Ingenieurwissenschaften und zugeordnete Tätigkeiten
Filtern
Erscheinungsjahr
- 2017 (19) (entfernen)
Dokumenttyp
- Zeitschriftenartikel (11)
- Vortrag (8)
Sprache
- Englisch (19)
Schlagworte
Eingeladener Vortrag
- nein (8)
A combination of nanosized dielectric relaxation (BDS) and thermal spectroscopy (SHS) was utilized to characterize the dynamics of thin films of Poly(vinyl methyl ether) (PVME) (thicknesses: 7 nm – 160 nm). For the BDS measurements, a recently designed nano-structured electrode system is employed. A thin film is spin-coated on an ultra-flat highly conductive silicon wafer serving as the bottom electrode. As top electrode, a highly conductive wafer with non-conducting nanostructured SiO2 nano-spacers with heights of 35 nm or 70 nm is assembled on the bottom electrode. This procedure results in thin supported films with a free polymer/air interface. The BDS measurements show two relaxation processes, which are analyzed unambiguously for thicknesses smaller than 50 nm. The relaxation rates of both processes have different temperature dependencies. One process coincidences in its position and temperature dependence with the glassy dynamics of bulk PVME and is ascribed to the dynamic glass transition of a bulk-like layer in the middle of the film. The relaxation rates were found to be thickness independent as confirmed by SHS. Unexpectedly, the relaxation rates of the second process obey an Arrhenius-like temperature dependence. This process was not observed by SHS and was related to the constrained fluctuations in a layer, which is irreversibly adsorbed at the substrate with a heterogeneous structure. Its molecular fluctuations undergo a confinement effect resulting in the localization of the segmental dynamics. To our knowledge, this is the first report on the molecular dynamics of an adsorbed layer in thin films.
Unraveling the Dynamics of Nanoscopically Confined PVME in Thin Films of a Miscible PVME/PS Blend
(2017)
Broadband dielectric spectroscopy (BDS) was employed to investigate the glassy dynamics of thin films (7−200 nm) of a poly(vinyl methyl ether) (PVME)/polystyrene (PS) blend (50:50 wt %). For BDS measurements, nanostructured capacitors (NSCs) were employed, where films are allowed a free surface. This method was applied for film thicknesses up to 36 nm. For thicker films, samples were prepared between crossed electrode capacitors (CECs). The relaxation spectra of the films showed multiple processes. The first process was assigned to the α-relaxation of a bulklike layer. For films measured by NSCs, the rates of α-relaxation were higher compared to those of the bulk blend. This behavior was related to the PVME-rich free surface layer at the polymer/air interface. The second process was observed for all films measured by CECs (process X) and the 36 nm film measured by NSCs (process X2). This process was assigned to fluctuations of constraint PVME segments by PS. Its activation energy was found to be thickness-dependent because of the evidenced thickness dependency of the compositional heterogeneity. Finally, a third process with an activated temperature dependence was observed for all films measured by NSCs (process X1). It resembled the molecular fluctuations in an adsorbed layer found for thin films of pure PVME, and thus, it is assigned accordingly. This process undergoes an extra confinement because of frozen adsorbed PS segments at the polymer/substrate interface. To our knowledge, this is the first example where confinement-induced changes were observed by BDS for blend thin films
Specific heat spectroscopy (SHS) employing AC nanochip calorimetry was used to investigate the glassy dynamics of ultra-thin films (thicknesses: 10 nm–340 nm) of a polymer blend, which is miscible in the bulk. In detail, a Poly(vinyl methyl ether) (PVME)/Polystyrene (PS) blend with the composition of 25/75 wt. % was studied. The film thickness was controlled by ellipsometry while the film topography was checked by atomic force microscopy. The results are discussed in the framework of the balance between an adsorbed and a free surface layer on the glassy dynamics. By a self-assembling process, a layer with a reduced mobility is irreversibly adsorbed at the polymer/substrate interface. This layer is discussed employing two different scenarios. In the first approach, it is assumed that a PS-rich layer is adsorbed at the substrate. Whereas in the second approach, a PVME-rich layer is suggested to be formed at the SiO2 substrate. Further, due to the lower surface tension of PVME, with respect to air, a nanometer thick PVME-rich surface layer, with higher molecular mobility, is formed at the polymer/air interface. By measuring the glassy dynamics of the thin films of PVME/PS in dependence on the film thickness, it was shown that down to 30 nm thicknesses, the dynamic Tg of the whole film was strongly influenced by the adsorbed layer yielding a systematic increase in the dynamic Tg with decreasing the film thickness. However, at a thickness of ca. 30 nm, the influence of the mobile surface layer becomes more pronounced. This results in a systematic decrease in Tg with the further decrease of the film thickness, below 30 nm. These results were discussed with respect to thin films of PVME/PS blend with a composition of 50/50 wt.%as well as literature results.
Nanocomposites based on poly(L-lactide) (PLA) and organically modified Ni/Al layered double hydroxides (NiAl/LDHs) are prepared by melt blending and investigated by a combination of size exclusion chromatography, differential scanning calorimetry (DSC), small-angle X-ray scattering (SAXS), wide-angle X-ray scattering, and broadband dielectric spectroscopy. A detailed comparison to the behavior of the corresponding MgAl/LDH–PLA nanocomposites is made. SAXS investigations show that the morphology of the NiAl/LDH–PLA nanocomposites is more intercalated compared to the MgAl/LDH based PLA nanocomposite, which is more exfoliated. The DSC investigation gives a different dependence of the degree of crystallization on the concentration of LDH for NiAl/LDH–PLA than for MgAl/LDH–PLA nanocomposite system. These differences are discussed taking the differences of the morphologies of both systems into account. Broadband dielectric spectroscopy reveals information about the molecular dynamics where essential differences are observed for all relaxation processes taking place in both systems which were related to the different morphologies.
Polymer-based nanocomposites attracted recently a lot of attention from both the applicative and fundamental point of research. While the former point of view is due to the properties improvement compared to the corresponding matrix polymers the latter aspect is related to interaction of polymers with solid surfaces and confinement effects.
Here, nanocomposites based on poly(L-lactide) (PLA), which is a semi-crystalline polymer, and organically modified Layered Double Hydroxides (LDH) were prepared by melt blending, and investigated by a combination of Differential Scanning Calorimetry (DSC), Small- and Wide-Angle X-ray Scattering (SAXS, WAXS), and dielectric spectroscopy (BDS). Two different LDH materials were considered, which results in different morphologies of the nanocomposites. The influence of these different morphologies on the properties of the nanocomposites especially on the molecular mobility is discussed in detail.
In general the structure of semi-crystalline polymers has to be described by a three phase model, consisting of a mobile amorphous (MAF), a crystalline (CF), and a rigid amorphous fraction (RAF). For nanocomposites based on semi-crystalline polymers the RAF is due to both the crystallites (RAFcrystal) and the filler (RAFfiller). The considered nanocomposites were further investigated by hyper and temperature modulated differential scanning calorimetry. For the first time the different phase fractions CF, MAF, RAFcrystal, and RAFfiller could be estimated independently from each other.
Although the concept of structural water that is bound inside hydrophobic pockets and helps to stabilize protein structures is well established, water has rarely found a similar role in supramolecular polymers. Water is often used as a solvent for supramolecular polymerization, however without taking the role of a comonomer for the supramolecular polymer structure. We report a low–molecular weight monomer whose supramolecular polymerization is triggered by the incorporation of water. The presence of water molecules as comonomers is essential to the polymerization process. The supramolecular polymeric material exhibits strong adhesion to surfaces, such as glass and paper. It can be used as a water-activated glue, which can be released at higher temperatures and reused many times without losing its performance.
Different types of polymerbased nanocomposites (matrix materials: polyethylene, polypropylene, polylactide, polycarbonate, polystyrene) with a broad variety of nanofillers (fillers: layered silica, layered doubled hydroxides, POSS) are prepared where the concentration of the particles is varied. For layered fillers TEM images show both an intercalated and exfoliated morphology in dependence on the nanofiller and the matrix. All systems are studied in detail by dielectric spectroscopy (BDS) but also complementary methods like WAXS, SAXS, gas transport measurements, calorimetry, and FTIR spectroscopy are employed. Besides the dispersion, the interfacial region between the nanoparticles and the polymer matrix is crucial for the properties of the nanocomposites. Therefore, attention is paid to investigate this interfacial area by BDS because the polar groups of both the surfactant and compatibilizer are located close to the layers. For some systems it is found that the molecular mobility in the interfacial area is essentially higher than in the matrix. In addition a Maxwell/Wagner/Sillars polarization is found due to the blocking of charges at the layers. The time constant of this MWS-process can be correlated with characteristic length scales in the nanocomposites and provides information about the dispersion of the nanofiller.
Polymeric membranes represent a cost- and energy efficient solution for gas separation. Recently superglassy polymers with high free volume outperform many conventional dense polymers in terms of gas permeability and selectivity. However, such polymers are prone to pronounced physical aging, resulting in a dramatic reduction in the gas permeability. Molecular mobility of polymer segments plays an important role in the physical aging and the gas transport performance of polymeric membranes. Molecular mobility and physical aging of a representative superglassy polynorbornene with very high gas permeability, PTCNSi2g, was monitored by using dielectric spectroscopy with state-of-the-art high-resolution analyzers. This work helps to shed some light on the structure−property relationship of superglassy polymers on a molecular level and to provide practical “design rules” for the development of high performance polymers for gas separation.
Polymers with intrinsic microporosity (PIMs) are of great interest in the field of gas separation membranes. Already the first synthesized PIM-1 shows extraordinary permeability and selectivity. Unfortunately, PIM-1 is susceptible to physical aging and thus gradually loses its outstanding properties. In this study a polyhedral oligomeric silsesquioxane with phenethyl substituents (PhenethylPOSS) was used as a nanofiller (0–40 wt%) in the PIM-1 matrix to potentially improve the gas transport properties and prevent physical aging. The molecular mobility of the solution-cast nanocomposite films was analyzed by Broadband Dielectric Spectroscopy (BDS). Furthermore, gas permeability was determined with the time lag method (0–20 bar upstream pressure) at 35 °C for N2, O2, CH4 and CO2.
Discotic liquid crystals (DLCs) are self-assembled materials where self-assembly is driven by non-covalent intermolecular interactions. The corresponding molecules consist of a flat and rigid aromatic core substituted by flexible aliphatic side chains. While the former is responsible for the π-stacking, the latter gives rise to an increased solubility, processability, and rich thermotropic behavior. The disc-shaped molecules form columns that further assemble into two-dimensional arrays with a hexagonal mesophase. The alkyl chains fill the intracolumnar space giving rise to a nanophase separated state. These soft matter materials with highly ordered columnar structures have a great potential in molecular electronic devices such as active semiconductors in organic field-effect transistors and photovoltaic devices with a charge carrier mobility of up to 1.1 cm2/Vs. Two different homologous systems based on triphenylene derivatives were investigated as model systems for DLCs where the length of the aliphatic side chains is widely varied. Structural information is retrieved by X-ray diffraction carried out on a synchrotron. Experiments were carried out in the bulk state and confined to the nanometer wide channels of anodic aluminum membranes (Pore diameter 20 nm, 40nm, 80 nm and 180 nm). The latter case can be considered as a promising way to prepare nanowires. As method broadband dielectric spectroscopy (frequency range 10-2 Hz to 109 Hz) is employed. These experiments were accompanied by thermal investigations (Differential Scanning Calorimetry as well as Thermogravimetric Analysis) as well as inelastic neutron scattering (neutron Time-of-Flight and neutron Backscattering). The dynamics of these unique soft matter materials are discussed in detail considering their structure (length of the aliphatic side chain), the effect of self-confinement (of the aliphatic chains in the intracolumnar space) and of the outer confinement (influence of the pore size). Comparison is further made to a pyrene based system.