Filtern
Erscheinungsjahr
- 2014 (5) (entfernen)
Dokumenttyp
Schlagworte
- Arsenolipids (1)
- Canned cod liver (1)
- Column percolation leaching (1)
- ESI-MS/MS (1)
- HPLC-ICP-MS/ESI-Q-TOF-MS (1)
- Marine fish (1)
- Perfluorinated surfactants (1)
- Pesticides (1)
- Total petrol hydrocarbons (1)
Arsenolipids (AsL) of the type arsenic-containing fatty acids (AsFA) and hydrocarbons (AsHC) are known to occur in seafood and their identification is today a challenge due to the need of data for toxicological assessment. The aim of this investigation was to enhance the data concerning AsL in commercial canned cod liver. Therefore, the present study focuses on the quantification and identification of AsL by LC–ICP-MS combined with ESI-MS. The molecular structure of 17 AsL was elucidated on the basis of their exact mass and their product ion spectra and two new AsFA tentatively identified. The total arsenic concentration in four different canned cod liver analyzed by ICP-MS ranged from 2.6 to 5.5 mg As/kg with an extraction recovery of 98%. The AsL detected by RP-IPC–MS comprise 58–95% of the total arsenic content, indicating that AsL are a major class of arsenic in canned cod liver. Much of the AsL detected in the canned cod liver extracts are, however, not yet identified.
Practical applications: The results obtained in the present research show the possibility to apply the current extraction and detection method in different biological samples for the determination of AsL. Additionally, this information can be used for further studies to assess the risk of AsL for consumer health. On the other hand, the MS/MS results could be used for the future identification of AsL without the ICP-MS detection and thus, low the cost of the analysis.
KEY COMPARISON
Under the auspices of the Organic Analysis Working Group (OAWG) of the Comité Consultatif pour la Quantité de Matière (CCQM) a key comparison, CCQM K55.c, was coordinated by the Bureau International des Poids et Mesures (BIPM) in 2012. Twenty National Measurement Institutes or Designated Institutes and the BIPM participated. Participants were required to assign the mass fraction of valine present as the main component in the comparison sample for CCQM-K55.c. The comparison samples were prepared from analytical grade L-valine purchased from a commercial supplier and used as provided without further treatment or purification.
Valine was selected to be representative of the performance of a laboratory's measurement capability for the purity assignment of organic compounds of low structural complexity [molecular weight range 100300] and high polarity (pKOW > –2).
The KCRV for the valine content of the material was 992.0 mg/g with a combined standard uncertainty of 0.3 mg/g. The key comparison reference value (KCRV) was assigned by combination of KCRVs assigned from participant results for each orthogonal impurity class. The relative expanded uncertainties reported by laboratories having results consistent with the KCRV ranged from 1 mg/g to 6 mg/g when using mass balance based approaches alone, 2 mg/g to 7 mg/g using quantitative 1H NMR (qNMR) based approaches and from 1 mg/g to 2.5 mg/g when a result obtained by a mass balance method was combined with a separate qNMR result.
The material provided several analytical challenges. In addition to the need to identify and quantify various related amino acid impurities including leucine, isoleucine, alanine and a-amino butyrate, care was required to select appropriate conditions for performing Karl Fischer titration assay for water content to avoid bias due to in situ formation of water by self-condensation under the assay conditions. It also proved to be a challenging compound for purity assignment by qNMR techniques.
There was overall excellent agreement between participants in the identification and the quantification of the total and individual related structure impurities, water content, residual solvent and total non-volatile content of the sample. Appropriate technical justifications were developed to rationalise observed discrepancies in the limited cases where methodology differences led to inconsistent results.
The comparison demonstrated that to perform a qNMR purity assignment the selection of appropriate parameters and an understanding of their potential influence on the assigned value is critical for reliable implementation of the method, particularly when one or more of the peaks to be quantified consist of complex multiplet signals.
Column tests are a common tool to investigate the leaching behavior of contaminated soil and waste materials. In contrast to inorganic analytes, fewer studies with organic contaminants are available based on column tests. This paper is aimed at the question if soil materials contaminated with organic pollutants can be reliably investigated by column tests. Soils contaminated with TPH (total petrol hydrocarbons), PFC (perfluorinated surfactants) and the biocide tebuconazole were used for column percolation tests. Differences in the leaching behavior are mainly driven by partitioning behavior between organic carbon and water, which can be estimated from log KOW values and size and shape of molecules. PFC show higher release (10–50% for individual compounds) than pesticides (3.7–5.3%) and TPH (< 1%) at liquid to solid ratio of 4 l/kg. All eluate concentrations are low with maximum concentrations of 50 µg/l for PFC and 1–2 mg/l for pesticides and TPH. Despite this, the observed standard deviations are quite small suggesting good repeatability. In general the observed concentration trends are similar to that from lysimeter studies found in the literature and thus, it can be concluded that laboratory column experiments are a reliable tool for organic compounds with various physico-chemical properties.