TY - JOUR A1 - Schreiner, Rupert A1 - Wiedmann, J. A1 - Coenning, W. A1 - Porsche, J. A1 - Gentner, Jean-Louis A1 - Berroth, Manfred A1 - Scholz, Ferdinand A1 - Schweizer, H. T1 - Fabrication approach for antiphase narrow linewidth complex coupled 1.55 μm DFB lasers JF - Electronics Letters N2 - A new method for fabricating narrow linewidth antiphase complex coupled MQW DFB lasers by periodically etching the active layer and quartemary InGaAsP overgrowth is reported. The minimum linewidth for a 375 µm long ridge waveguide laser is only 250 kHz at an optical output power of 4 mW. KW - etching KW - optical fabrication KW - quantum well lasers KW - ridge waveguides KW - distributed feedback lasers Y1 - 1999 U6 - https://doi.org/10.1049/el:19990132 SN - 0013-5194 VL - 35 IS - 2 SP - 146 EP - 148 PB - The Institution of Engineering and Technology IET ER - TY - JOUR A1 - Hausladen, Matthias A1 - Schels, Andreas A1 - Asgharzade, Ali A1 - Buchner, Philipp A1 - Bartl, Mathias A1 - Wohlfartsstätter, Dominik A1 - Edler, Simon A1 - Bachmann, Michael A1 - Schreiner, Rupert T1 - Investigation of Influencing Factors on the Measurement Signal of a CMOS Image Sensor for Measuring Field Emission Currents JF - Sensors Y1 - 2025 U6 - https://doi.org/10.3390/s25051529 N1 - Corresponding author der OTH Regensburg: Matthias Hausladen VL - 25 IS - 5 PB - MDPI ER - TY - CHAP A1 - Ławrowski, Robert Damian A1 - Langer, Christoph A1 - Schreiner, Rupert A1 - Sellmair, Josef T1 - Nano Emitters on Silicon Pillar Structures generated by a Focused Electron Beam Induced Deposition T2 - International Vacuum Nanoelectronics Conference (IVNC), 31st, 2018, Kyoto, Japan N2 - Nano emitters were deposited by focused electron beam induced deposition of Trimethyl-(methylcyclopentadienyl)platinum(IV) on top of silicon pillars. The nano emitters were exactly positioned in the center on the top of up to four pillars of a quadratic arranged array of sixteen pillars with a pitch of 50 μm. Integral field emission measurements were performed in a diode configuration with a 50 μm mica spacer in a vacuum chamber at pressures of about 10 -9 mbar. The Fowler-Nordheim plots show a linear behavior, like expected for an n-type silicon material and a metal needle. The I-V measurement of the most promising sample shows an integral emission current up to 2 μm at a voltage of 600 V (12 MV/m) and an onset voltage for a current of 1 nA of about 300 V. KW - field emission KW - nano emitter KW - focused electron beam induced deposition KW - MeCpPtMe3 Y1 - 2018 U6 - https://doi.org/10.1109/IVNC.2018.8520059 PB - IEEE ER - TY - CHAP A1 - Buchner, Philipp A1 - Hausladen, Matthias A1 - Bartl, Mathias A1 - Schreiner, Rupert T1 - Elektronenquellen basierend auf Feldemission aus Silizium T2 - Tagungsband zum 4. Symposium Elektronik und Systemintegration ESI: 17. April 2024, Hochschule Landshut N2 - Der Beitrag gibt einen Überblick über zwei typische Bauformen für Elektronenquellen auf der Basis von Feldemission aus Silizium. Des Weiteren wird eine typische Trioden-Beschaltung solcher Elektronenquellen für hohe Elektronentransmission vorgestellt und dabei auf ihre Leistungsfähigkeit eingegangen. Y1 - 2024 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:bvb:860-opus4-4212 SN - 978-3-9818439-9-6 SP - 46 EP - 53 PB - Hochschule für Angewandte Wissenschaften Landshut CY - Landshut ER - TY - JOUR A1 - Eiler, Julian A1 - Weber, Stefan A1 - Gerlesberger, Peter A1 - Plöchinger, Heinz A1 - Schreiner, Rupert T1 - Active heat-loss compensated miniaturized pirani sensor chip JF - IEEE Sensors Letters N2 - Due to the limited measuring range of commercial Pirani sensors in lower pressure regimes, attempts are being made to extend the measuring range of the sensors. Our approach to extend the measuring range toward lower pressures is a micro-electromechanical systems (MEMS) Pirani sensor with active heat compensation on the suspensions. The sensor element has the shape of a microhotplate and consists of a nickel heating meander embedded in two silicon nitride layers. The whole structure is built on a silicon wafer. The sensor element is suspended