Präsentation
Filtern
Erscheinungsjahr
- 2017 (8) (entfernen)
Dokumenttyp
- Vortrag (4)
- Posterpräsentation (4)
Sprache
- Englisch (8)
Referierte Publikation
- nein (8)
Schlagworte
- LA-ICP-MS (8) (entfernen)
Eingeladener Vortrag
- nein (4)
LA-ICP-MS finds widespread use in the analysis of biological samples and its importance as an analysitical method is still increasing. Often tissues or single cells are ablated in imaging mode on glass slides, but the analysis time increases by reducing the spot size of the laser. Additionally, with increased lateral resolution a loss in sensitivity is inherently connected and this holds true in particular for single cell analysis in imaging mode. However, if only the composition of elements in a single cell needs to be measured, complete ablation of cells by single shots looks promising. This approach was already discussed by Managh et al. and will be discussed in more detail in this presentation. The aim of this study is to develop a calibration strategy for single cell analysis based on the total consumption concept. It will be shown that this concept provides quantitative results at single cell level, if the target material is ablated. We compare two different laser spot sizes, 30 µm and 110 µm. The smaller spot size of 30 µm is used for imaging and the larger spot size of 110 µm is used for the targeted ablation of complete single cells. Cells were stained by two novel cell dyes, mDOTA-Tb (CheMatech, Dijon, France), which binds to free thiol groups of proteins, and Ir-DNA intercalator (Maxpar®, Fluidigm, San Francisco, USA), which stains DNA quantitatively. Finally, quantification of Ir and Tb will be performed by matrix matching calibration, following the approach of Drescher et al.[1], i.e. spotting of a dilution series of Ir and Tb standards on nitrocellulose membrane. Results obtained so far show a good correlation between imaging and single spot ablation, indicating that the total consumption concept may serve as an acceptable assumption.
Homogeneity of dispersed brominated flame retardants (HBCD) in polystyrene by LA-ICP-MS and XRF
(2017)
Polybrominated Flame retardants (PBFR) are of concern as emerging pollutants resulting from plastic waste, which set them free because these additives are not chemically bonded to the polymer. For this reason we fortunately use the laser ablation inductive coupled mass spectrometry (LA-ICP-MS) to verify the amount of 1,2,5,6,9,10-Hexabromocyclododecane (HBCD) in polystyrene (PS) resp polybrominated diphenylether (BDE-209) in polypropylene (PP). Results from X-ray fluorescence spectroscopy (RFA) are compared with those from LA-ICP-MS for studying the homogeneity of PBFR such as BDE-209 (0.1% wt. in PP) or HBCD (1% wt. in PS). RFA is well suited for the reason that it is a rapid, non-destructive and sensitive method. We also use the LA-ICP-MS as reference method for quantification of the content of PBFR herein and by measurement of ABS (acrylonitrile–butadiene–styrene, ABS) and correlate these data with RFA measurements. The necessity for the proof of homogeneity of BFR additives resulting from the use of these samples for weathering studies we perform to discover unknown transformation process and to get a certified reference method.
For studying the homogeneity partition of BFR in PS or PP, we need to estimate the relation V/N (V=ablated volume, N=molar amount) for any studied area, which is in case of a homogenous partition for every area identical. To measure the ablated volume we applied the white light interference microscopy from which we derived the theoretical amount of ablated flame retardant. In correlation to an ablated CRM we get the molar amount of ablated BFR. From the counts (RFA) resp. the ratio of peak area of the bromine isotope we derive the concentration of BFR in ablated PS resp. PP. Another approach uses the applied external standard addition using RFA scanning. A cylindrical probe of defined geometry, corresponding to a defined amount of BFR, was removed from PS. Into this hole was added a solution of BFR of defined concentration and letting dried. RFA scanning of background and the hole gives a direct confirmation of the included amount of BFR herein. According to ISO 13528 samples for proficiency tests were acknowledged as homogenous if the criteria for homogeneity ss<0.3sigma were fulfilled.
Laser ablation with inductively coupled plasma is still more used in life science as biology and biomedicine and the utilization of metals and proteins determination simultaneously is also growing up. We have developed a new strategy of labeling of antibody (it can specific binds to proteins) by nanoparticles and quantum dots which is composed of thousands of atoms and thus increases the sensitivity enormously and of course decreases the Limit of detection, compare to lanthanoids labeling. The ability of successfully tagged antibodies bound to Antigen (protein) was proved by dot blot on membrane imaged by LA-ICP-MS.
Homogeneity of dispersed brominated flame retardants (HBCD) in polystyrene by LA-ICP-MS and XRF
(2017)
To investigate the release or migration of flame retardants from polypropylene (PP) and polysytrene (PS) samples with a defined content of flame retardants as additives were prepared and used. Therefore a distinct 1,2,5,6,9,10-hexabromocyclododecane HBCD concentration of 1 wt.% in PS resp. a specified bromodiphenylether (BDE-209) of 0.1 wt.% in PP is defined. For the preparation of the samples granular PP or PS are extruded together with the BFR additives. Even the result of this process may lead to homogenous partitions of the BFR additives. So, the distribution of these additives must be proven before using the samples in an experimental setup for weathering studies. In accordance to the regulation of RoHS (2011/65/EU) , where the use of XRF is recommended for the proof of flame retardants in electronic consumer products, we use this method as a reference to the laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS). Therefore we present the correlation of these experiments. The experimental setup for the XRF experiment is like a standard addition: in cavities, which are introduced in the sample plates subsequently, solutions of defined concentration of flame retardants are put in there. According to the idea of standard addition, we get an information of the originating mass fraction of flame retardant in each sample and we can monitor the release and migration of these additives during/after the weathering experiments with high precision. An internal standard of HBCD is added as a marker and can be analyzed after the weathering experiment.
Oxidative stress is produced by an imbalance between free radical production and biological system's ability to detoxify the reactive intermediates and repair the resulting damage. In the human eye the main causes of oxidative stress are the daily exposure to sunlight, chemical insults and the special microenvironment with abundant photo-sensitizers. For this reason, oxidative stress has been associated several ocular diseases, like aged-related macular degeneration (AMD). On the other hand, Metallothioneins (MTs) are a family of low molecular weight (6–7 kDa), cysteine-rich (30%) and metal-binding proteins. The cysteine residues can bind metal atoms such as zinc, copper, and cadmium via thiolate bonds. These proteins have a wide range of functions including defense against oxidative damage, intracellular storage and transport and metabolism of metal ions. The antioxidant properties of MTs reside in their capacity to capture and neutralize free radicals by binding and transferring zinc ions in a redox-dependent fashion, forming the antioxidant system Zinc-Metalothionein (Zn-MT).
Highly sensitive analytical tools are required to study the relationship between Zn and MTs in sections from ocular tissues. These methodologies should permit the simultaneous localization (bioimaging) of metals and proteins. Laser ablation (LA) coupled to ICP-MS has shown a huge potential for bioimaging studies in biological tissues. In addition, the use of metal nanoclusters (NCs) as elemental tags will provide signal amplification, compared with other tags traditionally employed (e.g. polymeric tags). To this end, antibodies with gold nanoclusters (AuNCs) will be used in combination with LA-ICP-MS for the detection of different metallothioneins (MT 1/2 and 3) directly into the ocular tissue sections.
- Methods:
The AuNCs synthesized were bioconjugated with an Anti-MT 1/2 antibody and with Anti-MT 3 antibody. Next, using ocular tissue sections (5 microns thick) from different donors the immunoassays were performed. After the immunoassay protocol, imaging studies were carried out by LA-ICP-MS as well as by fluorescence (confocal microscope) in order to compare both methodologies.
- Results:
The MTs (measuring the Au signal) and the coordinated metals distribution (Zn and Cu) were successfully carried out in human ocular tissues, including sclera, choroid, retina and retinal pigment epithelium regions. The image patterns found in ocular tissues were in agreement with those reported by conventional immunohistochemistry.
- Conclusions:
It is possible to know the distribution of MT proteins and different coordinated metals using bioconjugated AuNCs and LA-ICP-MS. Proposed analytical tools could help to better understand the roles of the antioxidant system Zinc-Metalothionein in the eye.
The interaction of nanoparticles (NPs) with cells has become a major field of interest, ranging from therapeutic applications to nanotoxicology. The cellular uptake depends on the primary characteristics of the NPs (e.g. size, shape, surface modification) and on the cells interacting with the particles. Thereby the quantification of NPs in cells is of particular importance to obtain information under different experimental conditions. Presently, the number of NPs internalized is often determined by inductively coupled plasma (ICP) optical emission spectrometry (OES) or ICP mass spectrometry (MS) after acid digestion of a cell suspension or a cell pellet. The result is an average value and no information about the distribution among cells or within a cell is available. Therefore we developed a method based on laser ablation (LA) in combination with ICP-MS to localise and quantify metallic NPs in single cells.
LA-ICP-MS is a powerful analytical method which offers excellent sensitivity at high spatial resolution and multielement capability without time-consuming sample preparation steps. Recently, LA-ICP-MS was established for elemental mapping of biological samples like tissues.
In our experiments, fibroblast cells were incubated with gold or silver containing nanoparticles and grown on sterile coverslips under standard conditions. For LA analysis the cells were fixed with formaldehyde and dried. Subcellular resolution is achived by careful optimisation of laser energy, ablation frequency and scan speed. The elemental distribution was determined by continuous ablation line by line of cells incubated with NPs. Our results show that LA-ICP-MS is able to detect NP aggregates within cellular substructures. After 24 h of incubation the NPs were found in the cytosol, preferencially in the perinuclear region, but do not enter the nucleus. Additionally, a quantification strategy at single-cell level was developed. For this purpose nitrocellulose membrane was spiked with Ag or Au nanoparticle suspension at different concentration levels and analysed by LA-ICP-MS. Based on this calibration the number of NPs taken up by individual cells was determined and variations within the cell population become visible. The cells show a strong dependence of NP uptake on concentration and incubation time.
Our results demonstrate the potential of LA-ICP-MS providing insight into NP uptake and intracellular distribution dependent on experimental parameters.
Elemental imaging of biological samples using laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) provides spatially resolved information on element distribution in thin sections. By rastering with a laser across the sample, a two-dimensional image of the elemental distribution can be reconstructed that shows the intensities of the respective elements. Using overlapping laser shots the area ablated from single cells or thin sections (thickness 5 to 10 µm) can be reduced significantly so that the pixel size of the intensity measurement is significantly reduced. Having in mind that a laser shot ablates thin biological samples completely, we can make use of a new concept for calibration in the laser ablation method: the concept of total consumption. This calibration strategy allows production of simple matrix matched standards and provides an internal standardisation by ink jet technology, where a metal containing inks is printed on as thin layer on top of a biological sample.
Different applications will be presented where our concepts have been applied. In the first example we used nanoparticle suspension of given particle numbers to quantify the uptake of metallic nanoparticles by biological cells. In the second example antibodies have been tagged by metals to measure protein expression in prostata cancer. In this approach application of house keeping proteins are investigated additionally to compensate variations in thickness and density of the biopsy samples. In the third application different nephrotoxic behaviour of Pt containing drugs have been investigated to study the local enrichement in kidney samples of mice treated with these three different compounds. Here the internal standard is required to allow intercomparisons between different individual mouse tissues.
At the end of the lecture future trends will be discussed for elemental microscopy.
We are using laser ablation (LA)-ICP-MS to image the local distribution of elements (metals and hetero-elements) directly or (metallo-)proteins by metal-tagged antibodies in cells and tissue indirectly. Different applications will be discussed to demonstrate the state of the art and to visualize the elemental distribution pattern in soft bio-materials (tissue, single cells). In the first application Pt-containing drugs for cancer treatment are investigated and elemental distribution pattern are shown for tissue samples from animal experiments. Different standardization and quantification schemes including isotope dilution analysis will be discussed. In the second application, which is dedicated to toxicological research, the up-take of nano-particles by single cells are discussed and metal containing stains are used to visualize the distribution of nano-particles, proteins and DNA in a single cell simultaneously. This information is correlated with the distribution of the nanoparticles to identify the cell compartments where nano-particles are enriched. Quantification schemes have been developed to transform the measured intensities into number of particles up taken by the cells. In the third and last application LA-ICP-MS is applied to visualize the local distribution of proteins, which are used as bio-markers for prostate cancer. For this purpose, biopsy samples from patients have been simultaneously stained by eight differently metal-tagged antibodies in a multiplex approach. Detection of house-keeping proteins serves as internal standards to overcome differences in protein expression. Additionally ink-jet printing of metal doped inks onto the surface of these tissue samples has been applied for internal standardization and drift corrections.
Finally future trends to develop an “elemental microscope” will be discussed.