Präsentation
Filtern
Erscheinungsjahr
- 2017 (3) (entfernen)
Dokumenttyp
- Vortrag (2)
- Posterpräsentation (1)
Referierte Publikation
- nein (3)
Schlagworte
- Modellierung (3) (entfernen)
Eingeladener Vortrag
- nein (2)
For how trivial or provocative it can sound, the best neutron spectrometer in the world does not produce science by itself. By definition of Materials Science, neutron scattering data on engineering materials must be used as a tool to understand, and even tailor, materials performance. In order for this to happen, it is clear that neutron data need to be acquired under the most relevant condition possible, coupled to other experimental techniques, and capitalized by means of proper simulations and data analysis.
In fact, access to neutron sources is not routine. Consequently, it is imperative to search ways to make neutron data rentable for the material science and industrial research community.
In this presentation, and based on the example of Ceramic Diesel Particulate Filters and Aluminum Matrix Composites, we will show a couple of strategies to combine neutron data with other experiments, and with theoretical models. Their combination allows raising the value of experiments from data production to problem-solving. Obviously, these are only a few among the many combinations possible to help improving materials properties, performance, and safety.
We investigated, the damped Received Signal Strength Indicator (RSSI) of a Bluetooth Low Energy (BLE) signal, transmitted from the BLE-module embedded in building materials with changing moisture content, Fig. 1. The BLE-module communicates with a mobile Smart Device as tablet via 2.45 GHz-ISM-frequency band where water dipoles start to oscillate, Fig. 2. The damping model demonstrates this damping effect on RSSI by the abstraction of the reality observed in a real system. Through the reproduction of the active relationships, the system behavior is decomposed in such a way that a separate consideration of the required system parameters is possible.
Beim Ansprechen von Sicherheitseinrichtungen werden unter Druck stehende Gase als Freistrahl freigesetzt. Die Abmessung des daraus resultierenden Gefährdungsbereiches ergibt sich durch den Vergleich mit einem Grenzwert, wie z. B. der unteren Zündgrenze.
Die Berechnung des Freistrahles wird im Allgemeinen durch empirische oder Integralmodelle durchgeführt. Hierbei wird jedoch angenommen, dass die Freisetzungsdauer ausreichend lang ist, damit der Freistrahl einen stationären Zustand erreicht. Ist die Freisetzungsdauer durch ein kurzes Ansprechen der Druckentlastungseinrichtung oder einer geringen zur Verfügung stehenden Gasmenge nur kurz, stellt sich die Frage, inwiefern der resultierende Freistrahl die durch die stationäre Annahme in den Modellen berechneten Längen überhaupt noch erreicht, bzw. ab welcher Freisetzungsdauer von einem stationären Strahl ausgegangen werden kann.
Um diese Fragestellung zu untersuchen wurden CFD Berechnungen durchgeführt. Variiert wurden hierbei die Gasdichte (unterschiedliche Stoffe), die Austrittsgeschwindigkeit, der Austrittsdurchmesser und die Freisetzungsdauer. Basierend auf diesen Untersuchungen wird diskutiert, ob eine Korrelation zwischen den Austrittsparametern und der Dauer bis zum Erreichen der Stationarität abgeleitet werden kann. Diese Korrelation ermöglicht dann aus den Ergebnissen der stationären Freistrahlmodelle, Aussagen für sehr kurze Freisetzungszeiträume zu treffen.