TY - GEN A1 - Krause, Martin A1 - Gräfe, Boris A1 - Mielentz, Frank A1 - Milmann, Boris A1 - Streicher, Doreen ED - Christian U. Grosse, T1 - New possibilities for ultrasonic imaging of concrete elements KW - Beton KW - Zerstörungsfreie Prüfung im Bauwesen (ZfPBau) KW - Ultraschallecho-Verfahren KW - Luftgekoppelter Ultraschall KW - Phased array PY - 2007 SN - 978-3-540-72447-6 SP - 575 EP - 582 PB - Springer CY - Heidelberg AN - OPUS4-19107 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Krause, Martin A1 - Gräfe, Boris A1 - Mielentz, Frank A1 - Milmann, Boris A1 - Friese, Martin A1 - Wiggenhauser, Herbert A1 - Mayer, K. ED - M.G. Alexander, ED - H.-D. Beushausen, ED - F. Dehn, ED - P. Moyo, T1 - Ultrasonic imaging of post-tensioned concrete elements: New techniques for reliable localization of grouting defects T2 - 2nd International Conference on Concrete Repair, Rehabilitation and Retrofitting CY - Cape Town, South Africa DA - 2008-11-24 KW - Post-tensioned concrete KW - Ultrasonic echo KW - Phase evaluation KW - Air-coupled ultrasound PY - 2009 SN - 978-0-415-46850-3 SP - 521 EP - 527 PB - CRC Press CY - Boca Raton AN - OPUS4-20651 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Wiggenhauser, Herbert A1 - Krause, Martin A1 - Maierhofer, Christiane A1 - Algernon, Daniel A1 - Gardei, André A1 - Gräfe, Boris A1 - Kohl, Christoph A1 - Lausch, Regine A1 - Mielentz, Frank A1 - Milmann, Boris A1 - Streicher, Doreen A1 - Zacher, Gerhard T1 - Grundlagen kombinierter zerstörungsfreier Prüfverfahren zur Untersuchung von Betonbauteilen T2 - Forschergruppe 384 Abschlusskolloquium CY - Bergisch Gladbach, Deutschland DA - 2007-05-03 PY - 2007 SP - 23 EP - 44 PB - BAM CY - Berlin AN - OPUS4-14805 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Mielentz, Frank A1 - Milmann, Boris A1 - Krause, Martin A1 - Wiggenhauser, Herbert T1 - Praxiseinsatz eines Ultraschall-Verfahrens zur Strukturuntersuchung von Betonbauteilen N2 - Einsatzbereiche des Meßsystems: - Ortung von Strukturelementen oder Verdichtungsmängeln in Beton - Dickenbestimmung von Bauteilen bei einseitiger Zugänglichkeit - Messung des Haftverbundes bei mehrschichtigen Bauteilen Auswerteverfahren: - Prinzip der laufzeitkorrigierten Überlagerung Vorteile: - Automatischer Meßablauf durch Array-Technik - Flexibler Einsatz durch lange Kabelverbindungen zwischen Prüfkopfarray und Meßapparatur T2 - Fachtagung Bauwerksdiagnose - Praktische Anwendungen Zerstörungsfreier Prüfungen CY - Munich, Germany DA - 21.01.1999 KW - Dickenmessung KW - Sohlplatte KW - Leerrohre PY - 1999 AN - OPUS4-36521 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Helmerich, Rosemarie A1 - Milmann, Boris A1 - Wöstmann, Jens T1 - Bond durability of CFRP-laminates on concrete bridges N2 - Trans-European corridors for transport of people and goods require strengthening of bridges to carry increased axle loads in terms of absolute axle loads and of their frequency. Most of the bridges along highways are reinforced or prestressed concrete bridges. Since the late 1990s, CFRP laminates have been applied to box girder and T-beam bridges to increase the overall capacity. Although regular inspections are carried out, no special method was available to test the bond condition of CFRP laminates after being in Service for more than ten years. The German Center of Competence in Civil Engineering is aware of this need and funded a research project to investigate the bond condition by means of advanced non-destructive testing (NDT). T2 - 31st Danubia-Adria Symposium on advances in experimental mechanics CY - Kempten, Germany DA - 24.09.2014 KW - Concrete bridges KW - Strengthening KW - Non-destructive testing KW - CFRP KW - Durability KW - Inspection PY - 2014 SN - 978-3-00-046740-0 SP - 1 EP - 2 AN - OPUS4-33116 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Wolf, Julia A1 - Mielentz, Frank A1 - Milmann, Boris A1 - Helmerich, Rosemarie A1 - Köpp, Christian A1 - Wiggenhauser, Herbert A1 - Kurz, J.H. A1 - Moryson, R.M. A1 - Samokrutov, A. A1 - Alekhin, S. G. A1 - Alver, Ninel A1 - Sazak, H.Ö. T1 - An ultrasound monitoring system for concrete structures N2 - The research project "Ultrasonic Net for Concrete Monitoring (UNeCOM)" aims at developing a methodology for an embedded ultrasonic network for the condition assessment of infrastructure constructions. Civil engineering structures made of concrete, which are located in tectonically active regions or undergo special loading conditions, may require continuous monitoring. It is important to assess the condition of the building and its stability to recognise and classify the effect of a seismic event or evolving damage at early stages before failure occurs. Embedded ultrasonic sensors offer the possibility to detect changes in the material and degradation mechanisms from inside the structure in areas which are difficult or impossible to inspect otherwise. In contrast to conventional ultrasonic testing methods, where the concrete surfaces are scanned with ultrasound probes, this new approach uses sensors, which are embedded into concrete, eliminating the effect of variable coupling conditions between sensors and concrete. This method allows an integral detection of changes in the concrete structure, for example due to seismic activities, to detect mechanical impacts, as well as degradation of the material due to overloading. Such methods have great relevance especially for the monitoring of constructions like power plants, bridges, offshore structures and other structures with high technical safety requirements. The sensor network can be controlled remotely through the internet which is also being used for data transfer. The embedded sensor network is designed to monitor structural damage and concrete degradation globally with high sensitivity. T2 - Istanbul bridge conference 2014 CY - Istanbul, Turkey DA - 11.08.2014 KW - Ultrasound KW - Concrete KW - Monitoring PY - 2014 SN - 978-605-64131-6-2 SP - Paper 32, 1 EP - 9 AN - OPUS4-32028 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Helmerich, Rosemarie A1 - Milmann, Boris A1 - Wöstmann, Jens T1 - Non-destructive detection of surface-bond defects in carbon composite-strengthened concrete structures N2 - For almost 15 years, carbon fibre-reinforced polymer (CFRP) plates and sheets have been used for strengthening and repair of civil engineering structures. CFRP plates were applied to upgrade structures for change in use or increasing traffic load. CFRP laminates have also been used to repair deteriorated structures such as multi-storey parking or bridges. The execution quality and condition of the strengthening measure in terms of bond integrity were neither monitored nor tested systematically. Inspectors eventually applied simple hammer knocking during regular main inspection for subjective noise distinction as a measure for eventual insufficient bond. This paper presents the feasibility and the limitations of low-frequency transversal ultrasonic waves with dry-coupling point-contact sensors for inspection and defect detection between CFRP laminate and concrete surfaces. The German Centre of Competence in Civil Engineering (DIBt) has initiated a national research project [Helmerich et al. (2012). Condition analysis of bonded CFRP-applications on concrete structures by means of non-destructive testing [in German: Zustandsuntersuchung von CFK-Klebeverstärkungen an Betonbauteilen