TY - JOUR A1 - Becker, Roland A1 - Buge, Hans-Gerhard A1 - Win, Tin T1 - Determination of pentachlorphenol (PCP) in waste wood - method comparison by a collaborative trial JF - Chemosphere N2 - Two independently developed and validated procedures for the determination of pentachlorophenol (PCP) in waste wood were compared by means of a collaborative trial. Both methods foresee quantification of PCP by gas chromatography (GC-ECD) after acetylation and differ with regard to the use of methanol or toluene/sulphuric acid, respectively, as solvent in the sonication extraction step. Test samples with established analyte homogeneity were prepared from a ground “real life” starting material. A total of 23 participating laboratories with experience in wood preservative analysis were instructed to apply both methods to three levels of content in the range of 0.5–20 mg PCP/kg. In case of the toluene/sulphuric acid extraction, lower recoveries and higher interlaboratory dispersion of results at the higher PCP contents were observed. Seen against the background of the Horwitz equation a reproducibility standard deviation of not, vert, similar19% for the methanol extraction at the 4.5 mg/kg level meets the requirement for a sound analytical method. Thus, the sonication extraction procedure with methanol has been annexed as a reference method to the German waste wood regulation. KW - Extraction KW - Derivatisation KW - Sonication KW - Analysis KW - Gas chromatography KW - Regulation PY - 2002 DO - https://doi.org/10.1016/S0045-6535(02)00004-8 SN - 0045-6535 SN - 0366-7111 VL - 47 SP - 1001 EP - 1006 PB - Elsevier Science CY - Kidlington, Oxford AN - OPUS4-1628 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - JOUR A1 - Becker, Roland A1 - Buge, Hans-Gerhard A1 - Bremser, Wolfram A1 - Nehls, Irene T1 - Mineral oil content in sediments and soils: comparability, traceability and a certified reference material for quality assurance JF - Analytical and bioanalytical chemistry N2 - The performance of twelve laboratories with previously established proficiency in the determination of the mineral oil content in a fresh water sediment is described. The summation parameter total petrol hydrocarbon (TPH) is defined according to ISO 16703:2004 with regard to the sample preparation to be applied, the flame ionisation detection (FID) and the boiling range of C10–C40 to be integrated. Comprehensive tests of homogeneity and stability have been carried out on the candidate material using appropriate models. The outcome of the study served as the basis for the certification of the candidate reference material as ERM-CC015a. The certified mass fraction is 1,820±130mgkg-1 and traceability was established by using an appropriate calibration standard certified for the mass fraction of C10–C40. The interlaboratory scatter of measurement results in this exercise can largely be explained by the variability of the individual calibrations based on this common calibration standard. KW - Total petroleum hydrocarbons KW - Extraction KW - Gas chromatography KW - Calibration KW - Interlaboratory study PY - 2006 DO - https://doi.org/10.1007/s00216-006-0423-4 SN - 1618-2642 SN - 1618-2650 VL - 385 IS - 3 SP - 645 EP - 651 PB - Springer CY - Berlin AN - OPUS4-12399 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -