TY - JOUR A1 - Vollhardt, D. A1 - Emrich, G. A1 - Siegel, S. A1 - Rudert, Rainer T1 - Phase Transition in Monolayers of Straight Chain and 2-Methyl Branched Alcohols at the Air-Water Interface N2 - Monolayers of straight chain and 2-methyl branched chain alcohols with alkyl chain lengths of C10-C18 are experimentally studied by a conventional film balance technique combined with a Brewster angle microscope (BAM). The comparison of the surface pressure ()-area (A) isotherms with the corresponding BAM images provides information on the phase behavior and the first-order main phase transition of the monolayers. Striking differences in the dependence of the phase transition pressure on temperature of the straight chain and 2-methyl-substituted alcohols are correlated with differences in the molecular ordering. The general conditions for the main phase transition in the corresponding homologous alcohols can be derived. The effect of alkyl chain length and 2-methyl substitution on the general textural features of the condensed phase domains is determined under equilibrium and nonequilibrium conditions. n-Alcohol monolayers form defined and well-shaped condensed phase domains, often with inner texture in equilibrium. The long-range orientational order is strongly reduced in the condensed phase of 2-methyl-alcohols. Therefore, in the two-phase coexistence region of 2-methyl-alcohol monolayers only irregularly shaped domains without any inner structure are formed, which cannot be observed at the medium alkyl chain length C14 because of the low contrast. Model calculations of the two-dimensional lattice structure of the racemic 2-methyl-hexadecanol on the basis of the pg space group are performed and correspond well with the reduced ordering concluded from the experiments. PY - 2002 DO - https://doi.org/10.1021/la0201671 SN - 0743-7463 SN - 1520-5827 VL - 18 IS - 17 SP - 6571 EP - 6577 PB - American Chemical Society CY - Washington, DC AN - OPUS4-2032 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Paris, O. A1 - Li, C. A1 - Siegel, S. A1 - Weseloh, G. A1 - Emmerling, Franziska A1 - Riesemeier, Heinrich A1 - Erko, A. A1 - Fratzl, P. T1 - A new experimental station for simultaneous X-ray microbeam scanning for small- and wide-angle scattering and fluorescence at BESSY II N2 - A new instrument for simultaneous microbeam small- and wide-angle X-ray scattering and X-ray fluorescence (SAXS/WAXS/XRF) is presented. The instrument is installed at the microfocus beamline at BESSY II and provides a beam of 10 µm size with a flux of about 109 photons s-1. A SAXS resolution up to 500 Å d-spacing and a range of scattering vectors of almost three orders of magnitude are reached by using a large-area high-resolution CCD-based detector for simultaneous SAXS/WAXS. The instrument is particularly suited for scanning SAXS/WAXS/XRF experiments on hierarchically structured biological tissues. The necessary infrastructure, such as a cryo-stream facility and an on-site preparation laboratory for biological specimens, are available. KW - Scanning SAXS KW - Scanning WAXS KW - Microbeam KW - Synchrotron radiation PY - 2007 SN - 0021-8898 SN - 1600-5767 VL - 40 IS - Supplement SP - s466 EP - s470 PB - Blackwell CY - Oxford AN - OPUS4-15049 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Siegel, G. A1 - Mockenhaupt, F.H.M.E. A1 - Behnke, A.-L. A1 - Ermilov, Eugeny A1 - Winkler, K. A1 - Pries, A.R. A1 - Malmsten, M. A1 - Hetzer, R. A1 - Saunders, R. A1 - Lindman, B. T1 - Lipoprotein binding to anionic biopolyelectrolytes and the effect of glucose on nanoplaque formation in arteriosclerosis and Alzheimer's disease N2 - Arteriosclerosis with its clinical sequelae (cardiac infarction, stroke, peripheral arterial occlusive disease) and vascular/Alzheimer dementia not only result in far more than half of all deaths but also represent dramatic economic problems. The reason is, among others, that diabetes mellitus is an independent risk factor for both disorders, and the number of diabetics strongly increases worldwide. More than one-half of infants in the first 6 months of life have already small collections of macrophages and macrophages filled with lipid droplets in susceptible segments of the coronary arteries. On the other hand, the authors of the Bogalusa Heart Study found a strong increase in the prevalence of obesity in childhood that is paralleled by an increase in blood pressure, blood lipid concentration, and type 2 Diabetes mellitus. Thus, there is a clear linkage between arteriosclerosis/Alzheimer's disease on the one hand and diabetes mellitus on the other hand. Furthermore, it has been demonstrated that distinct apoE isoforms on the blood lipids further both arteriosclerotic and Alzheimer nanoplaque formation and therefore impair flow-mediated vascular reactivity as well. Nanoplaque build-up seems to be the starting point for arteriosclerosis and Alzheimer's disease in their later full clinical manifestation. In earlier work, we could portray the anionic biopolyelectrolytes syndecan/perlecan as blood flow sensors and lipoprotein receptors in cell membrane and vascular matrix. We described extensively molecular composition, conformation, form and function of the macromolecule heparan sulfate proteoglycan (HS-PG). In two supplementary experimental settings (ellipsometry, myography),we utilized isolated HS-PG for in vitro nanoplaque investigations and isolated human coronary artery segments for in vivo tension measurements. With the ellipsometry-based approach, we were successful in establishing a direct connection on a molecular level between diabetes mellitus on the one side and arteriosclerosis/Alzheimer's disease on the other side. Application of glucose at a concentration representative for diabetics and leading to glycation of proteins and lipids, entailed a significant increase in arteriosclerotic and Alzheimer nanoplaque formation. IDLapoE4/E4 was by far superior to IDLapoE3/E3 in Plaque build-up, both in diabetic and non-diabetic patients. Recording vascular tension of flow-dependent reactivity in blood substitute solution and under application of different IDLapoE isoforms showed an impaired vasorelaxation for pooled IDL and IDLapoE4/E4, thus confirming the ellipsometric investigations. Incubation in IDLapoE0/E0 (apoE “knockout man”), however, resulted in a massive flowmediated contraction, also complemented by strongly aggregated nanoplaques. In contrast, HDL was shown to present a powerful protection against nanoplaque formation on principle, both in the in vitro model and the in vivo scenario on the endothelial cell membrane. The competitive interplay with LDL is highlighted through the flow experiment, where flow-mediated, HDL-induced vasodilatation remains untouched by additional incubation with LDL. This is due to the four times higher affinity for the proteoglycan receptor of HDL as compared to LDL. Taken together, the studies demonstrate that while simplistic, the ellipsometry approach and the endothelialmimicking proteoglycan-modified surfaces provide information on the initial steps of lipoprotein-related Plaque formation, which correlates with findings on endothelial cells and blood vessels, and afford insight into the role of lipoprotein deposition and Exchange phenomena at the onset of these pathophysiologies. KW - Diabetes mellitus and Alzheimer's disease KW - HS-PG flow sensor and lipoprotein receptor KW - Glucose and nanoplaque formation KW - IDLapoE3/E3 and IDLapoE4/E4 isoforms KW - HDL protection KW - β-amyloid (1–42) PY - 2016 DO - https://doi.org/10.1016/j.cis.2016.02.001 SN - 0001-8686 VL - 232 SP - 25 EP - 35 AN - OPUS4-37078 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Bonse, Jörn A1 - Bachelier, G. A1 - Siegel, J. A1 - Solis, J. A1 - Sturm, Heinz T1 - Time- and space-resolved dynamics of ablation and optical breakdown induced by femtosecond laser pulses in indium phosphide N2 - Femtosecond time-resolved microscopy has been used to analyze the structural transformation dynamics (melting, ablation, and solidification phenomena) induced by single intense 130 fs laser pulses in single-crystalline (100)-indium phosphide wafers in air on a time scale from ~100 fs up to 8 ns. In the ablative regime close to the ablation threshold, transient surface reflectivity patterns are observed by fs microscopy on a ps to ns time scale as a consequence of the complex spatial density structure of the ablating material (dynamic Newton fringes). At higher fluences, exceeding six times the ablation threshold, optical breakdown causes another, more violent ablation regime, which reduces the energy deposition depth along with the time of significant material removal. As a consequence, ablation lasts longer in a ring-shaped region around the region of optical breakdown. This leads to the formation of a crater profile with