The present paper aims to re-examine the validity of the linear correlation found between AFTLOC, the adiabatic flame temperature at the apex of the flammability range of fuel-air-inert mixtures (where LOC, the Limiting Oxygen Concentration, is measured) and AFTLFL, the adiabatic flame temperature at the lower flammability limit of fuel-air mixtures (LFL). New sets of experimental measurements of LFL and LOC referring to fuel-air mixtures diluted with N2, CO2 and H2O(vap) from trusted literature sources form a comprehensive database for such evaluation. Both the slope and intercept of correlations AFTLOC = a + b*AFTLFL are dependent on the nature of inert gas and on initial temperature. Based on the linear correlation between AFTLOC and AFTLFL, a procedure for calculation of LOC and MIC (Minimum Inert Concentration) of fuel-air-inert mixtures is presented, using measured or calculated LFL of fuel-air mixtures and their corresponding AFT. The method predicts with reasonable accuracy LOC and MIC of fuel-air-inert mixtures (relative deviations ranging between -14 and +17% when calculated and measured LOC and MIC for fuelair-nitrogen and fuel-air-carbon dioxide at ambient initial conditions are examined).
The classification of flammable gas mixtures is based on either testing or calculation methods proposed by the revised international standard ISO 10156. This standard is used for classification of physical hazards in Chapters 2.2 and 2.4 of the UN Globally Harmonized System of Classification and Labelling of Chemicals (GHS) and in the UN Recommendations on Transport of Dangerous Goods (TDG). The test methods of flammability and oxidizing potential in this standard were developed by BAM. Earlier versions of this standard are not based on triangular diagrams and on the reference combustible substance 'ethane'. The old material characteristics, especially in case of oxidizing potential, are based mostly on practical experience without any quantifiable test results. First time it is possible to compare experimental results from the CHEMSAFE database with the newly developed calculation method. In this paper the basic principles of the calculation methods are presented and the methods are validated by examples. A comparison of experimental flammability data with classification results gained by the calculation methods of ISO 10156 is demonstrated.