TY - JOUR A1 - Monkman, Gareth J. A1 - Sindersberger, Dirk A1 - Diermeier, Andreas A1 - Prem, Nina T1 - The magnetoactive electret JF - smart materials and structures N2 - A magnet which adheres to every surface, not only those of ferromagnetic materials, has hitherto been the domain of science fiction. Now for the first time such a novel device exists. The fusion of a permanently magnetized magnetoactive polymer containing hard magnetic particles and an electret enhanced with ferroelectric particles has resulted in the development of a new smart device-the magnetoactive electret. Magnetoactive electrets can be made to exhibit the usual magnetic properties of permanent magnetism together with the electrostatic properties of electrets. This results in simultaneous magnetoadhesion and electroadhesion forces from the same elastomeric element. The biasing field, needed to avoid discontinuities concerned with transition through the zero point in operating curves, is normally provided by means of either a magnetic or an electric field. This novel technology provides both bias options in a single device. KW - 6D printing KW - electret KW - electroadhesion KW - FLUIDS KW - MAGNETIC-FIELD KW - magnetoactive electret KW - magnetoactive polymer KW - magnetoadhesion KW - Magnetorheological elastomers KW - RHEOLOGY Y1 - 2017 U6 - https://doi.org/10.1088/1361-665X/aa738f VL - 26 IS - 7 PB - IOP Publishing ER - TY - JOUR A1 - Prem, Nina A1 - Chavez Vega, Jhohan Harvey A1 - Böhm, Valter A1 - Sindersberger, Dirk A1 - Monkman, Gareth J. A1 - Zimmermann, Klaus T1 - Properties of Polydimethylsiloxane and Magnetoactive Polymers with Electroconductive Particles JF - Macromolecular Chemistry and Physics N2 - Magnetoactive polymers are intelligent materials whose mechanical and electrical characteristics are reversibly influenced by external magnetic stimuli. They consist of a highly elastic polymer matrix in which magnetically soft and/or hard particles are distributed by means of special fabrication processes. In addition to ferromagnetic particles such as carbonyl iron powder, electrically conductive particles may also be embedded into the polymer matrix. After characterizing a range of compounds, this work focuses on a comparison of the electrical properties and the suitability of various materials for applications, with particular emphasis on integration into 3D and 6D printing processes. 6D printing is based on the selective positioning of particles in a 3D polymer matrix with a further three degrees of freedom for a graduated dispersion of the particles at certain points and in desired directions. The aim is therefore to ensure that the polymers containing electroconductive tracks have the best possible electrical properties, that is, low resistivity but are still capable of being printed. A comparison between the traditionally used compounds containing graphite and carbon black is made for the first time. This latter is found to be greatly superior both in terms of electrical conductivity and applicability to 3D printing and 6D printing. KW - 3D printing KW - 6D printing KW - carbon black KW - composites KW - electroconductive particles KW - graphite KW - magnetoactive polymers KW - polydimethylsiloxane KW - STRAIN, *MRU Y1 - 2018 U6 - https://doi.org/10.1002/macp.201800222 VL - 219 IS - 18 PB - Wiley ER -