TY - CONF A1 - Vogl, Jochen A1 - Klingbeil, Patrick A1 - Pritzkow, Wolfgang A1 - Riebe, Gundel T1 - Reference Measurements by Multi-Collector ICP-IDMS T2 - 10th Beijing Conference and Exhibition on Instrumental Analysis CY - Beijing, China DA - 2003-10-13 PY - 2003 AN - OPUS4-3799 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Ostermann, Markus A1 - Kettisch, P. A1 - Becker, Dorit A1 - Vogl, Jochen T1 - Measurements of sulfur in oil using pressurised wet digestion technique in open vessels and isotope dilution mass spectrometry KW - Wet digestion KW - Open vessel digestion KW - Sulfur in oil KW - Reference materials KW - TIMS KW - IDMS PY - 2003 UR - http://www.springerlink.com/content/b7alk8lgly2v/?p=6237db8a9c28481d87e7b017e6474b73&pi=88 SN - 1618-2642 SN - 1618-2650 VL - 377 IS - 4 SP - 779 EP - 783 PB - Springer CY - Berlin AN - OPUS4-2738 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Vogl, Jochen A1 - Pritzkow, Wolfgang A1 - Klingbeil, Patrick T1 - Isotope ratio measurements with Multi-Collector-ICP-MS using collision cell technology T2 - Seminar on food analysis CY - Beijing, China DA - 2005-10-28 PY - 2005 AN - OPUS4-11652 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Vogl, Jochen A1 - Klingbeil, Patrick A1 - Pritzkow, Wolfgang A1 - Riebe, Gundel T1 - Comparative studies between ID-ICP-MS and ID-TIMS T2 - Seminar on food analysis CY - Beijing, China DA - 2005-10-28 PY - 2005 AN - OPUS4-11654 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Vogl, Jochen T1 - Isotope dilution mass spectrometry - Introduction and basic principles T2 - Seminar on food analysis CY - Beijing, China DA - 2005-10-28 PY - 2005 AN - OPUS4-11656 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Vogl, Jochen T1 - Advances in isotope ratio mass spectrometry and required isotope reference materials N2 - The article gives a condensed version of the keynote lecture held at the International Mass Spectrometry Conference 2012 in Kyoto. Starting with some examples for isotope research the key requirements for metrologically valid procedures enabling traceable and comparable isotope data are discussed. Of course multi-collector mass spectrometers are required which offer sufficiently high isotope ratio precision for the intended research work. Following this, corrections for mass fractionation/discrimination, validation of the analytical procedure including chemical sample preparation and complete uncertainty budgets are the most important issues for obtaining a metrologically valid procedure for isotope ratio determination. Only the application of such metrologically valid procedures enables the generation of traceable and comparable isotope data. To realize this suitable isotope and/or δ-reference materials are required, which currently are not sufficiently available for most isotope systems. Boron is given as an example, for which the situation regarding isotope and δ-reference materials is excellent. Boron may therefore serve as prototype for other isotope systems. KW - Isotope reference materials KW - Delta reference materials KW - Traceability KW - Comparability KW - Measurement uncertainty KW - Synthetic isotope mixtures KW - Mass fractionation KW - Mass discrimination PY - 2013 DO - https://doi.org/10.5702/massspectrometry.S0020 SN - 2187-137X SN - 2186-5116 VL - 2 IS - 50020 SP - 1 EP - 7 AN - OPUS4-28562 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Vogl, Jochen A1 - Rosner, Martin T1 - Production and certification of a unique set of isotope and delta reference materials for Boron isotope determination in geochemical, environmental and industrial materials N2 - Isotopic reference materials are essential to enable reliable and comparable isotope data. In the case of boron only a very limited number of such materials is available, thus preventing adequate quality control of measurement results and validation of analytical procedures. To address this situation a unique set of two boron isotope reference materials (ERM-AE102a and -AE104a) and three offset δ11B reference materials (ERM-AE120, -AE121 and -AE122) were produced and certified. The present article describes the production and certification procedure in detail. The isotopic composition of all the materials was adjusted by mixing boron parent solutions enriched in 10B or 11B with a boron parent solution having a natural isotopic composition under full gravimetric control. All parent solutions were analysed for their boron concentration as well as their boron isotopic composition by thermal ionisation mass spectrometry (TIMS) using isotope dilution as the calibration technique. For all five reference materials the isotopic composition obtained on the basis of the gravimetric data agreed very well with the isotopic composition obtained from different TIMS techniques. Stability and homogeneity studies that were performed showed no significant influence on the isotopic composition or on the related uncertainties. The three reference materials ERM-AE120, ERM-AE121 and ERM-AE122 are the first reference materials with natural δ11B values not equal to 0‰. The certified δ11B values are -20.2‰ for ERM-AE120, 19.9‰ for ERM-AE121 and 39.7‰ for ERM-AE122, each with an expanded uncertainty (k = 2) of 0.6‰. These materials were produced to cover about three-quarters of the known natural boron isotope variation. The 10B enriched isotope reference materials ERM-AE102a and ERM-AE104a were produced for industrial applications utilising 10B for neutron shielding purposes. The certified 10B isotope abundances are 0.29995 for ERM-AE102a and 0.31488 for ERM-AE104a with expanded uncertainties (k = 2) of 0.00027 and 0.00028, respectively. Together with the formerly certified ERM-AE101 and ERM-AE103 a unique set of four isotope reference materials and three offset δ11B reference materials for boron isotope determination are now available from European Reference Materials. KW - Boron isotope variations KW - Delta-scale KW - Stable isotopes KW - Isotope reference materials KW - Delta reference materials KW - Metrology in chemistry KW - Absolute isotope abundance PY - 2012 DO - https://doi.org/10.1111/j.1751-908X.2011.00136.x SN - 1639-4488 SN - 1751-908X VL - 36 IS - 2 SP - 161 EP - 175 PB - Blackwell CY - Oxford AN - OPUS4-26260 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Vogl, Jochen A1 - Kipphardt, Heinrich A1 - Matschat, Ralf T1 - CCQM-P62: purity of nickel with respect to six defined metallic analytes - Final assessment T2 - Meeting of CCQM-Inorganic Analytical Working Group CY - Beijing, China DA - 2006-10-16 PY - 2006 AN - OPUS4-13993 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CHAP A1 - Vogl, Jochen A1 - Pritzkow, Wolfgang ED - Vanhaecke, F. ED - Degryse, P. T1 - Reference materials in isotopic analysis KW - ICPMS KW - IRM KW - Reference materials KW - Delta reference materials PY - 2012 SN - 978-3-527-32896-3 IS - Chapter 6 SP - 139 EP - 163 PB - Wiley-VCH Verlag GmbH & Co. KGaA CY - Weinheim AN - OPUS4-26102 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Völling, E. A1 - Reifarth, N. A1 - Vogl, Jochen ED - Nosch, M.-L. ED - Laffineur, R. T1 - The intercultural context of treasure A in Troy - jewellery and textiles T2 - 13th International Aegean Conference CY - Copenhagen, Denmark DA - 2010-04-21 PY - 2012 SN - 978-90-429-2665-3 SP - 531 EP - 538 PB - Peeters Publishers CY - Liège, Belgium AN - OPUS4-26408 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -