Filtern
Dokumenttyp
- Zeitschriftenartikel (1)
- Beitrag zu einem Tagungsband (1)
- Vortrag (1)
Sprache
- Englisch (3)
Schlagworte
- Concrete (1)
- Concrete testing (1)
- Defect detection (1)
- Imaging (1)
- Impact echo (1)
- Lamb waves (1)
- Laser (1)
- Non-destructive testing (1)
- Surface Waves (1)
- Ultrasound (1)
Organisationseinheit der BAM
Eingeladener Vortrag
- nein (1)
This study investigates the non-destructive detection of delaminations in concrete plates using non-contact laser ablation, instead of the conventional hammer excitation, as part of the impact echo method. We performed tests on five concrete specimens of different sizes, two of which contained artificial delaminations. A range of steel ball hammers was used as reference impulse sources, the responses of which were compared with wave excitation generated by a 7 ns pulsed 1064 nm Nd:YAG laser with 150 mJ pulse energy. Signals were recorded by surface-mounted accelerometers and two contactless methods: microphones and a laser Doppler vibrometer. The laser generates frequencies across a broad range of frequencies (0 to 150 kHz) but with much less energy than the hammers' narrower frequency spectra; the laser pulse energy transferred into the specimen is 0.07 mJ, corresponding to about 0.5 ‰ of the impulse source energy. Because of this, the thick intact plates' characteristic thickness stretch resonance frequency can be reliably detected by the hammer excitations but not when using laser excitation. However, the laser can excite low-frequency flexural vibration modes over a shallow delamination at 3 cm depth. The low-frequency flexural vibration results are verified by numerical natural frequency analysis.
Rapid and accurate non-destructive evaluation (NDE) techniques are needed to assess the in-place condition of concrete structures. However the time and effort required to perform NDE tests using conventional surface-mounted contact sensors hinder rapid evaluation of full-scale structures. The authors are cooperating in research to develop rapid and robust methods that collect mechanical wave signals from concrete structures and to characterize defects in concrete
using that signal data. The suitability of surface waves and laser-based, non-contact wave detection techniques for this purpose are examined here. After a brief introduction to non-contact sensing, an experimental set-up is described and results from experimental tests are presented. Mechanical surface waves in a concrete slab specimen are generated with several different conventional sources. The ability of a laser vibrometer to detect wave propagation from concrete that does not have any reflective treatment (normal concrete surface) is demonstrated, allowing the generation of ultrasonic images. Test results from a concrete specimen containing a subsurface defect are then presented. The obtained ultrasonic images illustrate some limitations of using surface waves to detect subsurface defects in concrete, although approaches to improve the results are proposed.