a central protrusion. In the melting regime below the ablation threshold, the melting dynamics of indium phosphide has been quantified and subsequent superficial amorphization has been observed upon solidification on the ns time scale leading to amorphous layer thicknesses of the order of a few tens of nanometers. KW - Femtosecond laser pulse KW - Indium Phosphide KW - Ablation KW - Surface reflectivity KW - Fs-time resolved microscopy KW - Scanning Force Microscopy PY - 2008 DO - https://doi.org/10.1063/1.2885105 SN - 0021-8979 SN - 1089-7550 VL - 103 IS - 5 SP - 054910-1 EP - 054910-6 PB - American Institute of Physics CY - Melville, NY AN - OPUS4-17090 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Bonse, Jörn A1 - Bachelier, G. A1 - Wiggins, S. M. A1 - Siegel, J. A1 - Solis, J. A1 - Krüger, Jörg A1 - Sturm, Heinz T1 - Femtosecond laser ablation of indium phosphide in air: dynamical, structural and morphological evolution N2 - The irradiation of single-crystalline indium phosphide (c-InP) by Ti:sapphire femtosecond laser pulses (130 fs, 800 nm) in air is studied by means of in-situ time resolved reflectivity measurements [fs-time-resolved microscopy (100 fs-10 ns) and point probing analysis (ns - µs)] and by complementary ex-situ surface analytical methods (Micro Raman Spectroscopy, Scanning Force, and Optical Microscopy). The dynamics of melting, ablation, and optical breakdown as well as structural changes resulting from rapid solidification are investigated in detail. Different laser-induced surface morphologies are characterized and discussed on the basis of recent ablation and optical breakdown models. KW - Femtosecond laser ablation KW - Optical breakdown KW - Time-resolved measurements KW - Semiconductor KW - Indium phosphide PY - 2010 SN - 1454-4164 VL - 12 IS - 3 SP - 421 EP - 426 PB - INOE & INFM CY - Bucharest AN - OPUS4-21082 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Stratakis, E. A1 - Bonse, Jörn A1 - Heitz, J. A1 - Siegel, J. A1 - Tsibidis, G.D. A1 - Skoulas, E. A1 - Papadopoulos, A. A1 - Mimidis, A. A1 - Joel, A.-C. A1 - Comanns, P. A1 - Krüger, Jörg A1 - Florian, C. A1 - Fuentes-Edfuf, Y. A1 - Solis, J. A1 - Baumgartner, W. T1 - Laser engineering of biomimetic surfaces N2 - The exciting properties of micro- and nano-patterned surfaces found in natural species hide a virtually endless potential of technological ideas, opening new opportunities for innovation and exploitation in materials science and engineering. Due to the diversity of biomimetic surface functionalities, inspirations from natural surfaces are interesting for a broad range of applications in engineering, including phenomena of adhesion, friction, wear, lubrication, wetting phenomena, self-cleaning, antifouling, antibacterial phenomena, thermoregulation and optics. Lasers are increasingly proving to be promising tools for the precise and controlled structuring of materials at micro- and nano-scales. When ultrashort-pulsed lasers are used, the optimal interplay between laser and material parameters enables structuring down to the nanometer scale. Besides this, a unique aspect of laser processing technology is the possibility for material modifications at multiple (hierarchical) length scales, leading to the complex biomimetic micro- and nano-scale patterns, while adding a new dimension to structure optimization. This article reviews the current state of the art of laser processing methodologies, which are being used for the fabrication of bioinspired artificial surfaces to realize extraordinary wetting, optical, mechanical, and biological-active properties for numerous applications. The innovative aspect of laser functionalized biomimetic surfaces for a wide variety of current and future applications is particularly demonstrated and discussed. The article concludes with illustrating the wealth of arising possibilities and the number of new laser micro/nano fabrication approaches for obtaining complex high-resolution features, which prescribe a future where control of structures and subsequent functionalities are beyond our current imagination. KW - Biomimetic surfaces KW - Laser processing KW - Surface functionalization KW - Bioinspiration KW - Bionic materials PY - 2020 DO - https://doi.org/10.1016/j.mser.2020.100562 SN - 0927-796X VL - 141 SP - 100562-1 EP - 100562-47 PB - Elsevier B.V. AN - OPUS4-50927 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -