Filtern
Erscheinungsjahr
- 2008 (1562) (entfernen)
Dokumenttyp
- Vortrag (659)
- Zeitschriftenartikel (324)
- Posterpräsentation (238)
- Beitrag zu einem Sammelband (168)
- Beitrag zu einem Tagungsband (119)
- Dissertation (12)
- Forschungsbericht (10)
- Sonstiges (9)
- Buchkapitel (7)
- Zeitschriftenheft (Herausgeberschaft für das komplette Heft) (4)
- Monografie (3)
- Sammelband (Herausgeberschaft für den kompletten Band) (3)
- Tagungsband (Herausgeberschaft für den kompletten Band) (2)
- Newsletter (2)
- Jahresbericht (1)
- Handbuch (1)
Sprache
- Deutsch (1088)
- Englisch (462)
- Mehrsprachig (10)
- Französisch (1)
- Russisch (1)
Schlagworte
- Beton (12)
- Non-destructive testing (12)
- Radar (10)
- Fluorescence (9)
- Quality assurance (9)
- Concrete (8)
- Cultural heritage (8)
- NMR (8)
- DLC (7)
- Fluorescence spectroscopy (7)
Eingeladener Vortrag
- nein (659)
Molecular dynamics of ultrathin supported polysulfone films studied by dielectric spectroscopy
(2008)
Charakterisierung typischer Defektstrukturen in modernen Werkstoffen mittels Computertomographie
(2008)
Crack growth tests have been performed at 950 °C with Single Edge Notch specimens of the Ni-based single crystal superalloy PWA1483. In particular, several orientations and frequencies have been investigated, thus allowing the assessment of the influence of these parameters on the crack growth rate. In addition, oxidation experiments have been carried out to characterize the kinetics of the outer oxide scale growth at the same temperature.
On the other side, crack growth has been simulated with the Finite Element program ABAQUS in real test conditions by the node release technique. The nodes are released according to the measured crack growth rate.
The simulation results are compared with the test results on the basis of the computed Crack Tip Opening Displacement (CTOD). For this purpose, the crack is propagated until a stabilized value of the CTOD is obtained. This is usually the case when the crack has crossed the initial plastic zone. The procedure provides an evaluation of the effects of cycle frequency, crystal orientation, plasticity and oxide induced crack closure.
After having checked in a previous study the influence of stroke and normal load in laboratory fretting tests accomplished with thin steel roping wires, in this paper the effect of the contact pressure (test configuration), environmental conditions (relative humidity) and reduction of the friction coefficient (lubricants) on the wear behaviour were analysed. The wires were 0.45 mm in diameter and the material was a cold-drawn eutectoid carbon steel (0.8% C) with a Tensile Strength over 2800 MPa. The tests were performed on an oscillating test rig and the volumetric wear of both specimens of the tribocouple was determined separately from three-dimensional topographies of the wear scars acquired by means of a confocal profiler, and a calculation algorithm developed in using MATLAB®. The strong effect of humidity and lubrication on wear behaviour was proved, whereas a slight effect of contact pressure was derived.