Filtern
Dokumenttyp
Schlagworte
In this paper the preparation of silicon and titanium oxide thin films using an atmospheric pressure plasma process will be reported. To obtain these oxide films hexamethyldisiloxane and titanium tetraisopropoxide were used as precursor materials. Based on the different chemical reaction mechanisms the film deposition processes were carried out in the direct as well as in the remote PACVD mode. The deposition parameters were varied and the influence on different film properties was studied. The deposited oxide films were characterised by profilometry, ellipsometry, SEM, UV-VIS-NIR-transmission measurements. FT-IR spectroscopy and contact angle measurements. Additionally, first results will be presented concerning the creation of composite films using a combination of plasma and liquid dye nebulization technique.
The multiple-sample approach by means of centrifugal adhesion testing (CAT-technology) allows the determination of bonding strength of adhesive-bonded joints on a statistical basis of up to eight samples. Therefore, it is obvious to ensure the continuous handling and identical processing of an octet of samples within the entire process chain of wet-chemical cleaning, plasma-chemical pre-treatment, bonding of samples, and testing of bonding strength. Within the multiple-sample bonding set-up (MPKV-technology) a defined bonding pressure can be adjusted regardless the actual number of samples. A comparison of single- and multiple-sample approach is made for bonding strength of selected adhesives, double-sided adhesive tapes and different material combinations [stainless steel (V2A) vs. stainless steel, polyamide (PA), or polypropylene (PP)]. It is shown that both technologies improve reliability of results
Die Bestimmung der Haftfestigkeit von Lackierungen, Beschichtungen oder Klebungen ist wichtig für die Beurteilung von entsprechenden Fertigungsabläufen. Unter Verwendung einer neuen Zentrifugentechnik wurde jetzt ein neues Mehr-Proben-Konzept zur schnellen Validierung von Klebverbindungen entwickelt.
Die Bestimmung der Haftfestigkeit von Lackierungen, Beschichtungen oder Klebeverbunden ist ein wichtiges Analyseinstrument bei der Beurteilung von entsprechenden Fertigungsabläufen. Unter Verwendung einer neuen Zentrifugentechnologie wurde in einem AiF Forschungsprojekt OKTETT die gesamte Prozesskette Vorbehandlung - Verklebung - Prüfung validiert.