Filtern
Dokumenttyp
- Beitrag zu einem Sammelband (2) (entfernen)
Sprache
- Englisch (2)
Referierte Publikation
- nein (2)
Schlagworte
- Acoustic emission (1)
- Acoustic emission analysis (1)
- Bondline (1)
- DCB test (1)
- Damage zone (1)
- In-situ test (1)
- Interface adhesion (1)
- Interlaminar fracture energy (1)
- Micro-mechanical fracture model (1)
- Micro-mechanisms (1)
Organisationseinheit der BAM
To better understanding the failure of adhesive joints tensile tests were carried out on miniature test specimens from Norway spruce in the synchrotron. Urea-formaldehyde resin was used as adhesive. e. For comparison purposes, tensile tests were carried out on solid wood and on bonded miniature tensile shear samples with acoustic emission. The acoustic emission signals of all the experiments occurred with classified pattern recognition. This resulted in two classes of signals for each two frequency peaks. One class consisted of the low-frequency and the other of the higher-frequency peak of higher intensity, but this was essentially independent from the structure (solid wood or plywood) and size scale of the test specimens. The influence of the adhesive layers was determined on wood test specimens on laboratory scale and on miniature test specimens with an adhesive layer and selected fiber orientations. This gave evidence that the sound emission signals from the failure of the adhesive layer presumably of the class with low frequency signals peak in the range of services can be assigned.
Mode I fracture toughness tests on Double Cantilever Beam specimens from carbon-fibre and glassfibre reinforced polymer-matrix composites were monitored with Acoustic Emission (AE) and loaddisplacement traces and delamination lengths were recorded. AE characterized the kinetics of delamination propagation. The progress of AE activity and AE intensity with load and AE source location plots are used to determine the delamination onset on the microscopic and macroscopic scale.
Energy dissipating processes initiated in the damage zone near the delamination tip. Low Interface adhesion results in lower debonding stresses and larger damage zones compared with composites with good adhesion. Time-dependent linear location of AE sources yields the average length of the damage zone and the average speed of delamination propagation. Parameter analysis has been used empirically for identifying AE source mechanisms. A new Classification Software for transient AE waveforms permits identification of the source mechanism of individual AE signals. A micro-mechanical fracture model based on the AE results describes the contributions of microscopic matrix and Interface mechanisms to the interlaminar fracture energy.