on all four corners of the substrate. On each of the suspensions, there is an additional heating structure that minimizes the heat flux from the hot sensor element toward the substrate. The sensor is driven at a constant temperature through a self-balancing Wheatstone bridge. A constant voltage is applied to the heating structures on the suspensions. It has been demonstrated that with these additional heaters, the sensitivity of the sensor can be increased in the high-vacuum regime. This enables reliable vacuum measurements down to 10−6 mbar. KW - Temperature measurement KW - Heating systems KW - Temperature sensors KW - Sensitivity KW - Pressure measurement KW - Voltage measurement KW - Heat sinks KW - Semiconductor device measurement KW - Noise measurement KW - Bridge circuits Y1 - 2025 U6 - https://doi.org/10.1109/LSENS.2025.3605747 SN - 2475-1472 VL - 9 IS - 10 PB - Institute of Electrical and Electronics Engineers (IEEE) ER - TY - GEN A1 - Eiler, Julian A1 - Weber, Stefan A1 - Gerlesberger, Peter A1 - Plöchinger, Heinz A1 - Schreiner, Rupert T1 - Miniaturized Pirani vacuum sensor with active heat-loss compensation T2 - Verhandlungen der Deutschen Physikalischen Gesellschaft e.V. (DPG), Regensburg, 16. - 21. März 2025 N2 - Pirani sensors measure the thermal conductivity of the residual gas in a vacuum by creating a thermal gradient between a heated sensor element and a heat sink. The heat flux from the sensor element to the heat sink over the residual gas is a measure of the vacuum and can be determined by the electrical power applied. In addition to the heat flux over the gas, there are further energy losses from the heating structure due to radiation and parasitic heat fluxes via the suspensions of the sensor element. These losses reduce the sensitivity of the sensor. For this reason, a Micro-Pirani sensor in the shape of a microhotplate was developed that actively compensates the heat flux via the suspensions. This was achieved by placing additional heating structures on the suspensions, which interrupt the heat flow from the sensor element via the suspensions during operation. This active compensation improves the sensitivity at low pressures, enabling vacuum measurements from atmospheric pressure down to 10e-6 mbar. Y1 - 2025 UR - https://www.dpg-verhandlungen.de/year/2025/conference/regensburg/part/o/session/66/contribution/7 SN - 2751-0522 PB - Deutsche Physikalische Gesellschaft e.V. ER - TY - CHAP A1 - Eiler, Julian A1 - Berndt, Dominik A1 - Schreiner, Rupert T1 - Miniaturisierter Wasserstoffsensor basierend auf der 3-Omega Methode T2 - Tagungsband zum 4. Symposium Elektronik und Systemintegration ESI: 17. April 2024, Hochschule Landshut N2 - Die Arbeit stellt einen thermischen Wasserstoffsensor auf Siliziumbasis vor, der mit der 3-Omega Messmethode betrieben wird. Durch das dynamische Messverfahren, die große Sensoroberfläche bei gleichzeitig geringer thermischer Masse und der Materialkombination wird eine Auflösungsgrenze von 55 ppm Wasserstoff in Stickstoff erreicht. Y1 - 2024 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:bvb:860-opus4-4205 SN - 978-3-9818439-9-6 SP - 38 EP - 45 PB - Hochschule für Angewandte Wissenschaften Landshut CY - Landshut ER - TY - GEN A1 - Krysztof, Michal A1 - Baranowski, Kamil A1 - Zychla, Michal A1 - Hausladen, Matthias A1 - Schreiner, Rupert A1 - Knápek, Aleksandr T1 - MP61 - Detection of Electron Beam in Atmospheric Pressure Using CMOS Image Sensor T2 - EUROSENSORS XXXVII ; 07.09.2025 - 10.09.2025 ; Wroclaw ; Poster I N2 - In the article, a new detection system that enables observation of the electron beam signal passing through a gas layer at atmospheric pressure is presented. An experimental setup consisting of an elec-tron gun (electron emitter, extraction, and focus electrodes), silicon nitride membrane, and a CMOS image sensor is described, as well as first image of the electron beam spot after passing through 400 µm of air at atmospheric pressure is presented. Y1 - 2025 U6 - https://doi.org/10.5162/EUROSENSORS2025/MP61 SP - 325 EP - 326 PB - AMA ER - TY - CHAP A1 - Bartl, Mathias A1 - Hausladen, Matthias