TY - JOUR A1 - Schoknecht, Ute A1 - Tietje, O. A1 - Borho, N. A1 - Burkhardt, M. A1 - Rohr, M. A1 - Vollpracht, A. A1 - Weiler, L. T1 - Environmental impact of construction products on aquatic systems - Principles of an integrated source-path-target concept JF - Water N2 - Buildings exposed to water can release undesirable substances which, once transported to environmental compartments, may cause unwanted effects. These exposure pathways need to be investigated and included in risk assessments to safeguard water quality and promote the sustainability of construction materials. The applied materials, exposure conditions, distribution routes and resilience of receiving compartments vary considerably. This demonstrates the need for a consistent concept that integrates knowledge of emission sources, leaching processes, transport pathways, and effects on targets. Such a consistent concept can serve as the basis for environmental risk assessment for several scenarios using experimentally determined emissions. Typically, a source–path–target concept integrates data from standardized leaching tests and models to describe leaching processes, the distribution of substances in the environment and the occurrence of substances at different points of compliance. This article presents an integrated concept for assessing the environmental impact of construction products on aquatic systems and unravels currently existing gaps and necessary actions. This manuscript outlines a source–path–target concept applicable to a large variety of construction products. It is intended to highlight key elements of a holistic evaluation concept that could assist authorities in developing procedures for environmental risk assessments and mitigation measures and identifying knowledge gaps. KW - Construction products KW - Environmental impact KW - Assessment KW - Concept PY - 2022 UR - https://nbn-resolving.org/urn:nbn:de:kobv:b43-542175 DO - https://doi.org/10.3390/w14020228 SN - 2073-4441 VL - 14 IS - 2 SP - 1 EP - 19 PB - MDPI CY - Basel AN - OPUS4-54217 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - RPRT A1 - Gartiser, S. A1 - Heisterkamp, I. A1 - Schoknecht, Ute A1 - Burkhardt, M. A1 - Ratte, M. T1 - Empfehlungen für eine Testbatterie zur ökotoxikologischen Bewertung der Umweltverträglichkeit von Bauprodukten T2 - UBA-Texte N2 - Die Europäische Bauprodukteverordnung (EU) Nr. 305/2011 ermöglicht den Mitgliedstaaten Vorschriften zur Bewertung der Umweltauswirkungen ihrer Bauwerke zu erlassen. Ziel des Pro-jektes war es, Empfehlungen für eine Testbatterie zur ökotoxikologischen Bewertung der Um-weltverträglichkeit von Bauprodukten für die Außenanwendung zu erarbeiten, die zur Europä-ischen Harmonisierung von Prüfmethoden beitragen. Aus einer Auswahlliste von 39 Produkten wurden 20 Produkte in das ökotoxikologische Untersuchungsprogramm einbezogen. Monoli-thische und flächige Bauprodukte wurden in der horizontalen dynamischen Oberflächenaus-laugprüfung (DSL-Test) nach CEN/TS 16637-2, granulare Produkte im Schütteltest nach DIN EN 12457-1 eluiert. Die Eluate wurden in vier aquatischen Toxizitätstests (Algen, Daphnien, Leuchtbakterien, Fischeier), einem Gentoxizitätstest (umu-Test) und im Respirometertest (OECD 301 F) untersucht. Hierbei wurden niedrige bis sehr hohe Ökotoxizitäten (bis Verdün-nungsstufe 1536) bestimmt. Zudem wurde ein Europäischer Ringversuch mit 17 Teilnehmern und zwei Bauprodukten konzeptionell vorbereitet, durchgeführt und gemäß DIN ISO 5725 ausgewertet. Nach Ausschluss der nicht validen bzw. als Ausreißer identifizierten Biotests war die laborübergreifende Streuung des Gesamtverfahrens zur ökotoxikologischen Charakterisie-rung von Bauprodukten akzeptabel. Der Variationskoeffizient für die Konzentration, die einen 50%igen Effekt induziert (EC50) lag für die verschiedenen Tests und Bauprodukte zwischen 9 und 110% und beschreibt die Variabilität des gesamten, komplexen Verfahrensablaufs vom Elutionsprozess über Probenlagerung bis hin zur eigentlichen Biotestdurchführung. Es wurden Empfehlungen zur Planung und Durchführung von Ökotoxizitätstests zur Bewertung von Bau-produkten erarbeitet und bei der für die europäische Harmonisierung von Auslaugtests für Bauprodukte zuständigen CEN-Arbeitsgruppe eingereicht. KW - Freisetzung KW - Schadstoffe KW - Umweltbewertung KW - Ökotoxikologische Testverfahren KW - Bauprodukte PY - 2016 UR - http://www.umweltbundesamt.de/publikationen/empfehlungen-fur-eine-testbatterie-zur SN - 1862-4804 VL - 74/2016 SP - 1 EP - 161 CY - Dessau-Roßlau AN - OPUS4-38559 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Gartiser, S. A1 - Heisterkamp, I. A1 - Schoknecht, Ute A1 - Bandow, Nicole A1 - Burkhardt, M. A1 - Ratte, M. A1 - Ilvonen, O. T1 - Recommendation for a test battery for the ecotoxicological evaluation of the environmental safety of construction products JF - Chemosphere N2 - The European Construction Products Regulation allows Member States to adopt rules for evaluating the environmental impact of their buildings. The aim of the project was to develop recommendations for a test battery for the ecotoxicological assessment of the environmental impact of construction products for outdoor use and contribute to the European harmonization of test methods. From a shortlist of 39 products 20 products were included in the ecotoxicological testing program. Monolithic and plate-like construction products were eluted in the Dynamic Surface Leaching test (DSLT) in accordance with CEN/TS 16637-2, granular products were eluted in a one stage batch test in accordance with DIN EN 12457-1. The eluates were examined in four aquatic toxicity tests (algae, daphnia, luminescent bacteria, fish eggs), a genotoxicity test (umu test) and in the respirometer test (OECD 301 F). Here, low to very high ecotoxicity was observed (up to a dilution factor of 1536). Six out of 8 eluates, whose TOC exceeded 10 mg L⁻1 showed a good biodegradability above 75%. The intra-laboratory repeatability of the Lowest Ineffective Dilution (LID) usually was within ±1 dilution steps (ecotoxicity tests) and ±2 dilution steps (leaching and ecotoxicity tests). This is acceptable, when considering that the overall variability of sample preparation, leaching test, and bioassays add up. The conclusions lead to practical recommendations for a suitable combination of leaching and ecotoxicity tests. KW - Biodegradability KW - Construction products KW - Leaching tests KW - Exotoxicity PY - 2017 DO - https://doi.org/10.1016/j.chemosphere.2016.12.115 SN - 0045-6535 SN - 1879-1298 VL - 171 SP - 580 EP - 587 PB - Elsevier Ltd. AN - OPUS4-38861 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Gartiser, S. A1 - Heisterkamp, I. A1 - Schoknecht, Ute A1 - Burkhardt, M. A1 - Ratte, M. A1 - Ilvonen, O. A1 - Brauer, F. A1 - Brückmann, J. A1 - Dabrunz, A. A1 - Egeler, P. A1 - Eisl, A.-M. A1 - Feiler, U. A1 - Fritz, I. A1 - König, S. A1 - Lebertz, H. A1 - Pandard, P. A1 - Pötschke, G. A1 - Scheerbaum, D. A1 - Schreiber, F. A1 - Soldán, P. A1 - Weiß, R. A1 - Weltens, R. T1 - Results from a round robin test for the ecotoxicological evaluation of construction products using two leaching tests and an aquatic test battery JF - Chemosphere N2 - A European round robin test according to ISO 5725-2 was conceptually prepared, realised, and evaluated. The aim was to determine the inter-laboratory variability of the overall process for the ecotoxicological characterization of construction products in eluates and bioassays. To this end, two construction products BAM-G1 (granulate) and HSR-2 (roof sealing sheet), both made of EPDM polymers (rubber), were selected. The granular construction product was eluted in a one stage batch test, the planar product in the Dynamic Surface Leaching test (DSLT). A total of 17 laboratories from 5 countries participated in the round robin test: Germany (12), Austria (2), Belgium (1), Czech Republic (1) and France (1). A test battery of four standardised ecotoxicity tests with algae, daphnia, luminescent bacteria and zebrafish eggs was used. As toxicity measures, EC50 and LID values were calculated. All tests, except the fish egg test, were basically able to demonstrate toxic effects and the level of toxicity. The reproducibility of test results depended on the test specimens and the test organisms. Generally, the variability of the EC50 or LID values increased with the overall level of toxicity. For the very toxic BAM-G1 eluate a relative high variability of CV ¼ 73%e110% was observed for EC50 in all biotests, while for the less toxic HSR-2 eluate the reproducibility of EC50 varied with sensitivity: it was very good (CV ¼ 9.3%) for the daphnia test with the lowest sensitivity, followed by the algae test (CV ¼ 36.4%). The luminescent bacteria test, being the most sensitive bioassay for HSR-2 Eluate, showed the highest variability (CV ¼ 74.8%). When considering the complex overall process the reproducibility of bioassays with eluates from construction products was acceptable. KW - Round robin test KW - Construction products KW - Leaching tests KW - Eluates KW - Ecotoxicity tests PY - 2017 DO - https://doi.org/10.1016/j.chemosphere.2017.01.146 SN - 0045-6535 SN - 1879-1298 VL - 175 SP - 138 EP - 146 PB - Elsevier Ltd. AN - OPUS4-39174 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - RPRT A1 - Tietje, O. A1 - Burkhardt, M. A1 - Rohr, M. A1 - Borho, N. A1 - Schoknecht, Ute T1 - Emissions- und Übertragungsfunktionen für die Modellierung der Auslaugung von Bauprodukten T2 - UBA Texte N2 - Auslaugung von Stoffen aus Bauteilen kann zu einer Belastung von Boden und Gewässern führen. Das Simulationsmodell COMLEAM (COnstruction Material LEAching Model) wurde eingesetzt, um die Stoffauswaschung besser zu verstehen und das damit verbundene Umweltrisiko besser einschätzen zu können. Emissionsfunktionen sind Bestandteil dieses Modells. Hier werden fünf verschiedenen Funktionen beschrieben, getestet und hinsichtlich ihrer Eignung für Prognosemodelle bewertet. KW - Emissionsfunktionen KW - Auswaschverlauf KW - Bauprodukt KW - Biozid KW - Modellierung PY - 2018 SN - 1862-4359 VL - 28 SP - 1 EP - 57 CY - Dessau-Roßlau AN - OPUS4-44735 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -