Filtern
Erscheinungsjahr
Dokumenttyp
- Vortrag (110) (entfernen)
Referierte Publikation
- nein (110)
Schlagworte
- Friction (10)
- Niobium carbide (8)
- Wear (8)
- NbC (6)
- Cutting tools (5)
- Machining (5)
- SRV (4)
- China (3)
- Hardness (3)
- Hot steam (3)
Organisationseinheit der BAM
Eingeladener Vortrag
- nein (110)
Niobium is today largely available. The initial NbC grade was substoichiometric, SPS sintered and cobalt bonded. The NiMo-bonded stoichiometric NbC1.0 grades enable the substitution of cobalt by nickel, SPS by conventional sintering and NbC0.88 by NbC1.0 in view of functional properties. Nickel bonded NbC grades have improved toughnesses versus cobalt NbC grades, but lose hardness. NiMo and NiMo2C bonded NbC1.0 grades compensated the loss in hardness while keeping the toughness.
The frictional response of molybdenum bis(C11-14 branched and linear alkyl) carbamodithioate oxo thioxo complex (Mo-dttc) versus bismuth dimethyldithiocarbamate (Bi-dtc) and bismuth dodecylbenzene Sulfonate (Bi-ddbsa) slip-rolling under mixed/boundary lubrication (T=120°C, n=10 millions of cycles, P0max=2.25 GPa) in PAO-based formulation against three different steel alloys were compared.
The tribotesting categories have different scopes with associated "pros" and "cons" and results obtained in one category cannot be simply transferred to another. The impact of design overrules in general the influence of the metallurgy or materials choice. The "cheap" test methods aim pre-screening and assessment of basic properties as well as use mainly for the test specimens SAE E52100 (100Cr6, SUJ2) ball bearing steel and carbon steels. The main test geometries are ball-on-flat/(disk) or block-on-ring apart 4-ball geometry. The tribological test conditions. This enabled "dynamic" testing, where during a test the "critical" solicitations were repeatedly and freely passed.
The slip-rolling 2Disk tribometer from Optimol Instruments represented the technological evolution in tribotesting of the well-known AMSLER-type tribometer marketed in 1922. Both use two discs with the same outer diameter rolling against each other on their circumference. In the AMSLER, the lower disc dips into an oil reservoir, whereas in the 2Disk the oil is injected into the contact. The oil supply of the 2Disk is controlled by pump and temperature by a heat exchanger.
The present work deals with Niobcarbid (NbC). Strategic reflections on tungsten carbide and more and more stringent toxicological restrictions for cobalt associated for both with spiraling stock market prices have attracted recently some attention for Niobium carbide as a substitute for tungsten carbide in machining.