This paper presents the state-of-the-art of using non-destructive testing (NDT) methods based on elastic waves for the condition assessment of structural timber. Two very promising approaches based on the propagation and reflections of elastic waves are described. While the first approach uses ultrasonic echoes for the testing of wooden building elements, the second approach uses guided waves (GW) for the testing of timber pole and pile structures. The basic principle behind both approaches is that elastic waves induced in a timber structure will propagate through its material until they encounter a change in stiffness, cross-sectional area or density, at which point they will reflect back. By measuring the wave echoes, it is possible to determine geometric properties of the tested structures such as the back wall of timber elements or the underground length of timber poles or piles. In addition, the internal state of the tested structures can be assessed since damage and defects such as rot, fungi or termite attacks will cause early reflections of the elastic waves as well as it can result in changes in wave velocity, wave attenuation and wave mode conversion. In the paper, the principles and theory of using elastic wave propagation for the assessment of wooden building elements and timber pole/pile structures are described. The state-of-the-art in testing equipment and procedures is presented and detailed examples are given on the practical application of both testing approaches. Recent encouraging developments of cutting edge research are presented along with challenges for future research.
Characterization of reflector types by phase-sensitive ultrasonic data processing and imaging
(2008)
Ultrasonic and radar imaging techniques are limited in resolution by the wavelength in the material, yet information beyond those limits is hidden in complex frequency dependent reflection coefficients. The analysis of the phase of complex reflection coefficients together with the properties of imaging algorithms can help to characterize and to classify indications of defects in concrete buildings. This paper describes a method to extract phase information from measurements and SAFT reconstructed images. The influencing factors like material properties, transducer characteristics, and imaging algorithms based on Born or Physical Optics approximations are elaborated. Simulated and experimental results are briefly discussed.
This paper presents the progress of successful location of grouting faults in tendon ducts with ultrasonic imaging. The examples were obtained in the research group FOR 384 funded by DFG (German Research Foundation). The co-operation of experimental research and modeling allowed imaging and identification of grouted and ungrouted areas of tendon ducts (including strands) in a large test specimen (40 m²). In addition to the criteria for indicating grouting faults in post-tensioned ducts known until now the phase evaluation of reflected ultrasonic pulses is described. Experiments and modeling of wave propagation are presented for reflections at metal plates in concrete (thickness range 0.5 mm to 40 mm) and for tendon ducts including strands.
The main part of the progress was achieved by automated measurements using dry contact transducers, 3D-SAFT reconstruction including phase evaluation and modeling considering wave propagation for typical elastic parameters and exact experimental site conditions. The results for shear waves as well as for pressure waves are compared in the frequency range from 50 kHz to 120 kHz.