Filtern
Dokumenttyp
- Zeitschriftenartikel (14) (entfernen)
Sprache
- Englisch (14)
Referierte Publikation
- ja (14)
Schlagworte
- Solid-state NMR (14) (entfernen)
Organisationseinheit der BAM
Methyl 4-O-methyl-?-Image-ribo-hex-3-ulopyranoside (2), a model compound for partially oxidized anhydroglucose units in cellulose, was crystallized from CHCl3/n-hexane by vapor diffusion to give colorless plates. Crystal structure determination revealed the monoclinic space group P21 with Z=2C8H14O6 and unit cell parameters of a=8.404(2), b=4.5716(10), c=13.916(3) Å, and ?=107.467(4)°. The structure was solved by direct methods and refined to R=0.0476 for 1655 reflections and 135 parameters. The hexulopyranoside occurs in a distorted chair conformation. Both hydroxyls are involved in hydrogen bonding and form zigzag bond chains along the b-axis. One of the two hydrogen bonds is bifurcated. The solid-state 13C NMR spectrum of 2 exhibits eight carbon resonances, with well-separated signals for the two methoxyls (1-OMe: 55.72 ppm, 4-OMe: 61.25 ppm) and a keto resonance with relatively large downfield shift (206.90 ppm). Differences in the C-4 and the methoxyls chemical shifts in the solid and liquid states were found
The incorporation of ions in the lattice of hydroxyapatite alters significantly its structure.
Particularly, if anions such as trigonal borate units are accommodated in the lattice severe
distortions must occur around the substitution site because of different geometric shape, electric
charge and anion size. Solid-state NMR has been used to investigate this problem in detail for a
hydroxyapatite sample synthesized by high temperature solid state reaction. The results clearly
verify the existence of network distortions. Indeed, only about 1/3 of the total phosphate content
forms crystalline hydroxyapatite (also found in XRD) whereas the residual amount is contained in
two different phosphate sites with 31P chemical shifts of 5.5 ppm and 2.3 ppm, but broad resonances
lines suggesting disorder. Furthermore, a novel proton signal at -0.6 ppm was found which is
directly associated with the borate incorporation. No specific correlation of the two structurally
different borate units with the two phosphate groups is found.
Thermal, thermo-oxidative and fire residues of high impact polystyrene/magnesium hydroxide/red phosphorus (HIPS/Mg(OH)2/Pr) are investigated by solid-state NMR and compared with the results for the binary subsystem Mg(OH)2/Pr. The influences of oxygen, nitrogen and temperature are discussed. For a thermal decomposition and pyrolysis during combustion, the main pyrolysis of HIPS takes place while the remaining residue is a rather intact polymer, with a major share of the embedded Pr still present. Subsequently, mainly amorphous phosphates and a slight amount of crystalline Mg3(PO4)2 and Mg2P2O7 are formed at the highest temperatures. Only with increasing mass loss does the remaining polystyrene structure decompose and graphitic structures occur. The influence of oxygen on the decomposition mechanism is most obvious for the binary system Mg(OH)2/Pr. Pr vanishes more rapidly and crystalline, oxygen-rich magnesium phosphates are formed. In HIPS/Mg(OH)2/Pr systems the polymer acts as a barrier to reaction by the embedded particles, so that major characteristics of an anaerobic decomposition are found. Significant amounts of phosphorus are retained in the condensed phase through a reaction of Pr with Mg(OH)2 to mostly amorphous phosphates. This formation of amorphous inorganic magnesium phosphates can act as an additional physical barrier. This study outlines some advanced approaches for controlling the condensed-phase mechanisms of phosphorus and underlines that solid-state NMR is a most powerful tool for investigating the organic and inorganic residues.
The influence of starting materials and synthesis route on the properties and the structure of cementitious sodium aluminosilicate gels is not fully understood, partly due their amorphous nature and the fact that they often contain residual reactants, which can make the results of single-pulse NMR spectroscopy applied to these materials difficult to interpret or ambiguous. To overcome some of these limitations, 29Si{27Al} TRAPDOR NMR as well as 27Al{29Si} and 27Al{1H} REDOR NMR spectroscopy were applied to materials synthesized by the one-part alkali-activation route from three different amorphous silica starting materials, including rice husk ash. The latter led to formation of a fully amorphous sodium aluminosilicate gel (geopolymer), while the materials produced from the other silicas contained amorphous phase and crystalline zeolites. Application of the double-resonance NMR methods allowed to identify hydrous alumina gel domains in the rice husk ash-based material as well as significantly differing amounts of residual silica in the three cured materials. Four-coordinated Al existed not only in the aluminosilicate gel framework but also in a water-rich chemical environment with only a small amount of Si in proximity, likely in the alumina gel or possibly present as extra-framework Al in the aluminosilicate gel. The results demonstrate how the employment of different silica starting materials determines the phase assemblage of one-part alkali-activated materials, which in turn influences their engineering properties such as the resistance against chemically/biologically aggressive media.
