TY - JOUR A1 - Holländer, Lars A1 - Grunewald, Thomas A1 - Grätz, Rainer T1 - Ignition probability of fuel gas-air mixtures due to mechanical impacts between stainless steel components N2 - The ignition probability of gaseous mixtures of acetylene, hydrogen and ethylene with air due to mechanical impacts between stainless steel components was examined for various impact energies. Additionally, the sources of ignitions were identified by infrared high-speed recordings. The stainless steel types used had different chemical compositions in order to investigate the influence of the chromium content on the ignition probability. The investigations reveal different ignition probabilities of the gas mixtures as well as different sources of ignitions depending on the steel type used and the impact energy applied. Impact energies below 126 J resulted in ignition of the gaseous mixture at the hot surfaces of the pin or the plate in most of the cases. At higher energies, initiation of ignition due to abraded particles was more probable when using stainless steel components with lower chromium content whereas the source of ignition was almost exclusively limited to the hot surfaces of pin and plate for the steel with the highest chromium content. However, as opposed to the source of ignition, the probability of ignition could not be correlated to the chromium content of the stainless steel. KW - Explosive atmosphere KW - Ignition probability KW - Mechanical impact KW - Stainless steel PY - 2014 DO - https://doi.org/10.1016/j.jlp.2014.10.009 SN - 0950-4230 SN - 1873-3352 VL - 32 SP - 393 EP - 398 PB - Butterworth CY - Guildford, Surrey AN - OPUS4-31845 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Holländer, Lars A1 - Grunewald, Thomas A1 - Grätz, Rainer T1 - Ist Edelstahl funkenärmer als unlegierter Stahl? - Untersuchungen zur Wahrscheinlichkeit der Zündung explosionsfähiger Atmosphären durch Schlagvorgänge bei der Verwendung von Edelstahl N2 - Die Konformitätsbewertung als Voraussetzung für das Inverkehrbringen von Geräten, die in den Geltungsbereich der Europäischen Richtlinie 94/9/EG fallen, bedarf einer Zündgefahrenbewertung, die auch die Gefahren durch 'mechanisch erzeugte Funken' berücksichtigen muss. In einem Forschungsvorhaben wurden in diesem Zusammenhang die von Edelstahlschlagfunken ausgehenden Zündgefahren untersucht. KW - Mechanisch erzeugte Funken KW - Schlagfunken KW - Edelstahl KW - Edelstahl-Schlagfunken KW - Edelstahl-Funken PY - 2014 SN - 2191-0073 VL - 4 IS - 11/12 SP - 32 EP - 35 PB - Springer-VDI-Verl. CY - Düsseldorf AN - OPUS4-32142 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Holländer, Lars A1 - Grunewald, Thomas A1 - Grätz, Rainer T1 - Influence of material properties of stainless steel on the ignition probability of flammable gas mixtures due to mechanical impacts N2 - Grazing impact experiments of various types of stainless steels were performed in explosive atmospheres of hydrogen, acetylene, ethylene or propane with air. Depending on the gas mixture, kinetic energy of the impact, and applied stainless steel, the dominant ignition sources are either separated particles or hot friction surfaces. An influence of chromium content on the ignition probability was not found, although an increase in chromium content results in a reduction of the oxidizability of separated particles. Additionally, the influence of the material properties thermal conductivity, specific heat, density and hardness on the ignition probability of the hydrogen–air mixture was investigated. With increasing thermal conductivity a decreasing rate of ignitions was observed. In contrast, an influence of the physical properties specific heat, density and hardness on the ignitability was not found. T2 - 15th International Symposium on Loss Prevention and Safety Promotion in the Process Industries CY - Freiburg, Germany DA - 05.06.2016 KW - Explosion protection KW - Mechanical generated sparks KW - Ignition protection KW - Non-electrical equipment KW - Ignition hazard assessment PY - 2016 DO - https://doi.org/10.3303/CET1648052 SN - 2283-9216 SN - 1974-9791 VL - 48 SP - 307 EP - 312 PB - AIDIC The Italian Association of Chemical Engineering AN - OPUS4-37456 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - RPRT A1 - Grunewald, Thomas A1 - Grätz, Rainer A1 - Holländer, Lars T1 - Entwicklung normativer Anforderungen an explosionsgeschützte nichtelektrische Geräte resultierend aus der Zündfähigkeit mechanisch erzeugter Schlagfunken (NAMES) N2 - Die Ergebnisse des Forschungsprojektes zeigen, dass Schlagvorgänge mit Edelstählen eine erhebliche Zündgefahr von explosionsfähigen Brenngasgemischen darstellen können. Dabei bestehen jedoch mitunter deutliche Unterschiede zwischen den verschiedenen Brenngasgemischen. Besonders hohe Zündwahrscheinlichkeiten konnten bei Brenngasgemischen mit Brenngasen der IEC-Explosionsgruppe IIC beobachtet werden, die Acetylen bzw. Wasserstoff als Brenngas enthielten. Schläge im Wasserstoff/Luft-Gemisch waren dabei jedoch bedeutend zündwirksamer. In diesem Gasgemisch konnte bei nied-rigen maximalen Schlagenergien bis 60 J sogar eine mitunter höhere relative Zündhäufigkeit beobachtet werden als bei Versuchen mit unlegiertem Baustahl. KW - Funken KW - Mechanisch erzeugte Funken KW - Schlagfunken KW - Reibfunken KW - Mechanische Funken KW - Mechanische Geräte KW - Explosionsschutz KW - ATEX KW - Nichtelektrische Geräte PY - 2015 UR - https://www.tib.eu/de/suchen/id/TIBKAT%3A877987866/Entwicklung-normativer-Anforderungen-an-explosionsgesch%C3%BCtzte/?tx_tibsearch_search%5Bsearchspace%5D=tn SP - 1 EP - 38 AN - OPUS4-38581 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -