@article{TheilerEndischLewerenz2021, author = {Theiler, Michael and Endisch, Christian and Lewerenz, Meinert}, title = {Float Current Analysis for Fast Calendar Aging Assessment of 18650 Li(NiCoAl)O2/Graphite Cells}, volume = {7}, pages = {22}, journal = {Batteries}, number = {2}, publisher = {MDPI}, address = {Basel}, issn = {2313-0105}, doi = {https://doi.org/10.3390/batteries7020022}, year = {2021}, abstract = {Float currents are steady-state self-discharge currents after a transient phase—caused by anode overhang, polarization, etc.—is accomplished. The float current is measured in this study with a standard test bench for five 18650 cells (Samsung 25R) at potentiostatic conditions while the temperature is changed in 5 K steps from 5 °C to 60 °C. The entire test is performed in about 100 days resulting in 12 measurement points per cell potential for an Arrhenius representation. The float current follows the Arrhenius law with an activation energy of about 60 kJ/mol. The capacity loss measured at reference condition shows a high correlation to the results of float currents analysis. In contrast to classical calendar aging tests, the performed float current analysis enables determining the aging rate with high precision down to at least 10 °C. Returning from higher temperatures to 30 °C reference temperature shows reducing float currents at 30 °C for increasing temperature steps that may originate from an hysteresis effect that has to be investigated in future publications.}, language = {en} } @article{TheilerBaumannEndisch2024, author = {Theiler, Michael and Baumann, Alexander and Endisch, Christian}, title = {Influence of inhomogeneous state of charge distributions on thermal runaway propagation in lithium-ion batteries}, volume = {2024}, pages = {112483}, journal = {Journal of Energy Storage}, number = {95}, publisher = {Elsevier}, address = {Amsterdam}, doi = {https://doi.org/10.1016/j.est.2024.112483}, year = {2024}, abstract = {It is well known that lithium-ion batteries pose a certain safety risk. The thermal runaway of a cell and the subsequent thermal propagation through the battery are considered particularly dangerous. Effective solutions for their mitigation are therefore of great interest. Previous studies have shown the significant influence of a cell's state of charge (SOC) on its behavior during thermal runaway. This relation may be exploitable in a battery pack to improve its safety. This study aims to assess the leverage of active SOC reduction in the imminent threat of thermal runaway. Implementing such a technique could become feasible with the emergence of reconfigurable battery systems. Four experiments were conducted, each with a module of three fresh 63 Ah high energy pouch cells in a spring-loaded bracing. The experiments studied different stationary SOC configurations, uniform (100\% and 60\%) and non-uniform (100\%-60\%-100\% and 100\%-20\%-100\%). The results indicate that thermal propagation is substantially delay (87 s) by discharging a cell in its path. The SOC reduction primarily decreases the maximum temperature of the respective cell. Further effects are a calmer thermal runaway and prolonged propagation time within the cell as well as to the next cell. In comparison, the SOC reduction has little impact on the cell's own triggering time, as the triggering time is mainly determined by the thermal energy transferred from the preceding cell and hence by its SOC. Furthermore, the analysis of the experimental data (temperature, voltage, pressure, video) gives insights into the propagation of thermal runaway through the individual layers of a cell. With reference to the position of a cell relative to the origin of the thermal propagation, a decrease of its mass loss and an increase of its internal propagation time is observed. This effect is attributed to the decreasing module pressure due to progressive loss of material. The assessment shows that active SOC reduction techniques have great leverage for mitigating or even stopping thermal propagation in a battery pack.}, language = {en} } @article{WilliamsNgaleuTheilerStrasseretal.2022, author = {Williams Ngaleu, Guy and Theiler, Michael and Straßer, Xenia and Hanzl, Christian and Komsiyska, Lidiya and Endisch, Christian and Lewerenz, Meinert}, title = {Influence of switching on the aging of high power lithium-ion cells}, volume = {8}, pages = {33}, journal = {Batteries}, number = {4}, publisher = {MDPI}, address = {Basel}, issn = {2313-0105}, doi = {https://doi.org/10.3390/batteries8040033}, year = {2022}, abstract = {For intelligent battery systems that are able to control the current flow for each individual cell, the multilevel inverter is an interesting approach to replace the bidirectional AC/DC-converter and improve flexibility of charging system and signal quality in both directions. Therefore, the cells are modulated by switching varying the duty cycle, the current and the frequency up to the kHz-range. This is only beneficial if the switching does not lead to a significant additional aging. The scientific gap to assess and understand the impact of switching is investigated in this paper by testing 22 high-power 18650 lithium-ion cells (Samsung 25R). The cells are tested at 50 Hz and 10 kHz switching frequency during charge, discharge and charge/discharge at 50\% duty cycle. The tests are compared to eight reference tests with continuous current flow performed at the average and the maximum current for charge and discharge, respectively. The results are obtained by evaluating the remaining capacity, resistance, electrochemical impedance spectroscopy and dV/dQ analysis. Before reaching rollover, the investigated cells lose homogeneity and cathode capacity but no significant difference for the aging parameters are found. After rollover, the cell-to-cell variation is greater than the aging induced by the different cycling parameters.}, language = {en} } @article{TheilerSchneiderEndisch2023, author = {Theiler, Michael and Schneider, Dominik and Endisch, Christian}, title = {Experimental Investigation of State and Parameter Estimation within Reconfigurable Battery Systems}, volume = {9}, pages = {145}, journal = {Batteries}, number = {3}, publisher = {MDPI}, address = {Basel}, issn = {2313-0105}, doi = {https://doi.org/10.3390/batteries9030145}, year = {2023}, abstract = {The battery system is one of the most-important, but also -critical components in the electric power-train. The battery's system states and parameters are commonly tracked by the battery monitoring system. However, in reality, the accuracy of the state and parameter estimation may suffer from insufficient excitation of the system. Since the current states and parameters serve as the basis for many battery management system functions, this might lead to incorrect operation and severe damage. Reconfigurable battery systems allow enhancing the system's excitation by applying a switching operation. In this contribution, the state and parameter estimation of a reconfigurable battery module were simulated and tested experimentally. Thereby, a low-exciting and a high-exciting drive cycle were compared. Furthermore, the switching patterns were applied to enhance the excitation and, hence, improve the estimation of an extended Kalman filter. The cells were switched via a pulse-width modulation signal, and the influence of frequency and duty cycle variation on the estimation accuracy were investigated. Compared to the low-excitation input, a significant improvement in the estimation of up to 46\% for the state of charge and 78\% for the internal resistance were achieved. Hereby, low frequencies and duty cycles proved to be particularly advantageous. Switching, however, has only a limited influence on an already highly excited system and may lead to additional aging due to higher heat generation.}, language = {en} } @article{TheilerSchneiderEndisch2022, author = {Theiler, Michael and Schneider, Dominik and Endisch, Christian}, title = {Kalman Filter Tuning Using Multi-Objective Genetic Algorithm for State and Parameter Estimation of Lithium-Ion Cells}, volume = {8}, pages = {104}, journal = {Batteries}, number = {9}, publisher = {MDPI}, address = {Basel}, issn = {2313-0105}, doi = {https://doi.org/10.3390/batteries8090104}, year = {2022}, abstract = {To ensure a reliable and safe operation of battery systems in various applications, the system's internal states must be observed with high accuracy. Hereby, the Kalman filter is a frequently used and well-known tool to estimate the states and model parameters of a lithium-ion cell. A strong requirement is the selection of a suitable model and a reasonable initialization, otherwise the algorithm's estimation might be insufficient. Especially the process noise parametrization poses a difficult task, since it is an abstract parameter and often optimized by an arbitrary trial-and-error principle. In this work, a traceable procedure based on the genetic algorithm is introduced to determine the process noise offline considering the estimation error and filter consistency. Hereby, the parameters found are independent of the researcher's experience. Results are validated with a simulative and experimental study, using an NCA/graphite lithium-ion cell. After the transient phase, the estimation error of the state-of-charge is lower than 0.6\% and for internal resistance smaller than 4mΩ while the corresponding estimated covariances fit the error well.}, language = {en} }