Filtern
Erscheinungsjahr
Dokumenttyp
- Zeitschriftenartikel (22)
- Beitrag zu einem Tagungsband (19)
- Beitrag zu einem Sammelband (2)
- Buchkapitel (1)
- Vortrag (1)
- Posterpräsentation (1)
Schlagworte
- Friction (14)
- Wear (11)
- Hydrogen (10)
- Vacuum (9)
- Graphite (7)
- Vakuum (7)
- PEEK (6)
- Polymers (5)
- Tribologie (5)
- Hydrogen environment (4)
Organisationseinheit der BAM
Eingeladener Vortrag
- nein (1)
This paper presents investigations on the tribological behaviour of PTFE composites against steel at cryogenic temperatures. The results showed that the friction coefficient decreases with temperature down to 77 K, but did not follow a linear evolution further down to extreme low temperatures. It can be stated that the cryogenic environment has a significant influence on the tribological performance of the polymer composites. The effect of low temperatures was more clearly detected at low sliding speed, where friction heat is reduced. A change in wear mechanism from adhesive to abrasive was observed in this case. SEM and AFM analyses showed that the PTFE matrix composites investigated under these experimental conditions have transferred material onto the disc down to very low temperatures. Chemical analyses indicate the presence of iron fluorides.
Tribologisches Verhalten der Werkstoffpaarung Polymerverbundwerkstoff/Stahl bei tiefen Temperaturen
(2005)
This paper presents the mechanical and tribological properties of
Polytetrafluoroethylene (PTFE) and Polyetheretherketone (PEEK)
matrix composites filled with short carbon fibers in cryogenic
environments. Tensile tests were performed at room temperature (RT)
in air and in LN2. Tribological experiments were carried out with a
pin-on-disc configuration at RT, in LN2, in LH2 and in LHe. PEEK
composites have a better tribological performance than PTFE materials
especially regarding the wear resistance.
For tribological components working under extreme
conditions, such as vacuum, or broad temperature
ranges, it is often a problem to achieve acceptable
durability of their friction parts. Thus, new material
requirements are involved for these tribo-systems, in
particular regarding operability and reliability. At BAM,
several projects were conducted in the recent years,
dealing with the tribological properties of friction
couples at cryogenic temperature and in vacuum
environment. This paper describes the vacuum and ultra
high vacuum tribometers constructed at BAM and
presents experiments carried out with polymer
composites. The experiments presented were performed
with PEEK, filled with solid lubricants, against 304
steel with a pin-on-disc configuration in oscillating
sliding. Friction tests were carried out in vacuum in the
temperature range between -40°C and +160°C and in
ultra high vacuum at room temperature.
In the development of hydrogen technology, special attention is paid to the technical problems of
hydrogen storage. One possible way is cryogenic storage in liquid form. Generally cryotechnical
machines need components with interacting surfaces in relative motion such as bearings, seals or
valves, which are subjected to extreme conditions. Materials of such systems have to be resistant to
friction-caused mechanical deformation at the surface, low temperatures and hydrogen environment.
Since materials failure can cause uncontrolled escape of hydrogen, new material requirements are
involved for these tribo-systems, in particular regarding operability and reliability. In the past few
years several projects dealing with the influence of hydrogen on the tribological properties of friction
couples were conducted at the Federal Institute for Materials Research and Testing, (BAM), Berlin.
This paper reports some investigations carried out with polymer composites. Friction and wear were
measured for continuous sliding and analyses of the worn surfaces were performed after the
experiments. Tests were performed at room temperature in hydrogen as well as in liquid hydrogen.