TY - CONF A1 - Meisner, Dennis A1 - Forstner, Lukas A1 - Kaftiranis, Nikitas A1 - Hierl, Stefan T1 - Investigation of process improvements through laser preheating in extrusion-based additive manufacturing process T2 - Lasers in Manufacturing Conference (LIM 2023), 26. Juni bis 29. Juni 2023, München N2 - Fused layer modeling (FLM) is widely used and is gaining more acceptance in the industry mainly due to its material variety and low costs. However, the usage is limited by a process-related anisotropy of the produced parts. The strength and ductility of the printed parts are significantly lower in the build-up direction than perpendicular to it. This is caused by insufficient interlayer bonding resulting from a reduced surface temperature in the process zone. To overcome this problem, a diode laser is integrated into the conventional FLM process to increase the surface temperature between the already printed surface and the newly applied substrate directly at the deposition zone. The investigations carried out show a significant improvement in the mesostructure, as well as a clear reduction in the anisotropy of the printed test specimens. KW - fused layer modeling KW - laser preheating KW - anisotropy KW - interlayer bonding KW - mesostructure Y1 - 2023 UR - https://opus4.kobv.de/opus4-oth-regensburg/frontdoor/index/index/docId/6529 UR - https://www.wlt.de/sites/default/files/2023-09/Contribution_140.pdf PB - Wissenschaftliche Gesellschaft Lasertechnik und Photonik e.V. (WLT) ER -