1)
- Transkristallisation (1)
- Viscoelastic (1)
Pull-out of Single Fibres
(1994)
An advanced equipment for single-fibre pull-out test designed to monitor the fracture process
(1995)
Viscoelastic properties of the interphase in fibre reinforced polymers - measurement and simulation
(1999)
The effect of transcrystallinity in carbon fiber reinforced poly(p-phenylene sulfide (PPS) composites on the apparent shear strength was investigated with the single fiber pull-out test. Transcrystalline zones around the reinforcing fibers do not seem to improve the adhesion level significantly. Neighbor fibers hinder the formation of the transcrystalline zone and a ductile fracture behavior can be observed. However, the apparent strength level is slightly higher for composites containing such reinforcing neighbor fibers compared with single fiber composite samples. During annealing a brittle interface can be formed in the multifiber composite yielding a higher level of the apparent shear strength.
Atmospheric-plasma fluorination was used to introduce fluorine functionalities onto the surface of carbon fibers without affecting their bulk properties. The interfacial adhesion between atmospheric-plasma-fluorinated carbon fibers and poly(vinylidene fluoride) (PVDF) was studied by means of direct wetting measurements and single fiber pullout tests. Measured contact angles of PVDF melt droplets on modified carbon fibers show that short exposure times of carbon fibers to atmospheric-plasma fluorination (corresponding to a degree of surface fluorination of F/C = 0.01 (1.1%)) leads to improved wettability of the fibers by PVDF melts. The apparent interfacial shear strength as a measure of practical adhesion, determined by the single-fiber pullout test, increases by 65% under optimal treatment conditions. The improved practical adhesion is not due to the formation of transcrystalline regions around the fibers or a change of the bulk matrix crystallinity or to an increased surface roughness; it seems to be due to the compatibilization of the interface caused of the atmospheric-plasma fluorination of the carbon fibers.
After a delamination process in a C-fiber reinforced polymer composite, the identification of the polymer residue of poly-(phenylene sulphide) on carbon fiber surfaces gives important information on the composite failure mechanism. Using scanning force microscopy (SFM) in its lateral force imaging mode or with the stiffness imaging mode, it is almost impossible to distinguish the two composite components owing to a very low material-based contrast of the local friction and compliance. The new technique using contrast based on a local AC current measurement allows a clear identification of the conducting carbon fiber and the non-conducting polymer coverage.