TY - JOUR A1 - Vierneusel, B. A1 - Schneider, Thomas A1 - Tremmel, S. A1 - Wartzack, S. A1 - Gradt, Thomas T1 - Humidity resistant MoS2 coatings deposited by unbalanced magnetron sputtering N2 - MoS2 is a suitable solid lubricant for environments free of oxygen or water vapor (i.e. vacuum). Humid air degrades film properties due to oxidation accompanied by high wear and increasing coefficients of friction. The present study aims at the further development of sputtered pure MoS2 coatings, extending their applicability to varying environmental conditions by increasing the resistance against humidity. The systematic coating development process is supported by using an experimental Box–Behnken design with variations of the deposition parameters cathode voltage, target/substrate distance, temperature and argon gas pressure. In contrast to common one-factor-at-a-time (OFAT) studies, this approach enables a determination of interactions between deposition process parameters and tribological–mechanical MoS2 film properties. The tribological improvement focuses on a maximization of wear resistance in air and vacuum measured in ball-on-disk experiments. The evaluated mechanical properties are hardness, elastic modulus and residual stresses. These stresses were determined by the substrate curvature method. The study reveals that the residual stress state in the films and the hardness-to-modulus ratio are crucial for their tribological performance in humid air and vacuum environments. After a detailed determination of the relationships between deposition conditions and film properties, some selected microstructural analyses are presented which show that a substantially basal orientation of the lattice has positive effects on wear but also causes anisotropic film properties which result in fissile fracture of the coating if strong shock or point loads occur. KW - Unbalanced magnetron sputtering KW - MoS2 KW - Humidity resistance KW - Residual stress PY - 2013 U6 - https://doi.org/10.1016/j.surfcoat.2013.07.019 SN - 0257-8972 VL - 235 SP - 97 EP - 107 PB - Elsevier B.V. AN - OPUS4-29729 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -