Refine
Year of publication
Document Type
- conference proceeding (article) (15)
- Article (6)
- conference proceeding (presentation, abstract) (3)
- Part of Periodical (3)
- Report (3)
- Part of a Book (2)
- conference talk (2)
- Book (1)
Is part of the Bibliography
- no (35)
Keywords
- Defect detection (1)
- Fiber lasers (1)
- Ingenieurwissenschaften (1)
- Kunststoffe (1)
- Kunststoffschweißen (1)
- Laser ablation (1)
- Laser processing (1)
- Laser transmission welding (1)
- Laser welding (1)
- Laserscanner (1)
Institute
Begutachtungsstatus
- peer-reviewed (7)
Forschungsbericht 2016
(2016)
The joint strength is gaining importance in quasi -simultaneous laser transmission welds, especially in structural components. A correlation between the joint strength and a process characteristic is a basic requirement for selecting the best process parameter setting. In this work, the temperature is measured during welding polyamide 6 by using a scanner-integrated pyrometer with an InGaAs-detector. The filtering of the heat radiation in the upper joining partner is taken into account by calibrating the mea surement system. By this, the measured temperature signal represents the temperature in the joining zone. A correlation is found between the measured temperature and the resulting joint strength. Moreover, high joint strengths are also seen for welds with short welding times, as far as the temperature is sufficiently high. With this knowledge, a process window can be derived easily in order to produce welds with high strength and short welding times.
Predicting the core temperature during welding is an ambitious aim in many research works. In this work, a 3D-scanner with integrated pyrometer is characterized and used to measure the temperature during quasi-simultaneous laser transmission welding of polyamide 6. However, due to welding in an overlap configuration, the heat radiation emitted from the joining zone of a laser transmission weld has to pass through the upper polymer, which is itself a semi-transparent emitter. Therefore, the spectral filtering of the heat radiation in the upper polymer is taken into account by calibrating the pyrometer for the measurement task. Thermal process simulations are performed to compare the temperature field with the measured temperature signal. The absorption coefficients of the polymers are measured, in order to get precise results from the computation. The temperature signals during welding are in good agreement with the computed mean temperature inside the detection spot, located in the joining area. This is also true for varying laser power, laser beam diameter and the carbon black content in the lower polymer. Both, the computed mean temperature and the temperature signal are representing the core temperature. In order to evaluate the spatial sensitivity of the measurement system, the emitted heat radiation from both polymers is calculated on basis of the computed temperature field. Hereby it is found, that more than 90 percent of the detected heat radiation comes from the joining area, which is a crucial information for contact-free temperature measurement tasks on semi-transparent polymers.
Thermo-mechanical simulation offers great opportunities to optimize welding processes of plastics. For realistic simulation, the temperature dependent mechanical properties need to be implemented from ambient temperature to temperatures above the flow temperature. Standard test methods are insufficient for characterization in the entire temperature range because close to the flow temperature the material is too soft for tensile tests and too stiff for rheometry. Therefore, an optimization strategy is developed, that determines unknown material parameters by testing in welding simulations. The unknown parameters are iteratively adjusted to minimize the mismatch between computed and measured set-paths. Thus, important process characteristics are calculated realistically, enabling the computer aided assessment of the weld quality.