Filtern
Dokumenttyp
- Zeitschriftenartikel (11)
Sprache
- Englisch (11)
Referierte Publikation
- ja (11)
Schlagworte
- Bone (11) (entfernen)
Organisationseinheit der BAM
A method is described for high-resolution label-free molecular imaging of human bone tissue. To preserve the lipid content and the heterogeneous structure of osseous tissue, 4 μm thick human bone sections were prepared via cryoembedding and tape-assisted cryosectioning, circumventing the application of organic solvents and a decalcification step. A protocol for comparative mass spectrometry imaging (MSI) on the same section was established for initial analysis with time-of-flight secondary ion mass spectrometry (TOF-SIMS) at a lateral resolution of 10 μm to <500 nm, followed by atmospheric pressure scanning microprobe matrix-assisted laser desorption/ionization (AP-SMALDI) Orbitrap MSI at a lateral resolution of 10 μm. This procedure ultimately enabled MSI of lipids, providing the lateral localization of major lipid classes such as glycero-, glycerophospho-, and sphingolipids. Additionally, the applicability of the recently emerged Orbitrap-TOF-SIMS hybrid system was exemplarily examined and compared to the before-mentioned MSI methods.
The surface of a titanium alloy (Ti6Al4V) implant material was covered with a bioactive calcium alkali phosphate ceramic with the aim to accelerate the healing and to form a stronger bond to living bone tissue. To fix the ceramic powder we used a femtosecond laser, which causes a thin surface melting of the metal. It is a requirement to prove that the laser irradiation would not reduce the lifetime of implants. Here we present the results of mechanical stability tests, determined by the rotating bending fatigue strength of sample rods. After describing the sample surfaces and their modifications caused by the laser treatment we give evidence for an unchanged mechanical stability. This applies not only to the ceramic fixation but also to a comparatively strong laser ablation.
A variation of the cross polarization (CP) experiment is discussed. The method requires two scans where the difference signal is equivalent to the I spin magnetization that is transferred to the S spins. The acquired signal is equivalent to F1 sum projection of a two-dimensional (2D) heteronuclear correlation experiment and is obtained by just two scans without the need to increment the indirect time domain t1. Any polarization transfer method and any kind of spin manipulations during the t1 incrementation period of a 2D NMR experiment can be applied. The method allows fast measurements of the CP transfer, particularly if various S spins signal overlap and is good for spectral editing of I spin signals with contact to S spins. Various examples for biomaterials are presented. Most importantly, this novel approach is ideal for detailed investigations of organicmineral interfaces in bone, here demonstrated for O-phospho-L-serine as simple model compound.
Bioactive ceramics used as coating materials combine the conductive properties of a bioceramic with the mechanical stability of the metal implant. We studied a calcium zirconium phosphate-containing coating material, FA-CZP [Ca5(PO4)3F, CaZr4(PO4)6], that is relatively insoluble in the biological milieu. The reaction of bone to this material was investigated histologically and histomorphometrically in an animal trial. Cylindrical Ti6Al4V specimens that had been coated with FA-CZP by plasma spraying were implanted in the femoral condyles of rabbits. The implants were left in place for 2, 4, 6, 12, and 14 weeks. FA-CZP led to impaired mineralization of the newly formed bone at the interface. Noncalcified osteoid was found throughout the whole study period. The layer seemed to become thicker with time. The mineralization disorder is evidently caused by zirconium ions. The presence of zirconium in the osteoid in contact with the implant was demonstrated by means of two different staining methods.
A solid-state NMR comparison of the mineral structure in bone from diseases joints in the horse
(2007)
In this work, subchondral cortical bone material is investigated from the joints of five horses, three of which presented with no clinical signs or radiographic signs of osteoarthritis and two of which suffered osteoarthritis joint disease, as judged by clinical and radiographic assessment and histological findings. The horse is a good model for osteoarthritis in humans, so the aim of this study is to use nuclear magnetic resonance (NMR) for a detailed investigation of the bone structure in bone material affected by osteoarthritis. In particular, we report on the assessment of the mineral structure of these samples as viewed by solid-state NMR.
Hydrogen-bearing species in the bone mineral environment were investigated using solid-state NMR spectroscopy of powdered bone, deproteinated bone, and B-type carbonated apatite. Using magic-angle spinning and cross-polarization techniques three types of structurally-bound water were observed in these materials. Two of these water types occupy vacancies within the apatitic mineral crystal in synthetic carbonated apatite and deproteinated bone and serve to stabilize these defect-containing crystals. The third water was observed at the mineral surface in unmodified bone but not in deproteinated bone, suggesting a role for this water in mediating mineral-organic matrix interactions. Direct evidence of monohydrogen phosphate in a 1H NMR spectrum of unmodified bone is presented for the first time. We obtained clear evidence for the presence of hydroxide ion in deproteinated bone by 1H MAS NMR. A 1H-31P heteronuclear correlation experiment provided unambiguous evidence for hydroxide ion in unmodified bone as well. Hydroxide ion in both unmodified and deproteinated bone mineral was found to participate in hydrogen bonding with neighboring water molecules and ions. In unmodified bone mineral hydroxide ion was found, through a 1H-31P heteronuclear correlation experiment, to be confined to a small portion of the mineral crystal, probably the internal portion.