Open Access

The decoupled synthesis of Fe-NC single-site electrocatalysts mediated by Lewis acids enables high active site density and utilization. However, current approaches often rely on small organic molecules and suffer from low synthesis yields due to the high Lewis acid-to-precursor ratios required to achieve highly porous carbons. Here, a porous organic polymer (POP) based on 2,4,6-Triaminopyrimidine (TAP) is utilized as a carbon-nitrogen-based scaffold for the synthesis of Fe─NC electrocatalysts. By tuning the amounts of MgCl2 ·6H2O used both as porogen and active site templating agent, synthetic yields exceeding 45% are achieved, a significant improvement compared to the 6% yield from the molecular analogue and the highest reported forMg2+ templated systems. Subsequent low-temperature exchange with Fe leads to atomically dispersed FeNx, minimizing Fe aggregation. The resulting materials exhibit high specific surface areas (>1000 m2 g−1) with micro-, meso-, and macropores, which promote mass transport and active site accessibility. Compared to Fe─NC synthesized via direct pyrolysis of Fe-coordinated POP, the decoupled method enables significantly higher catalytic activity in both alkaline and acidic media, and delivers 1 A cm−2 at 0.687 ± 0.004 VRHE in an alkaline gas diffusion electrode, highlighting its potential for practical oxygen reduction devices.

Commercial grade-1 titanium samples (Ti, 99.6%) were treated using three alternative methods, (i) femtosecond laser processing, (ii) thermal heat treatment, and (iii) electrochemical anodization, respectively, resulting in the formation of differently conditioned superficial titanium oxide layers. The laser processing (i) was carried out by a Ti:sapphire laser (pulse duration 30 fs, central wavelength 790 nm, pulse repetition rate 1 kHz) in a regime of generating laser-induced periodic surface structures (LIPSS). The experimental conditions (laser fluence, spatial spot overlap) were optimized in a sample-scanning setup for the processing of several square-millimeters large surface areas covered homogeneously by these nanostructures. The differently oxidized titanium surfaces were characterized by optical microscopy, micro Raman spectroscopy, variable angle spectroscopic ellipsometry, and instrumented indentation testing. The tribological performance was characterized in the regime of mixed friction by reciprocating sliding tests against a sphere of hardened steel in fully formulated engine oil as lubricant. The specific tribological performance of the differently treated surfaces is discussed with respect to possible physical and chemical mechanisms.