@article{ReindlMeisnerHierl, author = {Reindl, Thomas and Meisner, Dennis and Hierl, Stefan}, title = {Benchmarking of plastic-based Additive Manufacturing Processes}, series = {RTe Journal}, journal = {RTe Journal}, abstract = {Additive Manufacturing (AM) is a future-oriented manufacturing technology that is experiencing an enormous boom in the times of Industry 4.0. As a result, various AM technologies and printer models from different manufacturers are entering the market over a short time span. With the advancing establishment of this manufacturing technology for series applications, the expectations and requirements of the fabricated components are also increasing. However, a major challenge is the application-specific selection of the most suitable AM process due to a lack of comparable data. Furthermore, there needs to be more know-how regarding the geometrical and mechanical characteristics of AM parts. This paper addresses this problem by comparing the three most common plasticbased AM processes in the areas of surface quality, dimensional accuracy, and mechanical properties. Roughness measurements, evaluation of a benchmark artifact, tensile tests, and load increase tests are carried out. Based on the results, the individual possibilities and limitations of the compared AM processes can be detected.}, language = {en} } @inproceedings{MeisnerForstnerKaftiranisetal., author = {Meisner, Dennis and Forstner, Lukas and Kaftiranis, Nikitas and Hierl, Stefan}, title = {Investigation of process improvements through laser preheating in extrusion-based additive manufacturing process}, series = {Lasers in Manufacturing Conference (LIM 2023), 26. Juni bis 29. Juni 2023, M{\"u}nchen}, booktitle = {Lasers in Manufacturing Conference (LIM 2023), 26. Juni bis 29. Juni 2023, M{\"u}nchen}, publisher = {Wissenschaftliche Gesellschaft Lasertechnik und Photonik e.V. (WLT)}, pages = {10}, abstract = {Fused layer modeling (FLM) is widely used and is gaining more acceptance in the industry mainly due to its material variety and low costs. However, the usage is limited by a process-related anisotropy of the produced parts. The strength and ductility of the printed parts are significantly lower in the build-up direction than perpendicular to it. This is caused by insufficient interlayer bonding resulting from a reduced surface temperature in the process zone. To overcome this problem, a diode laser is integrated into the conventional FLM process to increase the surface temperature between the already printed surface and the newly applied substrate directly at the deposition zone. The investigations carried out show a significant improvement in the mesostructure, as well as a clear reduction in the anisotropy of the printed test specimens.}, language = {en} }