A1 - Asgharzade, Ali A1 - Buchner, Philipp A1 - Krysztof, Michal A1 - Knápek, Alexandr A1 - Bachmann, Michael A1 - Schreiner, Rupert T1 - Experimental method for investigation of the emission pattern characteristics of individual field emission tips using a CMOS image sensor T2 - 38th International Vacuum Nanoelectronics Conference (IVNC) N2 - The emission pattern characteristics of individual silicon field emission tips were investigated using a CMOS image sensor. The quality of the image was improved by spatial and temporal averaging, so that individual emission centers could be identified and their temporal changes investigated. By mapping the emission current onto the image, the distribution of the current density on the image sensor could be calculated. KW - CMOS image sensors KW - Silicon KW - Current density KW - Nanoelectronics Y1 - 2025 U6 - https://doi.org/10.1109/IVNC65669.2025.11121040 PB - IEEE ER - TY - CHAP A1 - Baranowski, Kamil A1 - Zychla, Michał A1 - Krysztof, Michał A1 - Żółtowski, Michał A1 - Hausladen, Matthias A1 - Schreiner, Rupert A1 - Knápek, Aleksandr T1 - Experimenal method for studying electron beams in gaseous environments using a CMOS image sensor T2 - 38th International Vacuum Nanoelectronics Conference (IVNC) N2 - Detecting and analyzing electron beams in atmospheric conditions remains a significant challenge due to scattering and absorption of electrons by gas molecules. In this work, a novel approach using a CMOS image sensor for real-time electron beam detection after its transmission through air is presented. The setup enables visualization of beam divergence, emission profiles, and dynamic behavior under atmospheric pressure. Presented results demonstrate the potential of CMOS image sensor for electron beam analysis in gaseous environment. Y1 - 2025 SN - 979-8-3315-3705-0 U6 - https://doi.org/10.1109/IVNC65669.2025.11120851 PB - IEEE ER - TY - CHAP A1 - Allaham, Mohammad M. A1 - Burda, Daniel A1 - Knápek, Alexandr A1 - Krysztof, Michał A1 - Baranowski, Kamil A1 - Hausladen, Matthias A1 - Schreiner, Rupert T1 - Testing the performance of tungsten-graphite cathodes as MEMS Electron microscope electron source T2 - 38th International Vacuum Nanoelectronics Conference (IVNC) N2 - This work presents preliminary results of the performance testing of exfoliated graphene layers deposited on the nanotip of a tungsten field emission cathode. The obtained tungsten-graphite cathodes were then operated in a 3D-printed MEMS electron microscope testing model for later applications. The results were promising, where a maximum emission current of 50.2 μA was obtained with an extraction voltage of 1 kV and anode voltage of 3 kV. Y1 - 2025 U6 - https://doi.org/10.1109/IVNC65669.2025.11121041 PB - IEEE ER - TY - CHAP A1 - Asgharzade, Ali A1 - Bartl, Mathias A1 - Hausladen, Matthias A1 - Chen, Yang A1 - Buchner, Philipp A1 - Edler, Simon A1 - Bachmann, Michael A1 - She, Juncong A1 - Schreiner, Rupert T1 - Investigation on the influence of internal voltage drops on the emission behavior of silicon field emission arrays using CMOS image sensor T2 - 38th International Vacuum Nanoelectronics Conference (IVNC) N2 - In this paper we report on an improved measurement and analysis method for determining the emission current distribution of field emitter arrays with CMOS sensors. It can also be used for field emission arrays where not all surfaces of the emitters are at the same electrical potential (e.g. for p-doped Si tips, where a strong current saturation occurs). To demonstrate the functionality of this method, a n-doped field emission array was measured using a variable external series resistance. Brightness variations in emission spots were analyzed to re-calculate the known series resistances for comparison. The re-calculated value is in good agreement with the actual value of the resistance. This method offers a quantitative approach to assess internal voltage drop effects on field emission using optical readout KW - field emission imaging KW - field emission KW - CMOS sensor Y1 - 2025 U6 - https://doi.org/10.1109/IVNC65669.2025.11120937 PB - IEEE ER -