TY - CONF A1 - Eberstein, Markus A1 - Müller, Ralf A1 - Reinsch, Stefan A1 - Rabe, Torsten A1 - Schiller, Wolfgang Arno A1 - Thiel, A. A1 - Deubener, J. T1 - Kinetic Modeling of LTCC-Shrinkage T2 - 3rd International Conference and Exhibition on Ceramic Interconnect and Ceramic Microsystems Technologies (CICMT 2007) CY - Denver, CO, USA DA - 2007-04-23 KW - LTCC KW - Glass matrix composites KW - Inclusions KW - Sintering kinetics KW - Modeling PY - 2007 SP - 1 EP - 8 PB - American Ceramic Soc. CY - Denver AN - OPUS4-14948 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Eberstein, Markus A1 - Rabe, Torsten A1 - Schiller, Wolfgang Arno T1 - Ceramic substrates based on LTCC Multilayer Technology T2 - Eqyptian-German Workshop on Advanced Materials CY - Stuttgart, Germany DA - 2007-09-03 PY - 2007 AN - OPUS4-15861 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Eberstein, Markus A1 - Müller, Ralf A1 - Reinsch, Stefan A1 - Rabe, Torsten A1 - Schiller, Wolfgang Arno A1 - Thiel, A. A1 - Deubener, J. T1 - Kinetic modelling of LTCC-Shrinkage T2 - IMAP/ACerS 3rd Int. Conf. and Exhibition on Ceramic Interconnect and Ceramic Microsystems Technologies (CICMT) CY - Denver, CO, USA DA - 2007-04-23 PY - 2007 AN - OPUS4-15874 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Eberstein, Markus A1 - Müller, Ralf A1 - Reinsch, Stefan A1 - Rabe, Torsten A1 - Schiller, Wolfgang Arno A1 - Thiel, A. A1 - Deubener, J. T1 - Kinetic Modeling of LTCC Shrinkage: Effect of Alumina Content N2 - We studied sintering of LTCC-type glass matrix composites (GMCs) consisting of small glass and alumina particles of equal size. Primarily, crystals act as rigid inclusions, decelerating the densification rate. In later stages, they also dissolve, partially increasing the viscosity. Release of alumina finally induces crystallization of alumosilicates, which enables post-firing stability. To study both effects, two model GMCs were prepared: an α-Al2O3 + barium alumoborosilicate glass (BABS)–GMC, which shows neither significant dissolution nor crystallization, and an α-Al2O3 + calcium alumoborosilicate glass (CABS)–GMC, which dissolves readily and promotes crystallization. The kinetics of shrinkage for both GMC were modeled by utilizing Frenkel theory for the early stage and Mackenzie–Shuttleworth theory for the late stage, assuming that sintering is superimposed by the weighted contributions of triparticle glass–crystal clusters, their random occurrence (ideal mixing), and a shrinkage rate controlled by the GMC effective viscosity. In agreement with modeling, the experimental results showed that the shrinkage rate of BABS–GMC decreases progressively for crystal volume fractions Φ > 0.15. The attainable shrinkage is reduced by up to 8% for Φ = 0.45. For the CABS–GMC with Φ = 0.25, a reduction of Φ to 0.20 was evident due to partial α-Al2O3 dissolution. This effect was found able to increase the sintering temperature by ~50–60 K. KW - LTCC KW - Glas Matrix Composites KW - Inclusions KW - Sintering Kinetics KW - Modeling PY - 2007 SN - 1551-4897 VL - 4 IS - 4 SP - 173 EP - 180 CY - Washington, DC AN - OPUS4-16506 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Reinsch, Stefan A1 - Müller, Ralf A1 - Eberstein, Markus A1 - Deubener, J. A1 - Thiel, A. A1 - Schiller, Wolfgang Arno ED - J.G. Heinrich, ED - C.G. Aneziris, T1 - Effect of dispersed Al2O3 particles on sintering of glass matrix composites T2 - 10th International Conference of the European Ceramic Society CY - Berlin DA - 2007-06-17 KW - LTCC KW - Glass matrix composites KW - Inclusions KW - Sintering kinetics KW - Modelling PY - 2007 SN - 3-87264-022-4 SP - 290 EP - 295 PB - Göller CY - Baden-Baden AN - OPUS4-17445 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Mann, Guido A1 - Vogel, Jens A1 - Preuß, Rüdiger A1 - Vaziri, Pouya A1 - Zoheidi, M. A1 - Eberstein, Markus A1 - Krüger, Jörg T1 - Nanosecond laser damage resistance of differently prepared semi-finished parts of optical multimode fibers N2 - Optical multimode fibers are applied in materials processing (e.g. automotive