Filtern
Erscheinungsjahr
Dokumenttyp
Schlagworte
- Assessment (2)
- Existing steel structures (2)
- Fatigue (2)
- Analysis (1)
- Bridge assessment (1)
- Composition (1)
- Debye–Waller factor (1)
- Double-quantum NMR (1)
- Eignungsnachweis (1)
- Elastomers (1)
Organisationseinheit der BAM
Assessment of existing steel structures - Recommendations for estimation of remaining fatigue life
(2008)
Polyethylene foils, used as greenhouse foils stabilized with various types of sterically hindered amine light stabilizers (HALS), showed an extraordinary prolonged lifetime on exposure to natural or artificial weathering if a gas-phase fluorination under low-pressure conditions was applied. The fluorination was performed using F2/N2 mixtures and provided ca. 50 F/100 C (fluorination degree ap25%). The lifetimes of fluorinated PE foils on exposure to artificial or natural weathering were increased at least by a factor of 2-4 as measured in terms of tensile strength and elongation at break.
A major international inter-comparison exercise on strain-controlled thermo-mechanical fatigue (TMF) has been undertaken to validate a new European Code of Practice for TMF Testing and to provide underpinning information for an ISO Standard. This paper focuses on (a) distribution of samples of Nimonic 90, (b) the establishment of a protocol for testing and reporting results, and (c) the analysis of the results. Participants in the inter-comparison exercise comprised eight inner-circle partners who primarily used test pieces which were all manufactured at the same workshop, albeit of three different test piece geometries, and ten outer-circle participants who manufactured their own test pieces, of their own in-house geometry. Each participant undertook three repeat in-phase (IP) tests and three repeat out-of-phase (OP) tests. The tests were conducted at temperatures cycling between 400 °C and 850 °C, with a strain range selected to give a failure life of approximately 1000 cycles, resulting in a stress range of up to ~1000 MPa. The testing conditions were chosen following a preliminary evaluation of critical testing parameters. Results from solid circular and solid flat test piece geometries, together with hollow tubular test pieces have been compared. The influence of temperature measurement using different types of temperature sensors has also been investigated. In-house repeatability has been assessed, together with inter-laboratory reproducibility. The results have been correlated with modulus and thermal expansion data for individual tests. Initially, the largest contribution to scatter in the results was attributed to human errors in reporting the results, compounded by computer assisted cut-and-paste errors. Once these obvious discrepancies had been corrected, it was possible to use the data sets to point to some recommendations regarding testing procedures that can be incorporated into the Code of Testing Practice [Hähner P et al. Code of practice for thermo-mechanical fatigue testing TMF-Standard-Work Package 6 Report, September 2005] and provide technical underpinning for the ISO Standard. The results and the procedures used for analysis are presented.
To start the large-scale deployment of offshore wind in German waters, the German Federal Ministry for the Environment (BMU) supports the offshore test site "alpha ventus" in the North Sea with a research budget of about 50 million Euro in the next years. The overall objective of the research is to reduce the costs of offshore wind energy deployment in deep water. In order to provide all participating research projects with detailed data, the test site will be equipped with extensive measurement instrumentation.
This research initiative was named RAVE Research at Alpha VEntus and consists of a variety of projects in connection with the installation and operation of alpha ventus. As part of the RAVE initiative, so far the participating institutes and companies have prepared projects on the following topics:
Realization of the joint measurements and data management
Analysis of loads, modelling and further development of the different components of offshore wind turbines
Loads at offshore foundations and structures
Further development of LIDAR wind measuring techniques
Grid integration of offshore wind energy
Monitoring of the offshore wind energy deployment in Germany "Offshore WMEP"
Measurement of the operating noises and modelling of the sound propagation between tower and water
Ecologic research