• Treffer 1 von 1
Zurück zur Trefferliste

A parametric study of shock wave simulations with help of COMSOL multiphysics

  • Adiabatic compression of gases can work as an ignition source and is still one of the main causes of accidents in chemical plants processing tetrafluoroethylene (Reza and Christiansen, 2007). The ignition of tetrafluoroethylene induced by adiabatic compression has been studied experimentally with a setup which allowed for the rapid opening of a high speed valve connecting two portions of a pipeline at different initial pressures. Due to the fast opening time and to the high pressure difference, a shock wave in the pipeline was generated. The propagation of the shock wave and its reflection at the end of the pipeline caused pressure and temperature increase. This led to some ignitions in the experiments performed. Nonetheless, in some test an ignition was not achieved, even if this was expected according to the theoretical temperatures predicted by the Rankine-Hugoniot equations. In order to understand the discrepancy between the experimental results and the theoretical predictions,Adiabatic compression of gases can work as an ignition source and is still one of the main causes of accidents in chemical plants processing tetrafluoroethylene (Reza and Christiansen, 2007). The ignition of tetrafluoroethylene induced by adiabatic compression has been studied experimentally with a setup which allowed for the rapid opening of a high speed valve connecting two portions of a pipeline at different initial pressures. Due to the fast opening time and to the high pressure difference, a shock wave in the pipeline was generated. The propagation of the shock wave and its reflection at the end of the pipeline caused pressure and temperature increase. This led to some ignitions in the experiments performed. Nonetheless, in some test an ignition was not achieved, even if this was expected according to the theoretical temperatures predicted by the Rankine-Hugoniot equations. In order to understand the discrepancy between the experimental results and the theoretical predictions, shock wave simulations have been carried out with COMSOL Multiphysics. The 'High Mach Flow' interface was used, since it solves the heat and impulse equations for fast flows. Figure 1 and Figure 2 show, respectively, the velocity and temperature distribution over time for a simulation in a 0.2 m pipeline of 20 mm in diameter with the following settings: - high pressure section: nitrogen initially at 20 bar; - low pressure section: nitrogen initially at 1 bar; - initial temperature of the system: 20 °C; - adiabatic walls with slip condition for the flow; - laminar flow. As from Figure 1 and Figure 2 the shock wave generation and propagation has been properly computed and the physical properties of the shock wave reflected the prediction of the Rankine-Hugoniot equation. Nonetheless, divergence problem occurred when trying to add turbulence to the system and strange temperature and profiles after the shock wave reflection were achieved if the no slip condition at the walls was chosen. Despite these limitations, it was possible to perform a parametric study and to analyze the effect of the pipe diameter and length on the shock wave evolution. Here simulations with constant wall temperature were carried out, in order to account for the heat losses to the pipe surroundings. Figure 3 shows that the temperature of the reflected wave is maintained for a longer time, if the pipe diameter is larger, due to minor heat losses. On the other hand, Figure 4 shows that higher average temperatures are achieved and maintained for a longer time if the pipe length increases. These results suggest that in the experiments performed by Meyer (2009) the pipe geometry was probably not optimal for the achievement/conservation of high temperatures and might explain the difficulty in inducing ignitions by adiabatic compression.zeige mehrzeige weniger

Metadaten exportieren

Weitere Dienste

Teilen auf Twitter Suche bei Google Scholar Anzahl der Zugriffe auf dieses Dokument
Metadaten
Autor*innen:Fabio Ferrero, Ronald Meyer-Scherf, Martin Kluge, Volkmar Schröder
Dokumenttyp:Beitrag zu einem Tagungsband
Veröffentlichungsform:Verlagsliteratur
Sprache:Englisch
Titel des übergeordneten Werkes (Englisch):COMSOL Conference 2012 (Proceedings)
Jahr der Erstveröffentlichung:2012
Herausgeber (Institution):COMSOL Inc.
Erste Seite:1
Letzte Seite:6
Freie Schlagwörter:Adiabatic compression; Numerical simulation; Shock wave
Veranstaltung:COMSOL Conference 2012
Veranstaltungsort:Milan, Italy
Beginndatum der Veranstaltung:2012-10-10
Enddatum der Veranstaltung:2012-10-12
ISBN:978-0-9839688-7-0
Bemerkung:
Geburtsname von Kluge, Martin: Beckmann-Kluge, M. -  Birth name of Kluge, Martin: Beckmann-Kluge, M.
Bemerkung:
Geburtsname von Meyer-Scherf, Ronald: Meyer, R. -  Birth name of Meyer-Scherf, Ronald: Meyer, R.
Verfügbarkeit des Dokuments:Physisches Exemplar in der Bibliothek der BAM vorhanden ("Hardcopy Access")
Bibliotheksstandort:Sonderstandort: Publica-Schrank
Datum der Freischaltung:19.02.2016
Referierte Publikation:Nein
Einverstanden
Diese Webseite verwendet technisch erforderliche Session-Cookies. Durch die weitere Nutzung der Webseite stimmen Sie diesem zu. Unsere Datenschutzerklärung finden Sie hier.