Filtern
Dokumenttyp
Schlagworte
- Hydrogen (6)
- Hydrogen assisted cracking (3)
- Carrier gas hot extraction (2)
- Creep resisting materials (2)
- Creep-resistant steel (2)
- Microstructure (2)
- Aerospace materials (1)
- Analytical calculation (1)
- Chemical corrosion (1)
- Corrosion (1)
- Corrosion testing (1)
- Creep-resistant Steel (1)
- Degradation (1)
- Diffusion (1)
- Diffusion Coefficient (1)
- Duplex stainless steel (1)
- Electrochemical corrosion (1)
- Experimental design (1)
- Handbook (1)
- Heat affected zone (1)
- Hydrogen assisted stress corrosion cracking (1)
- Hydrogen dependent mechanical properties (1)
- Hydrogen diffusion (1)
- Hydrogen embrittlement (1)
- Korrosion (1)
- Korrosionsschutz (1)
- Loch- u. Spaltkorrosion (1)
- Low alloy steels (1)
- Martensite (1)
- Material properties (1)
- Modeling (1)
- Numerical Simulation (1)
- Numerical modeling (1)
- Permeation (1)
- Post weld heat treatment (1)
- Pressure Vessel Steel (1)
- Solubility (1)
- Spannungsrisskorrosion (1)
- Stress corrosion cracking (1)
- Temperature (1)
- Temperature effect (1)
- Tensile loading (1)
- Thermal conductivity device (1)
- Ultra high strength steels (1)
- Ultra-high strength steel (1)
- Wasserstoff (1)
- Weld metal (1)
- Welding (1)
Organisationseinheit der BAM
Paper des Monats
- ja (1)
Spectacular failure cases of fossil power stations in the recent years exhibited severe cracking in T24 welds. The results show that hydrogen-assisted cracking up to 200 °C cannot be excluded. Hence, it is important to gain a basic understanding on how hydrogen might affect the basic material properties in the respective weld microstructures. The present study focuses on hydrogen degradation of the respective weld microstructures, i.e., the weld metal and the coarse grained heat affected zone, where actually cracking appeared in practice. Tensile tests were carried out for coarse grain heataffected zone (CGHAZ) and the weld metal in uncharged and electrochemically hydrogen-charged condition. It turned out that both microstructures show distinct tendency for gradual degradation of mechanical properties in the presence of increasing hydrogen concentration. Already for a hydrogen concentration about and above 2 ml/100 g Fe, a significant ductility reduction has been observed. SEM investigations revealed that the fracture topography changes from ductile topography in uncharged condition to intergranular topography for the CGHAZ and to ductile-brittle mix for the weld metal (WM) in hydrogen charged condition. Ti-rich inclusions were identified as central regions of quasi-cleavage fracture areas in the WM. An approximation procedure is applied to quantify the degradation intensity.
Quantitative investigations of hydrogen dependent properties of aircraft landing gear materials have only scarcely been carried out in the past. They are essential for respective component life time assessments. To better understand the behavior of these landing gear materials in a hydrogen rich environment, specimens were charged in the condition as delivered with known concentrations of hydrogen and then mechanically tested to evaluate the degradation effects. The present contribution is focused on evaluating the hydrogen concentration dependent material properties and the respective fracture topographies of the two investigated steels, and then continued by the comparison of the results with other previously investigated martensitic steels in order to better understand the thresholds for these materials to maintain structural integrity.