TY - CHAP A1 - Läuter, Matthias A1 - Kramer, Tobias T1 - Non-gravitational acceleration and torque on comet 67P/Churyumov-Gerasimenko T2 - Bulletin of the AAS N2 - From August 2014 to September 2016, the ESA operated the Rosetta spacecraft mission alongside with comet 67P/Churyumov-Gerasimenko (67P). The mission provided valuable long-term data on the comet’s nucleus, including its volume, mass, tensor of inertia, spatial position of the orbital trajectory, and rotational state. Y1 - 2023 UR - https://baas.aas.org/pub/2023n8i218p02 VL - 55 IS - 8 ER - TY - CHAP A1 - Bürger, Johanna A1 - Hayne, Paul A1 - Gundlach, Bastian A1 - Läuter, Matthias A1 - Kramer, Tobias A1 - Blum, Jürgen T1 - Investigating the Latitudinal Dependence of Lunar Regolith Properties Using LRO/Diviner Data and a Microphysical Thermal Model T2 - Bulletin of the AAS N2 - Regolith is formed through weathering of the local rock by meteorite bombardment, space weathering (Pieters & Noble, 2016) and thermal erosion (Delbo et al., 2014). In the case of the Moon, the space weathering effects and diurnal temperature variations are reduced towards the poles. The aim of this study is to investigate whether the lunar regolith properties derived from the comparison of regolith temperatures measured by the Diviner radiometer (Paige et al., 2010) on board the Lunar Reconnaissance Orbiter (LRO) with simulated temperatures derived from a microphysical thermal model show a latitudinal dependence. The developed microphysical thermal model expands upon previous models by more directly simulating regolith properties, such as grain radius and volume filling factor. Y1 - 2023 UR - https://baas.aas.org/pub/2023n8i207p02 VL - 55 IS - 8 ER - TY - JOUR A1 - Bürger, Johanna A1 - Hayne, Paul A1 - Gundlach, Bastian A1 - Läuter, Matthias A1 - Kramer, Tobias A1 - Blum, Jürgen T1 - A Microphysical Thermal Model for the Lunar Regolith: Investigating the Latitudinal Dependence of Regolith Properties JF - Journal of Geophysical Research: Planets N2 - The microphysical structure of the lunar regolith provides information on the geologic history of the Moon. We used remote sensing measurements of thermal emission and a thermophysical model to determine the microphysical properties of the lunar regolith. We expand upon previous investigations by developing a microphysical thermal model, which more directly simulates regolith properties, such as grain size and volume filling factor. The modeled temperatures are matched with surface temperatures measured by the Diviner Lunar Radiometer Experiment on board the Lunar Reconnaissance Orbiter. The maria and highlands are investigated separately and characterized in the model by a difference in albedo and grain density. We find similar regolith temperatures for both terrains, which can be well described by similar volume filling factor profiles and mean grain sizes obtained from returned Apollo samples. We also investigate a significantly lower thermal conductivity for highlands, which formally also gives a very good solution, but in a parameter range that is well outside the Apollo data. We then study the latitudinal dependence of regolith properties up to ±80° latitude. When assuming constant regolith properties, we find that a variation of the solar incidence-dependent albedo can reduce the initially observed latitudinal gradient between model and Diviner measurements significantly. A better match between measurements and model can be achieved by a variation in intrinsic regolith properties with a decrease in bulk density with increasing latitude. We find that a variation in grain size alone cannot explain the Diviner measurements at higher latitudes. Y1 - 2024 U6 - https://doi.org/10.1029/2023JE008152 VL - 129 IS - 3 ER -