Filtern
Erscheinungsjahr
- 2010 (9) (entfernen)
Dokumenttyp
- Vortrag (4)
- Zeitschriftenartikel (2)
- Beitrag zu einem Tagungsband (2)
- Posterpräsentation (1)
Schlagworte
- Compliance (1)
- Conformance test (1)
- Entscheidungsrisiko (1)
- Grenzwert (1)
- Instrumented indentation test (1)
- Konformitätstest (1)
- Limit value (1)
- Material testing machines (1)
- Materialprüfmaschine (1)
- Mehrdimensionale Verteilung (1)
- Multi-dimensional distribution (1)
- Multivariate Normalverteilung (1)
- Multivariate normal distribution (1)
- Risk of decision (1)
- Span (1)
- Spannweite (1)
- Standard deviation (1)
- Standardabweichung (1)
- Uncertainty (1)
Eingeladener Vortrag
- nein (4)
Bei Konformitätsentscheidungen müssen in der Regel mehrere Spezifikationen bzgl. unterschiedlicher Eigenschaften gleichzeitig eingehalten werden, was zu erhöhten Risiken führen kann. In dem Beitrag werden Verfahren zur Bestimmung der Entscheidungssicherheit bzw. der Irrtumswahrscheinlichkeit bei multivariaten Konformitätsprüfungen dargestellt. Auf die Berücksichtigung von möglichen Korrelationen zwischen den bewerteten Größen des Untersuchungsobjektes wird eingegangen. Grundlage des Verfahrens bildet die Bayes'sche Statistik.
Effect and measurement of the machine compliance in the macro range of instrumented indentation test
(2010)
The contribution concerns the strong effect of the machine compliance in the upper macro range of the instrumented indentation test on hard materials. To achieve a minimum uncertainty in determination of the machine compliance the measurement and analysis needed for the determination are studied in detail. Based on the assumption that the hardness and/or the indentation modulus are force independent, four methods on the determination of the machine compliance are described. Experimental results of a commercial testing machine up to 2500 N and of a standard machine up to 200 N are analyzed. The results show that the uncertainty of the compliance is usually higher than requested for a precisely enough determination of hardness and further materials parameters. Especially for the calibration of reference materials with high hardness and/or Youngs modulus, the machine compliance should be limited in ISO 14577 part 3, 2003 [1].