TY - JOUR A1 - Sadowski, A. A1 - Seidel, M. A1 - Al-Lawati, H. A1 - Azizi, E. A1 - Balscheit, Hagen A1 - Böhm, M. A1 - Chen, Lei A1 - van Dijk, I. A1 - Doerich-Stavridis, C. A1 - Kunle Fajuyitan, O. A1 - Filippidis, A. A1 - Winther Fischer, A. A1 - Fischer, C. A1 - Gerasimidis, S. A1 - Karampour, H. A1 - Kathirkamanathan, L. A1 - Subramanian, S. A1 - Topkaya, Cem A1 - Wagner, H. N. R. A1 - Wang, J. A1 - Wang, J. A1 - Kumar Yadav, K. A1 - Yun, X. A1 - Zhang, P. T1 - 8-MW wind turbine tower computational shell buckling benchmark - Part 1: An international ‘round-robin’ exercise N2 - An assessment of the elastic-plastic buckling limit state for multi-strake wind turbine support towers poses a particular challenge for the modern finite element analyst, who must competently navigate numerous modelling choices related to the tug-of-war between meshing and computational cost, the use of solvers that are robust to highly nonlinear behaviour, the potential for multiple near-simultaneously critical failure locations, the complex issue of imperfection sensitivity and finally the interpretation of the data into a safe and economic design. This paper reports on an international ‘round-robin’ exercise conducted in 2022 aiming to take stock of the computational shell buckling expertise around the world which attracted 29 submissions. Participants were asked to perform analyses of increasing complexity on a standardised benchmark of an 8-MW multi-strake steel wind turbine support tower segment, from a linear elastic stress analysis to a linear bifurcation analysis to a geometrically and materially nonlinear buckling analysis with imperfections. The results are a showcase of the significant shell buckling expertise now available in both industry and academia. This paper is the first of a pair. The second paper presents a detailed reference solution to the benchmark, including an illustration of the Eurocode-compliant calibration of two important imperfection forms. KW - Wind turbine tower KW - Computational KW - Shell buckling KW - Benchmark PY - 2023 DO - https://doi.org/10.1016/j.engfailanal.2023.107124 SN - 1350-6307 VL - 148 SP - 1 EP - 23 PB - Elsevier Science CY - Oxford AN - OPUS4-57019 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Szafarska, E. A1 - Mohr, F. A1 - Fischer, E. A1 - Erhard, Anton T1 - Phased array: well qualified for core shroud inspection PY - 1997 SN - 0029-5507 VL - 1/9 SP - 24 EP - 25 PB - Business Press Internat. CY - Sutton AN - OPUS4-18770 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Pyzalla, A. A1 - Pinto, H. A1 - Wild, E. A1 - Poeste, T. A1 - Bohne, C. A1 - Reimers, W. A1 - Aßmus, Kristin A1 - Hübner, Wolfgang A1 - Fischer, A. ED - Bartz, Wilfried J. T1 - Mechanical Stress in Tribo-Layers T2 - 14th International Colloquium Tribology "Tribology and Lubrication Engineering" CY - Stuttgart, Deutschland DA - 2004-01-13 PY - 2004 SN - 3-924813-54-X VL - I SP - 85 EP - 89 PB - Techn. Akad. Esslingen CY - Ostfildern AN - OPUS4-3144 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Brose, M. A1 - Ludwig, Th. A1 - Püster, Th. A1 - Bunte, J. A1 - Fiedler, A. A1 - Fischer, M. A1 - Heberer, E. A1 - Kautek, Wolfgang A1 - Spielmann, Ch. T1 - Ultrakurzpuls-Laser: Anwendungen, Risiken, Sicherheitsmaßnahmen KW - Arbeitsschutz KW - Lasersicherheit KW - Ultrakurzpuls-Laser KW - Femtosekunden-Technologie KW - Laserstrahlung KW - Strahlenschutz PY - 2004 SN - 0947-434X VL - 9 IS - 2 SP - 34 EP - 43 PB - Verl. TÜV Rheinland CY - Köln AN - OPUS4-3586 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Wüstenberg, Hermann A1 - Hauser, T. A1 - Boehm, R. A1 - Hintze, H. A1 - Fischer, E. T1 - Neue Ansätze zur Ultraschallprüfung von Eisenbahnachsen mit Array-Prüfköpfen T2 - Jahrestagung Zerstörungsfreie Materialprüfung ; 2001 (Berlin) : 2001.05.21-23 CY - Berlin, Deutschland DA - 2001-05-21 PY - 2001 UR - http://www.ndt.net/article/dgzfp01/papers/v20/v20.htm N1 - Serientitel: Berichtsband / Deutsche Gesellschaft für zerstörungsfreie Prüfung e. V. – Series title: Berichtsband / Deutsche