TY - CONF A1 - von Werder, Julia T1 - Gebäudebegrünung mit Biofilmen: Herausforderungen und Chancen N2 - Der Vortrag stellt die Ergebnisse der Forschungsarbeiten zur Biorezeptivität von Betonfassaden sowie der gezielten Applikation von Algen dominierten Biofilmen auf Betonfassaden vor. Insbesondere werden die Anforderungen an eine repräsentative Prüfmethode erläutert. T2 - BuGG-Tag der Forschung und Lehre Gebäudegrün 2024 CY - Leipzig, Germany DA - 26.09.2024 KW - Begrünung KW - Biorezeptivität KW - Beton KW - Biofilm PY - 2024 AN - OPUS4-62221 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - von Werder, Julia A1 - Simon, Sebastian A1 - Meng, Birgit ED - Gemrich, J. T1 - Hydrothermal Treatment of Ultra-High-Performance Concrete: Mechanical Properties and Phase Composition N2 - The advantages of treating prefabricated components made of Ultra-High-Performance Concrete (UCPC) at 90 °C are largely recognized, while hydrothermal treatment at 185 °C and the corresponding saturation pressure of 1.1 MPa, in contrast, is not applied in building practice so far and was studied only by a few researchers. In the research presented, the parameters pre-storage-time before treatment and dwell time in the autoclave were systematically varied. The results illustrate in which way compressive strength increases with the duration of treatment. Already samples which were only heated up and immediately cooled down show an increase in strength compared to the 28-day reference of about 10 %. After 20 h the maximum increase of about 25 % is reached. Interestingly the compressive strength of samples treated very long hardly decreases. It can be therefore concluded that for the composition investigated the achievable mechanical strength is not severely sensitive regarding the duration of the treatment. Also, pre-storage times before autoclaving longer than 0.5 days showed no significant impact on strength development. The phase composition measured by XRD exhibits significant changes compared to the reference. The amount of ettringite and portlandite have vanished, the cement clinker phases are substantially decreased and hydroxylellestadite and hydrogarnet are formed as new phases. The increase in strength can be assigned to an improved pozzolanic and hydraulic reaction. Contradictory to literature, there was found no tobermorite, a mineral which is known to be susceptible for disintegration at Long autoclaving duration. This explains why no significant strength loss appeared. T2 - 15th International Congress on the Chemistry of Cement CY - Prague, Czech Republik DA - 16.09.2019 KW - Hydrothermal treatment KW - UHPC KW - Phase composition KW - Mechanical strength PY - 2019 SN - 2523-935X SP - 1 EP - 11 AN - OPUS4-49481 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - von Werder, Julia A1 - Gardei, André A1 - Meng, Birgit ED - Caprai, V. ED - Brouwers, H. J. H. T1 - Functionalization of fibres for cement-based materials - selected test methods N2 - The low tensile strength of cement-based materials can be improved by the addition of fibres. In a joint research project, an industrial partner designed special coatings for polymer and carbon fibres by integrating surfactants and hydrophilic compounds. Aim of the developed functionalization was to ensure an even coverage of the fibre surfaces and to anchor them chemically in the cement-based matrix. Task of the BAM was to quantify the effect of the improved bond. In a first step a workable mortar adjusted to the strength of the tested fibres was developed and the fibre distribution assessed by light microscopy and computed tomography. To test the new coating for its efficiency to prevent cracking during hardening and to improve the loadbearing behaviour new test setups were developed or existing methods were adjusted. The experiments showed that the functionalization leads to a reduction of the crack area measured after the exposure of the wet mortar to strong drying conditions in the wind channel. Regarding the Efficiency to mitigate shrinkage cracks the functionalisation turned out to be more efficient for fibres made from polyacrylonitrile (PAN) than for carbon fibres. An improvement of the tensile strength after cracking of the cementitious matrix could only be documented for the coated carbon fibres. It could be quantified, however, only in the three-point bending tests because the fibres turned out to be too brittle for the applied single fibre pull-through test. T2 - 2nd International Conference on Sustainable Building Materials CY - Eindhoven, Netherlands DA - 12.08.2019 KW - Fibres KW - Functionalization KW - Mortar KW - Computed tomography KW - Shrinkage PY - 2019 VL - 5 SP - 16 EP - 25 AN - OPUS4-49480 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Cook, Jake A1 - von Werder, Julia T1 - Bioreceptive Concrete Surfaces: Understanding Material-Biology Interactions for Façade Greening N2 - The climate crisis has led to a growing demand for environmentally oriented approaches in the construction industry, including not only eco-friendly materials, but also the greening of urban spaces. Microbial facade greening with algae is a novel concept based on the inherent bioreceptive properties of different building materials. This study focuses on the influence of physical material properties on biofilm formation. Differently textured samples from the same UHPC mix were produced and their roughness and water absorption documented. The samples were then weathered under laboratory conditions to observe material-algae interactions. T2 - 11. Jahrestagung des DAfStb mit 63. Forschungskolloquium der BAM Green Intelligent Building CY - Berlin, Germany DA - 16.10.2024 KW - Bioreceptive concrete surface KW - Facede Greening KW - Adhesion strength experiment PY - 2024 AN - OPUS4-61811 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Schmidt, Wolfram A1 - Rübner, Katrin A1 - Schneider, Joachim A1 - von Werder, Julia A1 - Gluth, Gregor T1 - 63. DAfStb-Forschungskolloquium in der BAM - Themenblock 2: Nachhaltigkeitspotentiale N2 - Die Bauindustrie ist für rd. 40 % des weltweiten Energieverbrauchs und der Kohlenstoffemissionen verantwortlich. Mit der technologischen Entwicklung wird der Energiebedarf in Zukunft sinken, während sich das Problem grauer Emission verschärft. Daher ist ein verantwortungsvoller Umgang mit Ressourcen der Schlüssel zur Erreichung der Pariser Klimaziele. Der Einsatz klimaschonender Baustoffe weist dabei ein erhebliches Nachhaltigkeitspotential auf. Recycling, Rückgewinnung, Ressourcenschonung und Kreislaufwirtschaft können zu unersetzlichen Bestandteilen der Bautechnik werden. Im Folgenden werden einige Möglichkeiten vorgestellt, die bei der Dekarbonisierung der Bautechnik zukünftig hohe Potentiale aufweisen. Diese wurden beim 63. Forschungskolloquium des DAfStb an der BAM vorgestellt und Details können dem Tagungsband (DOI 10.26272/opus4-61338) entnommen werden. T2 - 11. Jahrestagung des DAfStb mit 63. Forschungskolloquium der BAM Green Intelligent Building CY - Berlin, Germany DA - 16.10.2024 KW - Bindemittel KW - Klimaschonende Baustoffe KW - Dekarbonisierung PY - 2025 SN - 0005-9846 VL - 75 IS - 4 SP - 131 EP - 134 PB - concrete content UG CY - Schermbeck AN - OPUS4-63068 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Hüsken, Götz A1 - Strangfeld, Christoph A1 - Robens-Radermacher, Annika A1 - von Werder, Julia A1 - Weigel, Sandra A1 - Mezhov, Alexander T1 - 63. DAfStb-Forschungskolloquium in der BAM - Themenblock 3: Innovative Technologien N2 - Innovationen sind der Treiber des technologischen Fortschritts. Durch die Anwendung innovativer Technologien, Produktionsverfahren und neuer Materialien können Effizienzsteigerungen erzielt werden, die sowohl zu einer Kosten- als auch Materialreduzierung führen können. Gerade vor dem Hintergrund einer nachhaltigen Entwicklung sind Innovationen der Schlüssel zu einem verantwortungsvollen Umgang mit Ressourcen und Rohstoffen. Im Rahmen des 63. DAfStb-Forschungskolloquiums (Tagungsband: DOI 10.26272/opus4-61338) an der BAM wurden innovative Ansätze im Bereich effizienter Fertigungstechnologien und neuer Materialien vorgestellt, die nachfolgend kurz zusammengefasst werden. T2 - 11. Jahrestagung des DAfStb mit 63. Forschungskolloquium der BAM Green Intelligent Building CY - Berlin, Germany DA - 16.10.2024 KW - Additive Fertigung KW - Biorezeptive Oberflächen KW - Biopolymere PY - 2025 SN - 0005-9846 VL - 75 IS - 4 SP - 134 EP - 135 PB - concrete content UG CY - Schermbeck AN - OPUS4-63069 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Stohl, Leonie A1 - Manninger, Tanja A1 - Dehn, Frank A1 - von Werder, Julia T1 - Understanding bioreceptivity of concrete: material design and characterization N2 - The climate crisis is driving an increasing demand for ecologically oriented concepts. In the building sector, this demand includes not only the use of environmentally friendly materials but also the greening of urban areas. One promising approach is the development of bioreceptive concrete façades, which support the growth of green biofilms directly on their surfaces. These innovative façades are anticipated to deliver benefits comparable to those of macroscopically greened façades, such as enhanced biodiversity and improved air quality, while offering the advantages of being more self-sustaining and stable systems once fully established. However, the development of bioreceptive concrete presents substantial challenges. Due to the interdisciplinarity and novelty of this field, standardized methods for material characterization and bioreceptivity assessment are currently lacking. This study proposes an approach for evaluating surface properties crucial for bioreceptivity, developed on differently structured samples of ultra-high-performance concrete (UHPC). Existing methods and standards from concrete technology are critically reviewed and, where necessary, modified to meet the unique requirements of measuring bioreceptive material properties. Special attention is given to the surface pH value and water retention characteristics, as these are essential for promoting microbial growth and ensuring the long-term stability of green biofilms. The observed surface characteristics vary according to the imprinted surface structures, offering a spectrum of material properties and enabling the evaluation of their impact on bioreceptivity. The findings presented form the foundation for subsequent laboratory weathering experiments, which will be discussed in a complementary publication. KW - Bioreceptivity KW - Concrete KW - Biofilm PY - 2025 UR - https://nbn-resolving.org/urn:nbn:de:kobv:b43-648180 DO - https://doi.org/10.1617/s11527-025-02863-y SN - 1359-5997 VL - 58 IS - 10 SP - 1 EP - 12 PB - Springer Science and Business Media LLC AN - OPUS4-64818 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - von Werder, Julia T1 - Biorezeptivität und Optimierung von Lehmbaustoffen - Forschung an der BAM N2 - Der Vortrag fasst die Forschungsaktivitäten der BAM in den Themengebieten Biorezeptivität von Beton und Optimierung von Lehmbaustoffen zusammen. Er diente als Kurzpräsentation für eine anschließende Podiumsdiskussion. T2 - Transformationsdialog "Material als Motor" CY - Berlin, Germany DA - 10.10.2024 KW - Biorezeptivität KW - Beton KW - Lehmbaustoffe PY - 2024 AN - OPUS4-62220 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - von Werder, Julia T1 - Living Concrete Walls: Engineering Bioreceptivity and Biofilms N2 - Building envelopes are a natural habitat of subaerial biofilms and can be more or less prone to be colonized (i.e. to be bioreceptive). Focusing on the added value of biofilms on manmade substrates represents new aesthetic frontiers and reduces the use of biocides. Moreover, the metabolic processes of photosynthetic biofilms can positively influence human health and life quality in densely populated cities by converting or absorbing pollutants. In the presented research the bioreceptivity of concrete claddings for building facades is engineered to sustain either natural or artificial establishment of microalgae-dominated biofilms. To be able to differentiate between the intrinsic material properties and the climatic boundary conditions, the experimental design in the first step comprised different analyses with model mono- and multi-species biofilms in sterile conditions and a high control of the environmental parameters. Growth and vitality of the algal component of the biofilms has been assessed with Pulse-amplitude modulation (PAM) fluorometry. T2 - 78th RILEM Annual Week & RILEM International Conference on Sustainable Materials & Structures: Meeting the major challenges of the 21st century - SMS 2024 CY - Toulouse, France DA - 25.08.2024 KW - Bioreceptivity KW - Biofilm KW - Weathering KW - Concrete KW - PAM fluorometry KW - Carbonation PY - 2024 AN - OPUS4-62224 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -