Ingenieurwissenschaften und zugeordnete Tätigkeiten
Filtern
Dokumenttyp
- Zeitschriftenartikel (3)
- Vortrag (3)
- Posterpräsentation (1)
Sprache
- Englisch (7) (entfernen)
Schlagworte
- Lubricants (7) (entfernen)
Organisationseinheit der BAM
Eingeladener Vortrag
- nein (3)
The motivation and the measurement setup for large fast-scanning piezoresistive cantilevers are presented. The theory behind the measurements of mechanical properties through contact resonance is explained. Results of such measurements on two kinds of polymer are compared to results from force distance curves. Noise, time-dependency and dependency of the results on the vibration mode are identified as challenges of contact resonance.
At the Stakeholder meeting of the EMPIR project “Multifunctional ultrafast microprobes for on-the-machine measurements”, details about two measurement modes were presented. Force distance curves and contact resonance measurements are compared. The basic principles are explained and exemplary measurements concerning mechanical properties of polymers are shown.
The magnetic plasma confinement system of the nuclear fusion experiment “Wendelstein 7-X”, which recently produced the first plasma, consists of 20 planar and 50 non-planar superconducting coils. To keep them precisely in position, these coils contact each other at special support elements. The supports are operated in high vacuum at a temperature of about 4 K, and when the magnetic field is ramped up, forces up to 1500 kN and sliding motion of some mm occurs. Because mechanical disturbances may cause severe failures, only low friction without any stick-slip behaviour is tolerable. In pre-tests a PVD-MoS2-coating had proven to be the optimum solution. It was tested with downsized samples in reciprocating motion in liquid nitrogen (T = 77 K) and liquid helium (T = 4,2 K). In long-term tests in liquid nitrogen this coating showed stable sliding for up to 14.900 friction cycles without coating failure. However, in liquid helium an unexpected stick-slip effect occurred, whose origin could not be clarified so far.
Pristine, reduced, and alkylated graphene oxides are applied as lubricating additives in paraffin grease. It has revealed that their crystalline structure governs the tribological properties of grease for steel tribo-pair. The microstructural analyses of grease samples showed that a loose fiber network of soap in the presence of graphene-based additive allows their facile release for efficient lubrication. The surface analyses based on the microscopic and elemental mapping show the development of a graphene-derived protective film on the worn scars, which protected the tribo-surfaces and subsided the wear. The reduced graphene oxide (rGO) with the interlamellar distance of 0.35 nm in the (002) plane provided minimum resistance to shear and exhibited maximum reduction in coefficient of friction (COF) for the paraffin grease. The presence of oxygen functionalities in the basal of pristine and alkylated graphene oxide (GO) compromised the interlamellar shearing under tribo-stress; consequently, higher COF than that of rGO.