Filtern
Erscheinungsjahr
- 2017 (6) (entfernen)
Dokumenttyp
Sprache
- Englisch (6) (entfernen)
Schlagworte
- Spectral induced polarization (4)
- Mercury intrusion porosimetry (2)
- Nuclear magnetic resonance (2)
- Sandstone (2)
- µ-CT (2)
- Bentheimer Sandstone (1)
- Complex resistivity (1)
- ESEM (1)
- Electrical properties (1)
- Electrical relaxation (1)
Within this study we have shown, that spectral induced polarization is a reliable method for the enhanced characterization of the Fontainebleau sandstone in general, and for its related stratigraphical units in particular. Due to its high sensitivity towards pore network and pore surface changes, different stratigraphical units can be clearly differentiated and
probably even classified. We have observed a good correlation between the maximum of the SIP phase shift and the dominant pore throat radius for this rock type, as it has been reported for others sandstones before [20].
We investigate the pore space of rock samples with respect to different petrophysical parameters using various methods, which provide data upon pore size distributions, including micro computed tomography (μ-CT), mercury intrusion porosimetry (MIP), nuclear magnetic resonance (NMR), and spectral induced polarization (SIP). The resulting cumulative distributions of pore volume as a function of pore size are compared. Considering that the methods differ with regard to their limits of resolution, a multiple length scale characterization of the pore space geometry is proposed, that is based on a combination of the results from all of these methods. The findings of this approach are compared and discussed by using Bentheimer sandstone. Additionally, we compare the potential of SIP to provide a pore size distribution with other commonly used methods (MIP, NMR). The limits of resolution of SIP depend on the usable frequency range (between 0.002 and 100 Hz). The methods with similar resolution show a similar behavior of the cumulative pore volume distribution in the overlapping pore size range. The methods μ-CT and NMR provide the pore body size while MIP and SIP characterize the pore throat size. Using this difference, the average pore body to throat ratio is determined to be about three for the Bentheimer sandstone.
Our study shows that a good agreement between the pore radii distributions can only be achieved if the curves are adjusted considering the resolution and pore volume in the relevant range of pore radii. The MIP curve with the widest range in resolution should be used as reference
Nuclear magnetic resonance (NMR) is a well established laboratory / borehole method to characterize the storage and transport properties of rocks due to its direct sensitivity to the corresponding pore fluid saturation (water or oil) and pore sizes.
For petrophysical applications there are several different NMR laboratory devices commercially available varying over a wide range of e.g. magnetic field strength / frequency (2 MHz to 30 MHz), applicable measurement protocols (T1, T2, T1-T2, T2-D, etc.) and sample sizes (2.5 cm to 10 cm in diameter). In this work we present NMR measurements, layed out in a round robin like manner, on a set of 20 sandstone samples. We use three different NMR devices containing two standard setups with homogenous magnetic fields (LIAG and RWTH) and one single-sided setup with gradient field (BGR) to measure T1 and T2 relaxation data. In our evaluation we especially focus on the comparison of the individually inverted relaxation time distributions to quantify the differences arising from different laboratory setups. Diverging results can be deduced on the one hand to the inherit differences between homogeneous and gradient fields but on the other hand also due to quality differences between the two homogeneous setups. Additionally, we also examine the influence of the individually chosen inversion parameters (signal processing, distribution sampling points, error weighting, regularization, etc.) to establish a general standardized best practice recommendation for future petrophysical NMR laboratory measurements.
The pore size distribution provides a suitable description of the pore space geometry that can be used to investigate the fractal nature of the pore space or to determine a fractal dimension. Fractal dimension describes the size of geometric objects as a function of resolution. It can be integrated into models of permeability prediction. We investigated the fractal dimension of the pore volume of 11 Eocene sandstone samples from China. This study describes an approach to use spectral induced polarisation spectra to estimate the pore size distribution and to determine the fractal dimension of the pore volume. Additionally, the fractal dimension was derived from data of the capillary pressure curves from mercury intrusion and the transversal relaxation time distribution of nuclear magnetic resonance. For samples with an effective pore radius larger than 1 μm, good agreement exists between the values of fractal dimension derived from the three different methods, which implies the identification of similar pore structures. Spectral induced polarisation can be a non-invasive laboratory technique for the estimation of the pore size distribution, but the application of the methodology for field measurements remains a challenging problem considering the limited frequency range.
We combined two completely different methods measuring the frequency-dependent electrical properties of moist porous materials in order to receive an extraordinary large frequency spectrum. In the low-frequency (LF) range, complex electrical resistivity between 1 mHz and 45 kHz was measured for three different soils and sandstone, using the spectral induced polarization (SIP) method with a four electrode cell. In the high-frequency (HF) radio to microwave range, complex dielectric permittivity was measured between 1MHz and 10 GHz for the same samples using dielectric spectroscopy by means of the coaxial transmission line technique. The combined data sets cover 13 orders of magnitude and were transferred into their equivalent expressions: the complex effective dielectric permittivity and the complex effective electrical conductivity.We applied the Kramers-Kronig relation in order to justify the validity of the data combination. A new phenomenological model that consists of both dielectric permittivity and electrical conductivity terms in a Debye- and Cole–Cole-type manner was fitted to the spectra. The combined permittivity and conductivity model accounts for the most common representations of the physical quantities with respect to the individual measuring method. A maximum number of four relaxation processes was identified in the analysed frequency range. Among these are the free water and different interfacial relaxation processes, the Maxwell-Wagner effect, the counterion relaxation in the electrical double layer and the direct-current electrical conductivity. There is evidence that free water relaxation does not affect the electrical response in the SIP range. Moreover, direct current conductivity contribution (bulk and interface) dominates the losses in the HF range. Interfacial relaxation processes with relaxations in the HF range are broadly distributed down to the LF range. The slowest observed process in the LF range has a minor contribution to the HF response.
Other than commonly assumed the relaxation times observed in the electrical low-frequency range (1 mHz – 40 kHz) of natural porous media like sandstones and tuff stones cannot be directly related to the dominant (modal) pore throat sizes, measured (e.g.) with mercury intrusion porosimetry (MIP). Working with a great variety of sandstones from very different origins and featuring great variations in textural and chemical compositions as well as in geometrical pore space properties, it was observed that particularly samples with narrow pore throats were characterized by long (low-frequency) relaxations. These, however, can (following the current theories) be rather explained by long “characteristic length scales” in these media or low diffusion coefficients along the electrical double layer. However, there is no straightforward way (or single approved method) of getting reliable numbers for properties such as the lengths of pore throats, the diameter and length of the wide pores and their respective distributions. Consequently we follow a multi-methodical approach and combine the benefits of MIP, micro-computed tomography (μ-CT) and nuclear magnetic resonance (NMR) to achieve much deeper insight due to the different resolutions and sensitivities to either pore constrictions (throats) or wide pores. This helps us to understand, whether the observed electrical relaxation phenomena actually depend on geometric length scales or rather on other properties such as chemical composition, clay content, clay type or cation exchange capacity. In this paper, we showcase selected results of a systematic study of a total of 16 sandstones and three tuffs. Findings and the particular advantage of the used method combination are discussed and shown in detail for a representative sample selection.