Refine
Document Type
- Article (2) (remove)
Institute
Language
- English (2)
Has Fulltext
- yes (2)
Is part of the Bibliography
- yes (2)
Keywords
- Anode (1)
- Cathode (1)
- Dog Bone Effect (1)
- Electrochemical (1)
- Interferometric (1)
- Micro-Galvanic Corrosion (1)
- Sub Microstructures (1)
In this paper, the indirect monitoring of plasma-induced defect formation within fused silica via plasma emission spectroscopy is presented. It is shown that low-pressure plasma treatment with hydrogen as process gas leads to a decrease in UV transmission of fused silica. This decrease can be directly attributed to oxygen vacancy-related defects and the presence of hydrogen within the silicon dioxide glass network. By the analysis of the plasma composition, it was observed that the amount of oxygen within the plasma increases with increasing treatment duration. Hence, oxygen was continuously released from glass network in the course of the plasma treatment. It was further observed that this release is strongly dependent on the applied plasma power where the lowest process efficiency occurs at the highest plasma power. It is shown that an increase in plasma power leads to a remarkable increase in light emission from the working gas, hydrogen. This observation indicates that the higher the degree of excitation and ionisation of the plasma, the lower the efficiency of plasma-induced formation of oxygen deficiency-related defects. This finding is of mentionable relevance for a better understanding of plasma-induced surface modification and coating processes.
In modern electrochemical coating technology, it is common practice to create uniform layers. However, this study focuses on the deposition of non-uniform layers achieved through a deliberate arrangement of micro structured electrodes on the anode side. The "dog bone effect” was employed as the primary approach [1]. When electroplating on an otherwise uniform surface, this effect selectively processes an area influenced by the geometric edge effect (figure 1 left). The coating within this area is intended to be (i) unevenly distributed and (ii) non-reproducible. Process data was obtained through electrochemical simulations and subsequently applied to a specially designed micro-galvanic setup. This enabled the production of suitable micro structured anodes, validation of coating parameters, and the deposition of visually imperceptible structured areas with inhomogeneous properties using "adhesive gold" on appropriate substrates such as silver and nickel. The layers and their local topography were characterized and analyzed using confocal laser microscopy, X-Ray fluorescence analysis (XRF), as well as a self-designed and constructed laser interference device. As a result, this specific galvanic process technology successfully produced metallic layers that (i) cannot be visually confirmed by the naked eye, (ii) exhibit varied microstructural anode geometries, (iii) display unique differences in layer thickness, (iv) possess non-reproducible and chaotic topographies, and (v) can be detected and identified using conventional analysis techniques or a simple interference setup.