29Si{27Al} TRAPDOR MAS NMR was applied to two faujasite-type zeolites with Si/Al ratios of 1.3 (Na-X) and 2.7 (Na-Y). The aim of this test study is to show that different Q4(mAl) sites (m=4,3,2,1) can be distinguished by differently strong TRAPDOR effects (ΔS/S0). Indeed, it was found that the TRAPDOR effect depends on the number m of AlO4 units connected to the Q4 silicon tetrahedrons. For Na-X, the measured ΔS/S0 values are 1:0.81:0.56 for Q4(4Al), Q4(3Al) and Q4(2Al), respectively (normalized to Q4(4Al)). The corresponding ΔS/S0 values are the same for Na-Y within the error bars, although the silicon sites are different: Q4(3Al), Q4(2Al) and Q4(1Al) and now normalized to Q4(3Al) as no Q4(4Al) is present. Nevertheless, the proposed method opens up the possibility to distinguish overlapping 29Si NMR signals of the Qn(mAl) sites in amorphous materials as the main goal of these investigations.
Three methyl celluloses with completely uniform substitution pattern, 2-O-methyl cellulose (1), 3-O-methyl cellulose (2) and 6-O-methyl cellulose (3), were prepared according to the cationic ring opening polymerization approaches starting from substituted 1,2,4-orthopivalate derivatives of D-glucose. These samples allowed for the first time to sort out the methyl substitution effects on solid-state NMR chemical shifts and relaxation. Dipolar dephasing experiments allowed the detection and assignment (1H, 13C) of the methyl groups. In 1 and 2, these resonances overlapped with those of C-6, whereas in 3, the methyl signal experienced a low-field shift into the region of C-2,3,5. 13C T1 experiments were used to verify different relaxation behavior of the carbon sites, particularly the short relaxation time of at the carbon substitution site next to the methyl groups. This effect was used to unambiguously identify the 13C chemical shifts of the carbons carrying the methoxyl substituent, although they overlap with all resonances in the C-2,3,5 region. The data obtained for the standard samples with uniform substitution will now be used as the basis for determining methylation patterns and substitution degree in commercial methyl celluloses.
Solid state NMR spectroscopy was applied to determine the overall degree of substitution (DS) and the degrees of substitution at C-6 (DSC-6) and C-2/3 (DSC-2/3). Four commercial methyl cellulose samples were used, having a DS between 0.51 and 1.96 as determined by wet-chemical analysis. The strategy and optimization of the NMR data acquisition as well as the data evaluation procedures are explained in detail. Optimization of the approach mainly comprised (a) maximizing the signal by choice of NMR probe, MAS spinning frequency and B0 field, (b) minimizing the measurement time by a Torchia-type experiment and (c) suppressing probe background by rotor-synchronized echo detection. Data evaluation used simply the integration of three different spectral ranges in the 13C NMR spectrum. The results of the experiments were in good agreement with the wet-chemical data. The NMR approach takes about the same analysis time as the conventional hydrolysis/chromatography analysis. However, it is a generally applicable and simple alternative without need for an extended sample preparation which is most useful if wet-chemical/chromatographic analyses are undesired or unavailable. Further studies have to concentrate on the validation of the analytical method and application to a larger sample array.
Unilateral and solid-state nuclear magnetic resonance
(NMR) analyses were performed on a parchment
fragment of the Dead Sea Scroll (DSS). The analyzed
sample belongs to the collection of non-inscribed and
nontreated fragments of known archaeological provenance
from the John Rylands University Library in Manchester.
Therefore, it can be considered as original DSS material
free from any contamination related to the post-discovery
period. Considering the paramount significance of the DSS,
noninvasive approaches and portable in situ nondestructive
methods are of fundamental importance for the determination
of composition, structure, and chemicalphysical
properties of the materials under study. NMR studies
reveal low amounts of water content associated with
very short proton relaxation times, T1, indicating a high
level of deterioration of collagen molecules within scroll
fragments. In addition, 13C cross-polarization magicangle-
spinning (CPMAS) NMR spectroscopy shows characteristic
peaks of lipids whose presence we attribute to
the production technology that did not involve liming.
Extraction with chloroform led to the reduction of both
lipid and protein signals in the 13C CPMAS spectrum
indicating probable involvement of lipids in parchment
degradation processes. NMR absorption and relaxation
measurements provide nondestructive, discriminative, and
sensitive tools for studying the deterioration effects on the
organization and properties of water and collagen within
ancient manuscripts.
Synergistic multicomponent systems containing melamine poly(metal phosphate)s have been recently proposed as flame retardants. This work focuses on the decomposition pathways, molecular mechanisms and morphology of the fire residues of epoxy resin (EP) flame retarded with melamine poly(zinc phosphate) (MPZnP) to explain the modes of action and synergistic effects with selected synergists (melamine polyphosphate (MPP) and AlO(OH), respectively). The total load of flame retardants was always 20 wt.%. The decomposition pathways were investigated in detail via thermogravimetric Analysis coupled with Fourier transform infrared spectroscopy. The fire residues were investigated via elemental analysis und solid-state nuclear magnetic resonance spectroscopy. The morphology of intumescent fire residues was investigated via micro-computed tomography and scanning electron microscopy.
EP + (MPZnP + MPP) formed a highly voluminous residue that showed structural features of both EP + MPZnP and EP + MPP, resulting in a highly effective protection layer. EP + (MPZnP + AlO(OH)) preserved the entire quantity of phosphorus content during combustion due to the Formation of Zn₂P₂O₇ and AlPO₄.