Filtern
Dokumenttyp
- Zeitschriftenartikel (1)
- Vortrag (1)
Sprache
- Englisch (2)
Schlagworte
- Air coupled (2) (entfernen)
Organisationseinheit der BAM
Eingeladener Vortrag
- nein (1)
Imaging wood defects using air coupled ferroelectret ultrasonic transducers in reflection mode
(2020)
Air-coupled ultrasound (ACU) is used to detect defects in wood panels without physically contacting the sample and with a quick scanning rate. Transducers made of cellular polypropylene (PP) with a high signal-to-noise ratio are quite suitable for ACU testing of wood. The extremely low modulus of elasticity and low density of PP transducers results in a small difference in acoustic impedance for the Transmission of ultrasonic waves between the transducer and air, allowing new areas of application to become possible.
To demonstrate the suitability of the reflection technique, measurements are shown on the three samples Multiplex, LVL, and MDF and compared with transmission measurements. Due to this acoustic barrier and the use of cellular PP transducers, an exact detection of delamination and cavities is possible in wood panels up to 40 mm thick. If only one side of an object is accessible and the depth of the defect is of interest, the reflection technique is preferred at the expense of a reduced measuring accuracy and Penetration depth.
Components made of fibre-reinforced plastic are a prominently used material in modern safety-relevant structures. Periodic in-service non-destructive inspection of these structures is necesary. The EMRP-funded project VITCEA aims on the evaluation of the performance of various non-destructive testing methods on the inspection of fibre-reinforced plastics.
The physical layout of fibre layers leads to complex structures of fibre-reinforced plastic parts. Furthermore different material properties of the fibre and the resin cause anisotropic behaviour of the material.This poses a challenge for ultrasonic NDT by causing a complex acoustical response.
The acoustical behaviour of fibre-reinforced plate materials has been simulated. Specimens with artificial flaws for the evaluation of the detection thresholds have been designed and manufactured.
Mechanized ultrasonic testing methods using phased-array sensors, air-coupled transducers, immersion tank testing and contact technique have been evaluated on the specimen.
In this talk results of different ultrasonic testing methods will be compared and discussed.