Filtern
Dokumenttyp
- Vortrag (13)
- Beitrag zu einem Tagungsband (4)
- Zeitschriftenartikel (2)
- Posterpräsentation (1)
Sprache
- Englisch (20) (entfernen)
Schlagworte
- Heat pump (9)
- Energy efficiency (6)
- Energy label (6)
- Energy labelling (5)
- Test method standard optimization (5)
- Seasonal performance (4)
- Air conditioner (3)
- Circumvention (3)
- Climate change (3)
- Coefficient of performance (3)
Organisationseinheit der BAM
Eingeladener Vortrag
- nein (13)
Improving the energy efficiency of products was identified as the most important short-term opportunity to decrease energy consumption and therefore CO2-emission worldwide. More efficient products are created due to technical innovation. Restricting market access to efficient products only and making the most efficient products stand out by energy labelling are legislative approaches to encourage this development. Market surveillance authorities’ checks are fundamental to protect the consumer from wrongly declared goods on the market and ensure fair competition between manufacturers. However, the activities of market surveillance authorities are limited by their financial resources. Testing all product efficiency parameters in an accredited laboratory is very time consuming and cost intensive. In this article, a theoretical concept is presented which can be used to develop screening tests enabling market surveillance authorities to perform product tests with less financial resources. The concept identifies components which lead to non-compliance or make a product less energy efficient with minimum effort. The principle is based on a combination of random product tests, disassembling specific products and comparing components. This represents a new approach in product testing procedures beyond the current market surveillance activities. The concept is being tested within a research project funded by the German government.
In this study, the test method EN 14825 for testing heat pumps is validated by verifying the sensitivity of the seasonal space heating energy efficiency ηs,(declared on the energy Efficiency label) in relation to the nominal heating capacity Pdesign. Therefore, the two major parts of the test method, the measurement part and the calculation part, were investigated. The calculation part was subjected to a sensitivity analysis in order to identify the properties of a heat pump which have a strong influence on ηs. The analysis revealed that the energy consumption in Special operating states, the duration in active-mode and seasonal performance values in active-mode (SCOPon) significantly affect the sensitivity of ηs. Especially short operating times, in which the heat pump is in active-mode, lead to large changes in ηs with varying Pdesign. In addition, the range of power of Pdesign turned out to have an increasing impact on ηs with decreasing Pdesign. For Pdesign values ≤10 kW, the sensitivity of ηs increases tremendously. Especially the determination of the ηs for devices with short operating times in active-mode (1400 h) and low values for Pdesign (≤10 kW)cannot be reproduced anymore.
To determine the seasonal performance of heat pumps for energy labelling this study proposes a two-point-method that could conceivably be an alternative to the European standard EN 14825 and similar test standards such as ISO 13256. Heat pumps were tested in line with the EN 14825. The reduction of measurement points, from between five to seven (EN 14825) to only two (two-point-method), leads to 60 % savings in cost and time. It is shown that the shortened method can be used to determine the seasonal energy efficiency of heat pumps with the same degree of precision compared to EN 14825.
Test methods for heat pumps
(2020)
In this contribution, a dynamic test method to determine the seasonal performance of invertertype air conditioners has been developed and verified. In comparison to current test standards, where test modes for fixing the compressor speed are required, a dynamic approach is applied with unfixed compressor speed and thus better reflects the performance of air conditioners under real operating conditions. The dynamic tests are conducted in two calorimeter chambers. The indoor chamber is kept at a constant temperature whereas the outdoor chamber is subjected to a temperature profile based on the climate BIN-distribution, representing the reference cooling demand. The proposed dynamic test considers the dynamic control of an air conditioner and delivers results which could indicate the units’ performance in the field.