mittels zerstörungsfreier Prüfung (ZfP)]. Final, internal project report], carried out at the Federal Institute for Materials Research and Testing (BAM), Germany. The aim of the project was to present a potential non-destructive testing method for bond defect detection as a measure for the durability of the strengthening system more than 10 years after application. KW - Concrete bridges KW - Strengthening KW - Non-destructive testing KW - Composite materials KW - Durability KW - Inspection PY - 2015 DO - https://doi.org/10.1080/15732479.2013.879322 SN - 1573-2479 VL - 11 IS - 1 SP - 3 EP - 14 PB - Taylor & Francis CY - London [u.a.] AN - OPUS4-33086 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - RPRT A1 - Krause, Martin A1 - Mayer, K. A1 - Ballier, G. A1 - Borchardt, Kerstin A1 - Chinta, P.K. A1 - Effner, Ute A1 - Milmann, Boris A1 - Müller, Sabine A1 - Nowak, Thomas Rudolf T1 - Hochgenaue Strukturerkennung von Holzbauteilen mit 3D-Ultraschall N2 - Inhalt ist die zerstörungsfreie Detailuntersuchung von Holzbauteilen mit einem dreidimensional abbildenden Ultraschall-Echoverfahren. Das neu entwickelte 3D-Verfahren berücksichtigt den anisotropen Aufbau des Holzes. Die Bildschnitte und Projektionen werden aus flächigen Ultraschallaufnahmen berechnet. Die Messungen erfolgen an Probekörpern sowie an Bauteilen aus der Praxis. In dem Forschungsvorhaben wird die für Holz neue 3D-Rekonstruktionsrechnung verwendet und mit dem Ziel weiterentwickelt, unter Berücksichtigung der anisotropen Struktur des Holzes eine dreidimensional aufgelöste Abbildung von Reflektoren im Inneren der Holzbauteile zu ermöglichen. Damit werden die bisher für Holzbauteile zur Verfügung stehenden Verfahren entscheidend ergänzt, weil nun eine hochgenaue dreidimensionale Abbildung erreichbar ist (Auflösung: 20 mm und besser). KW - Ultraschallecho-Verfahren KW - Holzbauteile KW - Abbildungsverfahren KW - Imaging PY - 2014 UR - https://www.irb.fraunhofer.de/bauforschung/baufolit/projekt/Hochgenaue-Strukturerkennung-von-Holzbauteilen-mit-3D-Ultraschall/20138035979 SN - 978-3-8167-9212-3 VL - 109 SP - 1 EP - 101 PB - Fraunhofer IRB Verl. CY - Stuttgart AN - OPUS4-32852 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Krause, Martin A1 - Mauke, R. A1 - Effner, Ute A1 - Milmann, Boris A1 - Völker, Christoph A1 - Wiggenhauser, Herbert T1 - Ultrasonic testing of a sealing construction made of salt concrete in an underground disposal facility for radioactive waste T2 - NDT-CE 2015 - International symposium non-destructive testing in civil engineering CY - Berlin, Germany DA - 2015-09-15 KW - Ultrasonic reflection measurement KW - Dry contact transducers in boreholes KW - Interface salt-concrete / rock salt KW - Ultrasonic imaging of internal reflectors PY - 2015 SN - 1435-4934 SP - 696 EP - 699 AN - OPUS4-34537 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Mayer, K. A1 - Milmann, Boris A1 - Krause, Martin A1 - Mielentz, Frank T1 - Methode zum Nachweis von Verpressfehlern in Spannbeton durch Phasenauswertung bei Ultraschallecho-Verfahren KW - Ultraschall-Echo-Verfahren KW - Verpressfehler KW - Spannbeton KW - Hüllrohr KW - Brücken PY - 2008 SN - 1616-069X SN - 0948-5112 VL - 112 IS - 12 SP - 37 EP - 40 PB - Deutsche Gesellschaft für Zerstörungsfreie Prüfung CY - Berlin AN - OPUS4-18685 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Milmann, Boris T1 - Ultraschallecho-Verfahren für Spannbeton: Signifikanter Nachweis von Verpressfehlern mit Phasenauswertung T2 - Fachtagung Bauwerksdiagnose 2008, Praktische Anwendungen Zerstörungsfreier Prüfungen und Zukunftsaufgaben CY - Berlin, Germany DA - 2008-02-21 PY - 2008 AN - OPUS4-18067 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -