Präsentation
Filtern
Erscheinungsjahr
- 2016 (2) (entfernen)
Dokumenttyp
- Vortrag (2)
Sprache
- Englisch (2)
Referierte Publikation
- nein (2)
Schlagworte
- Wood (2) (entfernen)
Eingeladener Vortrag
- nein (2)
Packages for the transport of radioactive material are often equipped with impact limiters consisting of wood, encapsulated by steel sheets. These impact limiters shall ensure the transport cask meets the mechanical and thermal IAEA regulatory test requirements. After damage caused by the mechanical tests the package has to withstand a severe fire scenario. According to the regulations during and following the thermal test, the specimen shall not be artificially cooled and any combustion of materials of the package shall be permitted to proceed naturally.
Corresponding to results of the French institute IRSN combustion and smouldering of wood inside the impact limiter occurred during and after the fire test. An additional energy supply from a pre-damaged impact limiter to the cask could be the consequence for the safety assessment of the containment.
BAM started a first test phase to examine the issue of combustion for such kind of package components. The goal was to understand the phenomena under the consideration of relevant regulatory boundary conditions. Several metal buckets were filled with wood and equipped with thermocouples. The test specimens have been prepared with different damage arrangements to take the influence of the mechanical tests into account. This paper shows the experimental setup and the conduction of the tests. The first test shows that pre-damaged metal encapsulations can lead to smouldering of the wood and with this to a supplement energy release after the end of the 30 minute fire. BAM is in the preparation process for a second test phase. A thermal test will take place with a wood filled test specimen weighing about 2Mg.
Many wooden artworks are contaminated by DDT (dichlorodiphenyltrichloroethane) as a result of a surface treatment by means of Hylotox-59©. The liquid preservative was used until the end of the 80s. DDT crystal structures are formed on the wood surfaces by the "blooming" of chlorine compounds. Contaminated waste wood with natural biocide ageing, gilded and wood carved elements of an old picture frame and wooden samples with paint layers were provided by the Schlossmuseum Sondershausen.
The removal of DDT was evaluated employing femtosecond and nanosecond laser radiation and cold atmospheric plasma technique using different working gases (air, nitrogen, and argon).
Before laser application, a chlorine measurement is done by X-ray fluorescence (XRF) analysis as reference. After laser processing, the XRF analysis is used again at the same surface position to determine depletion rates. Additionally, a documentation and characterization of the sample surface is done before and after laser and plasma treatment using optical microscopy. For plasma processing with various systems a chlorine measurement is done by gas chromatographic-mass spectrometry (GCMS) analysis.
For laser treatment a depletion of the chlorine concentration of 55-70% and 75% was achieved for 1064-nm nanosecond pulses and 800-nm femtosecond pulses, respectively. For the application of 30-fs laser pulses, no crystalline DDT residues remain on the sample surfaces. This holds also for the plasma processing with nitrogen as working gas.