Filtern
Dokumenttyp
Schlagworte
- Venting (3)
- Dust explosion (2)
- Turbulence (2)
- Dispersion (1)
- Dust explosions (1)
- Dustiness (1)
- Gas explosion (1)
- Gas explosions (1)
On drafting a new European standard "Gas Explosion Venting Protective Systems" a lack of data has been identified for venting at low activation pressures. Therefore, experiments have been performed on vented gas explosions using bursting foils of different strength. Cylinders of different volumes and length-to-diameter ratios (L/D) have been used as explosion vessels. The vessels were made from glass to make the flame propagation observable by a high-speed video system. For the dependence of the reduced explosion pressure Pred on L/D a maximum occurred for L/D about 3. This could be shown for vessels of different volumes and for different vent sizes. Using bursting foils of different strength it could be shown that the pressure evolution after the vent had opened, depended on the activation pressure only, when the vent size was to small to prevent a second peak in the pressure- time curve.
Der maßgebliche Einfluss turbulenter Strömungsbewegungen auf den Ablauf von
Explosionen ist bereits seit längerem bekannt. Wegen der Schwierigkeit, Betrag und
Richtung der turbulenten Schwankungsgeschwindigkeit in-situ zu messen, existieren
jedoch nur wenige diesbezügliche experimentelle Daten.
Es wurde deshalb eine aus drei Glassegmenten bestehende Versuchsapparatur mit
etwa 100 l Volumen und einem Länge/Durchmesser-Verhältnis von 4,7 errichtet, die
die gleichzeitige Messung der Strömungsgeschwindigkeit und deren turbulenter
Fluktuation, der Ausbreitungsgeschwindigkeit der Flamme, der zeitlichen Entwicklung
des Explosionsdruckes sowie im Falle von Staubexplosionen der Staubkonzentration
erlaubte.
Die Glassegmente wurden durch Metallflansche verbunden, an welche insgesamt
sechzehn gleichmäßig über Umfang und Höhe verteilte Ventilatoren zur kontrollierten
Erzeugung eines Turbulenzfeldes montiert waren.
Die Explosionsversuche wurden mit einem Propan-Stickstoff-Sauerstoff-Gemisch
sowie mit einem Maisstärke-Luft-Gemisch durchgeführt. Die Zündung der
explosionsfähigen Gemische erfolgte durch einen Hochspannungsfunken.
Als Berstfolien wurden zwei Polyethylenfolien (Dicke 10 und 15 µm) und drei
Aluminiumfolien (Dicke 15, 20 und 22 µm) verwendet.
Die Versuche zeigten sowohl bei Gas- als auch bei Staubexplosionen eine Zunahme
des reduzierten Explosionsdruckes für wachsende turbulente Schwankungs-geschwindigkeiten
im Bereich von 0 m/s bis 0,45 m/s. Diese Zunahme war
besonders ausgeprägt für verhältnismäßig kleine Entlastungsflächen (Durchmesser <
70 mm) bei geringen Ansprechdrücken (Polyethylenfolie), während für höhere
Ansprechdrücke (Aluminiumfolie) der Einfluss der Turbulenz zurückging.
Zur Ergänzung der Experimente wurden Simulationsrechnungen mit dem
Computational Fluid Dynamics-Programm Fluent6 unternommen. Diese Rechnungen
dienten der Validierung der den Programmen zugrunde liegenden Modelle im
Hinblick auf ihre Anwendbarkeit zur Berechnung von Explosionsabläufen in
technischen Anlagen. Es konnte eine realistische Wiedergabe der Druck-Zeit-Verläufe
durch die Rechnungen erreicht werden.
Experiments were performed on the influence of pre-ignition turbulence on the course of vented gas and dust explosions. A vertical cylindrical explosion chamber of approximately 100 l volume and a length-to-diameter ratio (l/d) of 4.7 consisting of a steel bottom segment and three glass sections connected by steel flanges was used to perform the experiments. Sixteen small fans evenly distributed within the chamber produced turbulent fluctuations from 0 to 0.45 m/s. A Laser-Doppler-anemometer (LDA) was used to measure the flow and turbulence fields. During the experiments the pressure and in the case of dust explosions the dust concentration were measured. In addition, the flame propagation was observed by a high-speed video camera. A propane/nitrogen/oxygen mixture was used for the gas explosion experiments, while the dust explosions were produced by a cornstarch/air mixture.
It turned out that the reduced explosion pressure increased with increasing turbulence intensity. This effect was most pronounced for small vents with low activation pressures, e.g. for bursting disks made from polyethylene foil. In this case, the overpressure at an initial turbulence of 0.45 m/s was twice that for zero initial turbulence.
A new safety characteristic the 'dustiness' according to VDI 2263 – part 9 (Verein Deutscher Ingenieure, 2008) is investigated. Dustiness means the tendency of a dust to form clouds. The paper deals with the physical reasons for the different behavior of dusts, even if they have similar properties such as particle size and density and the influence of the dustiness on dust explosions. In order to study the effects of the dustiness on dust cloud formation for different dispersion methods experiments in a vertical dust dispersion glass tube apparatus were carried out. Furthermore vented dust explosion experiments were done for two different dispersion methods and two static activation pressures.
Experiments show that particle size and density are not the only factors which influence dispersibility. Particle shape, specific surface area, flow and dispersion method have an influence which can outweigh size and density. Preliminary explosion experiments showed that the dustiness has an influence on the reduced explosion pressure and flame speed in a vented 75 L test apparatus. In order to verify the results for applications in the process industries further tests with industrial scale experiments are planned.