Filtern
Dokumenttyp
Sprache
- Englisch (23) (entfernen)
Schlagworte
- Non-destructive testing (7)
- Ground penetrating radar (5)
- Masonry (5)
- Radar (5)
- Tomography (4)
- Moisture (3)
- Void detection (3)
- Bridge inspection (2)
- Complex resistivity (2)
- Damage (2)
Eingeladener Vortrag
- nein (2)
One of the main problems in the assessment of the operability, stability and contamination potential of tailings facilities is the lack of data on subsurface materials, properties and structures. One key task in the use of geophysics is the selection of the proper methods for a given site/problem combination. Interpretation of the acquired and processed physical data (e.g. electrical resistivity distribution) into something useful for site assessment (e.g. contamination distribution) is another. In the TAILSAFE project (funded by the European Commission) we have worked with partners on the use of geophysics for tailings facilities inspection. DC and complex resistivity, ground penetrating radar, and spectral analysis of surface waves and multichannel analysis of surface waves have been used on dams and beaches. In most cases, our methods provided useful information on the subsurface structure, but the translation of geophysical values into geotechnical or other parameters is still challenging.
Complex special inspection of an old masonry arch bridge according to the Guideline on Inspection and Condition Assessment of Railway Bridges and numerical analysis of the structure are presented. The guideline summarises recommendations for the step-by-step investigation of railway bridges applying enhanced methods developed during the EU-funded project Sustainable Bridges. For the investigation of the arch barrel, the ballast parameters and the inner structure of the backfill behind the arch barrel a number of various advanced non-destructive and minor-destructive testing methods were applied. Deformation of the structure during load tests was measured using three independent measuring systems: laser vibrometer, LVDT and microwave radar. Results of calculations performed with 2D and 3D models based on FEM are compared with the field load tests. Sensitivity of the ultimate load of the structure to investigated parameters is studied in FE model. Some general conclusions according to methods of testing and modelling of masonry arch bridges are presented and discussed.
Complex resistivity (CR) behavior of building material - first results of field scale measurements
(2008)
Ground Penetration Radar (GPR) as a non-destructive (NDT)-method can be applied to obtain detailed information about the inner structure and condition of bridges without damaging the structure.
In this paper the capabilities and limitations of the application of the fast inspection technique GPR will be demonstrated.
In addition to GPR investigations, geoelectrical measurements, coring and petrophysical investigations have been carried out.
The investigated railway bridge in Olesnica is a typical European masonry arch bridge (age, construction and span length).
It shows typical damage to the masonry arches such as increasing salt concentration, destruction, material losses and longitudinal cracks.
Radar measurements were carried out with two main objectives: (1) Identification of basic geometric dimensions of the bridge and identification of construction details; (2) Evaluation of the condition of the masonry, such as mechanical damage (e.g. cracks) or variation of the moisture content.
Radar antennas of different frequencies (having different penetration depths) have been used to estimate the thickness of the walls.
Because of the high attenuation in the inner masonry structure the measurements have not produced satisfying results, but the radar measurements have been successfully applied to investigate the moisture distribution in the masonry.
These results have been verified by coring and through geoelectrical measurements.
Cracks were studied at two testing areas at one wing wall of the bridge using an automatic 2D radar scanning system.
The radar data were processed using advanced data processing tools like FT-SAFT reconstruction and data fusion.
The processing sequence allowed the creation of high-resolution depth sections (C-Scans).