TY - GEN A1 - Sterner, Michael T1 - Gas aus einer Gesamtenergieversorgungsperspektive - Warum wir Power-to-X für die Klimaneutralität brauchen T2 - Kopernikus-Konferenz Projekt "Ensure" (Deutsche Umwelthilfe), 15. April 2021 KW - Erneuerbare Energien KW - Klimaneutralität KW - Energiewende KW - Sektorenkopplung KW - Power-to-Gas Y1 - 2021 ER - TY - INPR A1 - Kaul, Anja A1 - Böllmann, Andrea A1 - Thema, Martin A1 - Kalb, Larissa A1 - Stöckl, Richard A1 - Huber, Harald A1 - Sterner, Michael A1 - Bellack, Annett T1 - Identification of Robust Thermophilic Methanogenic Archaea and Packing Material for High Liquid Hold-Up at Low Volumetric Gas Flow Rates for Use in Trickle-Bed Reactors for Biological Methanation T2 - SSRN Electronic Journal N2 - he hydrogen gas-to-liquid mass transfer is the limiting factor in biological methanation. In a trickle-bed reactor, mass transfer can be increased by high flow velocities in the liquid phase, by adding a packing material with high liquid hold-up, or by choosing methanogenic archaea with a high methane productivity. This study analyzed various packings and methanogenic strains from a hydrodynamic and microbial perspective. By analyzing twelve pure cultures of thermophilic methanogens for their ability to produce high quality methane and to form biofilms on different packings, strains of Methanothermobacter were found to perform better than thus of the genus Methanothermococcus. Best methane production and adherence was observed on DuraTop®, Bioflow 9, and filter foam. DuraTop® and Bioflow 9 had also a high dynamic liquid hold-up, but the maximum hold-up was determined for expanded clay. The ideal combination for use in the ORBIT-trickle-bed reactor was identified as Methanothermobacter thermoautotrophicus IM5 and DuraTop®. KW - Liquid hold-up maximization KW - Methane production KW - Methanothermobacter KW - Methanothermococcus KW - Optimized packing-organism combination Y1 - 2021 U6 - https://doi.org/10.2139/ssrn.3940878 N1 - final peer reviewed article published under: https://doi.org/10.1016/j.biortech.2021.126524 ER - TY - GEN A1 - Sterner, Michael A1 - Schumm, Leon T1 - Netzpuffer – Speicher & Kraftwerke als virtuelle Leitungen für mehr Versorgungssicherheit und EE-Integration in Nord und Süd T2 - 7. Smart-Grid-Fachtagung WAGO, Hannover, 29. Sept. 2021 KW - Stromspeicher KW - Batterien KW - Netzpuffer KW - Stromnetz Y1 - 2021 ER - TY - GEN A1 - Sterner, Michael T1 - Grüner Wasserstoff - wo wir ihn brauchen für die Klimaneutralität T2 - Energiewendeforum Wasserstoff (Grüner Strom Label e. V.), Bonn, 21. September 2021 KW - Erneuerbare Energien KW - Klimaneutralität KW - Energiewende KW - Wasserstoff Y1 - 2021 ER - TY - GEN A1 - Sterner, Michael T1 - Wie wird Deutschland klimaneutral? Neue Lösungen für erneuerbare Energieerzeugung T2 - Jahreskonferenz der Stiftung Nagelschneider zur Erforschung, München, 19.11.2021 KW - Erneuerbare Energien KW - Klimaneutralität KW - Energiewende KW - Klimaschutz Y1 - 2021 CY - München ER - TY - GEN A1 - Sterner, Michael T1 - Power-to-X for Europes Energy Transformation – Booster H2Global T2 - Hydrogen Online Workshop Conference (Mission Hydrogen), 25.03.2021 KW - Erneuerbare Energien KW - Klimaneutralität KW - Energiewende KW - Sektorenkopplung KW - Power-to-X Y1 - 2021 ER - TY - GEN A1 - Sterner, Michael T1 - Technologieausblick Solarstromspeicher T2 - Innovationsforum Photovoltaik, 18. Oktober 2021, Linz KW - Erneuerbare Energien KW - Klimaneutralität KW - Energiewende KW - Solarstrom KW - Energiespeicher KW - Photovoltaik Y1 - 2021 ER - TY - GEN A1 - Sterner, Michael T1 - Die Grenzen des Wasserstoff-Hypes T2 - 1. Mitteldeutscher Wasserstoffkongress, 2. November 2021, Leuna CCE Kulturhaus KW - Erneuerbare Energien KW - Klimaneutralität KW - Energiewende KW - Wasserstoff Y1 - 2021 ER - TY - CHAP A1 - Altmann, Robert A1 - Gebhard, Jürgen A1 - Troeger, Adrian A1 - Winkler, Markus A1 - Töpfer, Georg A1 - Remmele, Edgar A1 - Gaderer, Matthias A1 - Rabl, Hans-Peter ED - Berns, Karsten ED - Dressler, Klaus ED - Kalmar, Ralf ED - Stephan, Nicole ED - Teutsch, Roman ED - Thul, Martin T1 - Engine performance and emission analysis of a NRMM CI engine with common rail injection system operated with diesel fuel and rapeseed oil fuel T2 - Proceedings of the 6th Commercial Vehicle Technology Symposium 2020/2021 N2 - The use of alternative fuels in high-power non-road mobile machinery (NRMM) combustion engines is a possible way to substitute fossil fuel. By using pure vegetable oil fuels, like rapeseed oil fuel (DIN 51605), the greenhouse gases can be reduced effectively. Due to the differences in physical and chemical properties, a modification of the engine control unit calibration is necessary to adapt the working process on the fuel. Without modifications, the engine power output with rapeseed oil fuel is lower than with diesel fuel because of the smaller energy content. By adapting the engine settings, like the injection fuel mass, the power loss can be compensated but it accompanies with a higher fuel consumption. The engine emissions at part load conditions show, that there are benefits in particle emissions by using rapeseed oil at similar NOx emissions. Therefore, a design of experiment setup was initiated on a selected engine operation point to determine the effects of further parameters, like rail pressure, manifold pressure and injection pattern, on the process and to see the potential of an optimized calibration. KW - CI engine KW - common rail injection KW - Diesel Engine KW - DoE KW - rapeseed oil Y1 - 2021 SN - 978-3-658-29716-9 U6 - https://doi.org/10.1007/978-3-658-29717-6_16 SP - 231 EP - 242 PB - Springer Vieweg CY - Wiesbaden ER - TY - CHAP A1 - Buttner, Johannes A1 - Alonso-Villa, Cristina A1 - Bohigas Boladeras, Pere A1 - Kucera, Markus A1 - Waas, Thomas T1 - The Need for New Software Architectures for Next-generation Vehicle T2 - Proceedings of the 5th International E-Conference on Advances in Engineering, Technology and Management (ICETM 2021) N2 - Assuming that future connected cars with automated driving functions will require even more computing power and communication bandwidth, the current network infrastructure as well as the existing individualized control units are not a profitable option for such vehicles. In addition, changing user expectations demand flexible architectural patterns and upgradeability of software components without the need to visit the workshop. However, the current statically developed and configured ECU architecture does not offer any practicable possibilities for this. For these reasons, the research for a new dynamic and flexible architecture is necessary. This new type of system architecture is expected to meet future requirements in terms of space, cost, performance, energy efficiency and number of required computing units in the vehicle, which will arise as a result of the implementation/inclusion of new automated driving functionalities, and due to the changes in user expectations. Solutions to this issue can be found in the field of enterprise IT (cluster computing), in which technologies such as Ethernet, container-based virtualization and flexible software architectures have proven themselves to be very efficient for years. Relevant infrastructures, for example from cloud computing providers, have commonly been used in high-performance or high-availability applications. Thus, in the research project A 3F has been investigated which of these concepts and methods can be applied to modern vehicle system architectures. One of the main goals is to assess the synergy potential of the two sectors, information technology and automotive industry, which to date have very different orientations. However, this synergy is expected to grow strongly in the course of the developments mentioned above. In the following pages, the necessary changes related to hardware and software will be discussed briefly und will be compared to concepts and possible solutions from the IT world. Y1 - 2021 UR - https://www.seekdl.org/conferences/paper/details/10605.html SN - 978-1-63248-192-4 SP - 58 EP - 61 ER -