Gesellschaft für zerstörungsfreie Prüfung e. V. IS - 75-CD PB - DGZfP CY - Berlin AN - OPUS4-1136 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Liebner, Christian A1 - Fischer, J. A1 - Heinrich, Sebastian A1 - Lange, T. A1 - Hieronymus, Hartmut A1 - Klemm, E. T1 - Are micro reactors inherently safe? An investigation of gas phase explosion propagation limits on ethene mixtures N2 - A method for the determination of safety properties for micro reactors and micro structured components is presented. Micro structured reactors are not inherently safe but the range of safe operating conditions of micro reactors are extended since the explosion region is reduced. The λ/3 rule was demonstrated to be applicable to micro scale tubes for stoichiometric mixtures of ethane–oxygen and ethane–nitrous oxide. Furthermore first results from an investigation concerning detonation propagation through a micro reactor of non-ideal geometry are shown. Initial pressure investigated is ranging from low pressure up to 100 kPa. KW - Micro reactor KW - Explosion propagation limits KW - Chemical safety KW - Investigation method PY - 2012 DO - https://doi.org/10.1016/j.psep.2011.08.006 SN - 0957-5820 SN - 1744-3598 VL - 90 IS - 2 SP - 77 EP - 82 PB - Elsevier CY - Amsterdam AN - OPUS4-25594 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Hieronymus, Hartmut A1 - Fischer, J. A1 - Heinrich, Sebastian A1 - Liebner, Christian A1 - Lange, T. A1 - Klemm, E. T1 - Sicherheitstechnische Untersuchungen zum Betrieb von Mikroreaktoren im Explosionsbereich N2 - Es wird eine Methode zur sicherheitstechnischen Untersuchung von Mikroreaktoren und mikrostrukturierten Komponenten, die im Explosionsbereich betrieben werden sollen, vorgestellt. Mikrostrukturierte Reaktoren sind nicht inhärent sicher, wenngleich der Bereich der sicheren Betriebsbedingungen gegenüber konventionellen Reaktoren erweitert ist. Der Explosionsbereich kann durch die Mikrostrukturen eingeengt werden. Am Beispiel von Ethylen/Sauerstoff-Gemischen und Ethylen/N2O-Gemischen wird hinsichtlich der Ausbreitung von Detonationen durch Kapillarrohre gezeigt, dass die sogenannte λ/3-Regel angewandt werden kann. Darüber hinaus werden erste Ergebnisse der Untersuchung der Ausbreitung von Explosionen durch einen Mikroreaktor mit rechteckigem Strömungskanal vorgestellt. KW - Detonationszellbreite KW - Explosionsgrenzen KW - Mikroreaktoren KW - Sicherheitstechnik KW - Detonation cell width KW - Explosion limit KW - Microreactor KW - Saftey engineering PY - 2011 DO - https://doi.org/10.1002/cite.201100112 SN - 0009-286X SN - 1522-2640 VL - 83 IS - 10 SP - 1742 EP - 1747 PB - Wiley-VCH Verl. CY - Weinheim AN - OPUS4-24486 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Liebner, Christian A1 - Hieronymus, Hartmut A1 - Fischer, J. A1 - Klemm, E. T1 - Mikrostrukturierte Reaktoren im Explosionsbereich - Untersuchungsmethoden zu Fragen der (nicht vorhandenen) inhärenten Sicherheit T2 - 9. Fachtagung "Anlagen-, Arbeits- und Umweltsicherheit" CY - Köthen, Deutschland DA - 2008-11-06 KW - Mikroverfahrenstechnik KW - Mikroreaktor KW - Explosionsbereich KW - Ethylen KW - Explosionsausbreitung PY - 2008 SN - 978-3-89746-099-7 SP - 1 EP - 4 PB - VDI, Hallescher Bezirksverein CY - Halle AN - OPUS4-18373 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Erhard, Anton A1 - Wüstenberg, Hermann A1 - Fischer, E. A1 - Rathgeb, Werner A1 - Tagliamonte, M. T1 - Increasing the Reliability and Redundancy for Reactor Pressure Vessel Weld Inspection by Advanced UT-Techniques T2 - EPRI, Vessel and Internal Inspection Conference CY - San Antonio, TX, USA DA - 1994-07-11 PY - 1994 AN - OPUS4-18853 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Erhard, Anton A1 - Wüstenberg, Hermann A1 - Fischer, E. A1 - Rathgeb, Werner T1 - Ultrasonic Hybrid-Phased-Array-Probe for Weld Inspection at the BWR Pressure Vessel T2 - 6th ECNDT-European Conference on Non Destructive Testing CY - Nice, France DA - 1994-10-24 PY - 1994 AN - OPUS4-18855 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -