Filtern
Erscheinungsjahr
Dokumenttyp
- Beitrag zu einem Tagungsband (57)
- Zeitschriftenartikel (46)
- Posterpräsentation (33)
- Beitrag zu einem Sammelband (15)
- Vortrag (7)
- Sonstiges (1)
Schlagworte
- MALDI-TOF-MS (6)
- Polycondensation (6)
- MALDI (5)
- Oligomers (4)
- Macrocycles (3)
- Biodegradable polyesters (2)
- Flüssigchromatographie (2)
- Macrocyclics (2)
- Model compounds for melanoidins (2)
- Polyesters (2)
Eingeladener Vortrag
- nein (7)
Poly(ether sulfone)s were prepared by polycondensation of silylated 4-tert-butylcatechol and 4,4?-difluorodiphenylsulfone in N-methylpyrrolidone. The feed ratio and the reaction time were varied to study the influence of stoichiometry and conversion on molecular weight and extent of cyclization. Molecular weights and molecular weight distributions (MWD)s were characterized by SEC measurements calibrated with polystyrene. Light scattering confirmed that calibration with polystyrene gives reasonable results and revealed a tendency towards a bimodal MWD for the samples rich in cycles. The MALDI-TOF mass spectrometry indicated that the extent of cyclization increased with higher conversion and with optimization of the stoichiometry. This interpretation was confirmed by 1H NMR endgroup analyses. For the samples with the highest molar masses only mass peaks of cycles were found, which were detectable up to 20 000 Da before and up to 27 000 Da after fractionation. Via the pseudo-high dilution method low molar mass poly(ether sulfone) containing more than 95 mol% of cycles were prepared, and even these low molar mass samples had broad MWDs. DSC measurements indicated that the glass transition temperatures depend on the structure of the endgroups and increase with higher fractions of cycles.
3,5-Bis(4-fluorobenzoyl)phenol was polycondensed under various reaction conditions. Low molecular weights were obtained (Mn < 8000 Da), and MALDI-TOF mass spectrometry indicated that the chain growth was limited by cyclization. In the best mass spectra the cyclic, hyperbranched poly(ether ketone)s were detectable up to masses around 14 000 Da. When 4,4'-difluordiphenyl sulfone was added, star-shaped polymers having a diphenyl sulfone star center were formed, but cyclization was not completely suppressed. The results were compared to those obtained from "linear polycondensations" based on 4,4'-difluorobenzophenone (DFBP) and 4-tert-butylcatechol or bisphenol A. The poly(ether ketone)s of DFBP had also low molecular weights and contained high fractions of cycles. It is concluded that also in the case of hyperbranched polymers cyclization competes with propagation at any stage of the polycondensation at any concentration. Therefore, the fundamental trend of any "abn" polycondensation is the formation of star-shaped polymers having a cyclic core and hyperbranched star arms.
Numerous polycondensations of isosorbide and suberoyl chloride or other aliphatic dicarboxylic acid dichlorides were performed with pyridine as a catalyst and HCl acceptor. The reaction conditions were varied to optimize both the molecular weight and the fraction of cyclic oligo- and polyesters. Furthermore, we attempted to obtain the cyclic monomer by catalyzed back-biting degradation of the molten cyclic polyesters above 220 °C in vacuo. The polyesters were characterized by viscosity and size exclusion chromatographic measurements as well as matrix-assisted laser desorption/ionization time-of-flight mass spectrometry. In selected cases, mixtures of linear and cyclic polyesters were treated with a hot solution of partially methylated ß-cyclodextrin in methanol. This treatment allowed for a selective extraction of the linear chains up to approximately 5000 Da.
Liquid chromatography in combination with spectroscopic methods like matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS) or nuclear magnetic resonance (NMR) spectroscopy is a powerful method to characterize silsesquioxanes and silsesquioxane mixtures. As new examples, the formation of silsesquioxyl-substituted silsesquioxanes [(n-octyl)7(SiO1.5)8]2O and [(n-octyl)7(SiO1.5)8O]2[(n-octyl)6(SiO1.5)8] as well as the cage rearrangement of octa-[(n-heptyl)silsesquioxane] to larger structur es [(n-heptyl)SiO1.5)]n up to n=28 are shown.
A series of Cp(C5H5)ZrCl2 and Cp2ZrCl2 pre-catalysts (Cp = C5HMe4, C4Me4P, C5Me5, C5H4tBu, C5H3-1,3-tBu2, C5H2-1,2,4-tBu3) together with (C5H5)2ZrCl2 was used for the directed oligomerization of propene and 1-hexene in comparative experiments. Oligomer characterization was carried out by 1H NMR, SEC (GPC), MALDI-TOF MS, cryoscopy and Raman spectroscopy. From 1H NMR the nature and relative ratio of the double-bond end group is determined together with n if every oligomer molecule contains such a double-bond end group. Normally vinylidene double bonds (from -hydrogen elimination) are found. From 1H NMR and MALDI-TOF MS also vinyl end groups (from -methyl elimination) are observed in the case of oligopropenes with (C4Me4P)- (C5H5)ZrCl2 and with the symmetrical methyl containing Cp2ZrCl2 pre-catalysts. The vinylidene/vinyl ratio depends on the ligand and increases from C5HMe4 (65/35) over C4Me4P (61/39) to C5Me5 (9/91). A comparison of n from 1H NMR and SEC together with MALDI-TOF MS shows that the phospholyl-zirconocenes and (C5HMe4)2ZrCl2 also exhibit chain transfer to aluminium, thereby giving saturated oligomers.
Various dibutyltin derivatives were polycondensed with aliphatic ,-dicarboxylic acids having chain lengths from 4 (succinic acid) to 22 carbon atoms. White crystalline products were obtained from all experiments, and the structure of the products was independent of the synthetic method. Viscosity measurements revealed low molecular weights (n 1 500 Da) in all cases. Vapor pressure osmometry (VPO) measurements and matrix-assisted laser desorption time-of-flight (MALDI-TOF) mass spectrometry proved that cyclic dimers and trimer were formed from dicarboxylic acids having 6 to 16 carbons, but mainly the monomeric cycle from docosane dioic acid. Heating to 250°C did not change the structure. Therefore, the results indicate that the macrocycles are the result of a thermodynamically controlled ring-closing polycondensation. This means that linear high-molecular weight poly(dibutyltin dicarboxylate)s cannot exist above room temperature.
Various dibutyltin derivatives were polycondensed with aliphatic ,-dicarboxylic acids having chain lengths from 4 (succinic acid) to 22 carbon atoms. White crystalline products were obtained from all experiments, and the structure of the products was independent of the synthetic method. Viscosity measurements revealed low molecular weights (n 1 500 Da) in all cases. Vapor pressure osmometry (VPO) measurements and matrix-assisted laser desorption time-of-flight (MALDI-TOF) mass spectrometry proved that cyclic dimers and trimer were formed from dicarboxylic acids having 6 to 16 carbons, but mainly the monomeric cycle from docosane dioic acid. Heating to 250°C did not change the structure. Therefore, the results indicate that the macrocycles are the result of a thermodynamically controlled ring-closing polycondensation. This means that linear high-molecular weight poly(dibutyltin dicarboxylate)s cannot exist above room temperature.
Three new aromatic polyazomethines have been synthesized by solution polycondensation reactions of terephthalic dialdehyde with fluorine containing aromatic diamines. The polymers were obtained in high yields. The investigation of these polymers by means of matrix-assisted laser desorption ionizationtime-of-flightmass spectrometry (MALDITOFMS) proved the initial members of the four theoretical possible series of the corresponding oligomers with 210 repeating units per molecule.
Organically modified cage-like double four-ring spherosilicates have received considerable interest in the construction of nanosized hybrid materials, as well as building units for structural well-defined polymers. This group is extended by perfluoroalkyl ligands containing spherosilicates, synthesized by addition reaction of the octahydridodimethylsiloxyoctasilsesquioxane [H(CH3)2Si]8Si8O20 and heptadecafluorodecyl methacrylate. The resultant liquid spherosilicate substituted with eight terminal perfluoroalkyl groups was characterized by 29Si and 13C NMR spectroscopies and MALDI Time-of-Flight mass spectrometry. Partial substitution of perfluoroalkyl ligands by trimethoxysilyl containing groups provides condensable precursors for the synthesis of hydrophobic and oleophobic materials via the sol-gel process. This new spherosilicate, carrying on average four perfluoroalkyl groups and four trimethoxysilyl groups shows better hydrophobic and oleophobic properties compared with commonly used perfluoroalkyltrialkoxysilanes under identical concentration of perfluoroalkyl chains. In addition a comprehensive literature survey is given on structural well characterized, organically modified cage-like double four-ring spherosilicates.
Improved Synthesis and Characterization of w-Primary Amino-Functional Polystyrenes and Polydienes
(2002)
The role of 1,1-diphenylethylene (DPE) in radical emulsion polymerization of methyl methacrylate is investigated. The presence of DPE causes a strong decrease in both the rate of polymerization and the molecular weight. According to the results of structure analysis by means of MALDI-TOF mass spectrometry, UVvis spectroscopy, and 1HNMR spectroscopy, DPE is incorporated in the copolymer chain exclusively as a reactive recombinant ?,p-dimer, underlining the peculiar role of DPE in radical polymerizations.