industry), defense, aviation technology, medicine and biotechnology. One challenging task concerning the production of multimode fibers is the enhancement of laser-induced damage thresholds. A higher damage threshold enables a higher transmitted average power at a given fiber diameter or the same power inside a thinner fiber to obtain smaller focus spots. In principle, different material parameters affect the damage threshold. Besides the quality of the preform bulk material itself, the drawing process during the production of the fiber and the preparation of the fiber end surfaces influence the resistance. Therefore, the change of the laser-induced damage threshold of preform materials was investigated in dependence on a varying thermal treatment and preparation procedure. Single and multi-pulse laser-induced damage thresholds of preforms (F300, Heraeus) were measured using a Q-switched Nd:YAG laser at 1064 nm wavelength emitting pulses with a duration of 15 ns, a pulse energy of 12 mJ and a repetition rate of 10 Hz. The temporal and spatial shape of the laser pulses were controlled accurately. Laser-induced damage thresholds in a range from 150 J cm-2 to 350 J cm-2 were determined depending on the number of pulses applied to the same spot, the thermal history and the polishing quality of the samples, respectively. KW - Laser ablation KW - Optical fibers KW - Physical radiation damage KW - Radiation treatment KW - Glass transitions KW - Glasses PY - 2007 DO - https://doi.org/10.1016/j.apsusc.2007.09.032 SN - 0169-4332 SN - 1873-5584 VL - 254 IS - 4 SP - 1096 EP - 1100 PB - North-Holland CY - Amsterdam AN - OPUS4-16207 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Müller, Ralf A1 - Eberstein, Markus A1 - Reinsch, Stefan A1 - Schiller, Wolfgang Arno A1 - Deubener, J. A1 - Thiel, A. T1 - Effect of rigid inclusions on sintering of low temperature co-fired ceramics KW - Sintering KW - Glass Matrix Composites KW - Rigid Inclusion KW - Effective Viscosity KW - Kinetic Modelling KW - LTCC PY - 2007 SN - 1753-3562 SN - 0017-1050 SN - 0031-9090 SN - 1750-6697 VL - 48 IS - 4 SP - 259 EP - 266 PB - Society of Glass Technology CY - Sheffield AN - OPUS4-16211 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Thiel, A. A1 - Eberstein, Markus A1 - Müller, Ralf A1 - Deubener, J. T1 - Viskosität von Glasmatrix-Kompositen mit partiell löslicher kristalliner Dispersphase T2 - 81. Glastechnische Tagung und 4. DGG-Symposium "Novel Optical Technologies" CY - Aachen, Deutschland DA - 2007-06-04 KW - Glasmatrixkomposite KW - Lösung KW - Sintern PY - 2007 SN - 978-3-921089-52-1 IS - CD-ROM SP - 1 EP - 8 PB - Deutsche Glastechnische Gesellschaft CY - Offenbach AN - OPUS4-16212 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Rabe, Torsten A1 - Eberstein, Markus A1 - Schiller, Wolfgang Arno ED - Kevin Ewsuk, ED - Kiyoshi Nogi, ED - Wäsche, Rolf ED - Yukichi Umakoshi, ED - Tom Hinklin, ED - Keizo Uematsu, ED - Tony Tomsia, ED - Hiroya Abe, ED - Hidehiro Kamiya, ED - Makio Naito, T1 - Low Temperature Co-Fired Ceramics (LTCC) - Design and Characterization of Interfaces T2 - 2nd International Conference on Characterization and Control of Interfaces for High Quality Advanced Materials, and Joining Technology for New Metallic Glasses and Inorganic Materials 2006 CY - Kurashiki, Japan DA - 2006-09-06 KW - Grenzflächenreaktionen KW - Keramische Multilayer KW - Sintern PY - 2007 SN - 978-0-470-18414-1 VL - 198 SP - 173 EP - 178 PB - John Wiley & Sons, Ltd. AN - OPUS4-16123 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - GEN A1 - Reinsch, Stefan A1 - Meng, S. A1 - Eberstein, Markus A1 - Thiel, A. A1 - Müller, Ralf A1 - Deubener, J. T1 - Partial Solution of Dispersed alpha-Al2O3-Particles in Alumoborosilicate Glass T2 - 81. Glastechnische Tagung CY - Aachen, Deutschland DA - 2007-06-04 KW - Glasmatrixkomposite KW - Lösung KW - Sintern PY - 2007 SN - 978-3-921089-52-1 IS - CD-ROM SP - 1 EP - 5 PB - Deutsche Glastechnische Gesellschaft CY - Offenbach AN - OPUS4-16108 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -