TY - CONF A1 - Afraz, N. A1 - Adi, A. A1 - Hecht, Kristin T1 - Gas/liquid mass transport in falling film reactor versus theory N2 - Introduction: Mass transport at gas/liquid interfaces depends on many factors including the gas and liquid properties and hydrodynamics. The mass transport of a gas through the liquid is a limiting step in many chemical reactions. To gain a fundamental understanding of multiphase interfaces, the rate of mass transfer has been measured for pure gases (H2, N2, O2, He) into a thin liquid film with a well-defined surface area and velocity profile. This enables the mass transfer rate to be broken down into one parameter, which is the gas/liquid interfacial area (a), and a second parameter, which is the mass transfer coefficient (kL). Using gases with varying diffusion coefficients enables a comparison of the measured rates of mass transport to the rates predicted by film theory and penetration theory. Method: A gravity-driven thin water film 0.000180 m in thickness flowing along the outer surface of a capillary was contacted with a gas phase inside a closed system. The liquid was circulated continuously until it was saturated with gas and the equilibrium pressure was reached. In this device, there is laminar flow, and therefore, the hydrodynamics of the liquid film are well defined. Results: Penetration theory predicts a non-linear relationship between diffusion coefficient (DAB) and mass transfer coefficient (kL). by means of falling film reactor the actual rates of gas-liquid mass transfer are higher than those predicted by theory. Also, a linear relationship between DAB and kL is observed experimentally. The mass transfer coefficient can even, as a rule of thumb, be assumed to be relatively constant with a value of around 10-4 m/s for aqueous solutions. T2 - 13th European Congress of Chemical Engineering (ECCE) CY - Online meeting DA - 20.09.2021 KW - Mehrphasenströmung KW - Stofftransport KW - Wasserstoff PY - 2021 AN - OPUS4-53679 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adão, Filipe Jorge Santos Ferreira A1 - Helmerich, Rosemarie A1 - Voigt, Gerrit A1 - Moldenhauer, Laura A1 - Neumann, Patrick P. T1 - Humidity monitoring in concrete using Bluetooth Low Energy sensors N2 - The vulnerability of low quality concrete to changing weather conditions is well known. The constant exposure to temperature changes, biological activity, and humidity ends up in damage to buildings and structures which contain this material. It is therefore necessary to take preventive measures to control the extent of the damage done by weathering and possible penetration of adverse chemicals into structures which need public safety. The Federal Institute for Materials Research and Testing (BAM), in cooperation with the small enterprise LinTech GmbH, is working on a project to monitor humidity changes in concrete by analyzing the changes in signal strength (RSSI) from Bluetooth Low Energy sensors. In this paper, we show results which demonstrate the influence of changing water content in concrete on the received RSSI. We observed that as water content in concrete decreases, the received RSSI improves. However, the damping effect is not linearly proportional to water content, rather exponentially proportional. This suggests that changes in the received signal strength are more easily observed when water content in concrete is higher. Finally, we reconstructed a RSSI distribution map using computed tomography T2 - SMAR 2017 CY - Zurich, Switzerland DA - 13.09.2017 KW - RSSI KW - Concrete KW - Water KW - Monitoring KW - Computed Tomography PY - 2017 AN - OPUS4-43599 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adolphs, Jürgen A1 - Rübner, Katrin A1 - Schnell, Alexander A1 - Prinz, Carsten A1 - Peplinski, Burkhard A1 - Hempel, Simone T1 - Porenstruktur hydrothermal erhärteter Granulate aus Mauerwerkbruch T2 - 19. Internationale Baustofftagung (ibausil) CY - Weimar DA - 2015-09-16 PY - 2015 AN - OPUS4-34497 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adamczyk, Burkart A1 - Brenneis, Rudolf A1 - Kühn, M. A1 - Mudersbach, D. T1 - Verwertung von Edelstahlschlacken: Gewinnung von Chrom - Schlacke als Rohstoffbasis T2 - Berliner Rohstoff- und Recyclingkonferenz - Aufbereitung und Verwertung mineralischer Stoffe und Abfälle CY - Berlin, Germany DA - 2008-11-05 PY - 2008 AN - OPUS4-18641 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adamczyk, Burkart A1 - Mory, D. A1 - Schiller, D. A1 - Adam, Christian T1 - Chemische OnLine-Analyse von Schmelzen im Lichtbogenofen durch LIBS N2 - Vorgestellt wird die Anwendung von LIBS zur OnLine-Analyse an mineralischen Hochtemperturschmelzen. Anforderungen und Besonderheiten der Methode, der Aufbau am Lichtbogenofen der BAM sowie erste Ergebnisse an Modellschmelzen werden präsentiert. T2 - Schlacken-Symposium 2016 CY - Meitingen, Germany DA - 13.10.2016 KW - Online-LIBS KW - Online-Analyse KW - Lichtbogenofen KW - Schmelzen PY - 2016 AN - OPUS4-38152 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adamczyk, Burkart A1 - Schraut, Katharina A1 - Adam, Christian T1 - Nachbehandlung von Stahlwerksschlacke und deren Verwertung als Klinkermaterial N2 - LD-Schlacken weisen eine große chemische Ähnlichkeit zu Protlandzementklinker auf. Sie enthalten jedoch noch bis zu 30% Eisen, das mineralisch in oxidischer Form gebunden vorliegt. Dadurch kann sich bei der Erstarrung die wichtigste Klinkerphase "Alit" nicht ausbilden. Durch eine reduzierende Schmelzbehandlung der Schlacke kann des mineralisch gebundene Eisen als Metall separiert werden. Dadurch wird auch die Mineralogie der Schlacke so verändert, dass auch sie nun praktisch einem Portlandzementklinker entspricht. Entsprechende Versuche wurden am kleintechnischen Lichtbogenofen der BAM durchgeführt. Es werden Ergebnisse vorgestellt und auf Grenzen und Möglichkeiten eines derartigen Prozesses im Hinblick auf eine industrielle Umsetzung eingegangen. T2 - Berliner Konferenz "Mineralische Nebenprodukte und Abfälle" CY - Berlin, Germany DA - 11.06.2018 KW - LD-Schlacke KW - Lichtbogenofen KW - Zementklinker PY - 2018 AN - OPUS4-45221 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adamczyk, Burkart A1 - Kley, Gerd A1 - Simon, Franz-Georg T1 - Thermochemical treatment of waste materials T2 - Global Symposium on Recycling, Waste Treatment and Clean Technology (REWAS' 04) CY - Madrid, Spain DA - 2004-09-26 PY - 2004 AN - OPUS4-5678 LA - eng AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adam, Karin A1 - Noack, M. A1 - Seidlitzki, G. A1 - Kölsch, P. A1 - Schäfer, R. A1 - Tussaint, P. T1 - Aluminium in MFI-Membranen: Verteilung und Lokalisierung während der Synthese, der Einfluss der Suporte und die Wirkung auf die Permeation T2 - 16. Deutsche Zeolith Tagung CY - Dresden, Germany DA - 2004-03-03 PY - 2004 AN - OPUS4-3317 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adam, Karin A1 - Kraus, Werner T1 - Untersuchung zur Korrosion von Quecksilberamalgamspiegeln T2 - 80. Jahrestagung der Deutschen Mineralogischen Gesellschaft CY - Hamburg, Germany DA - 2002-09-08 PY - 2002 AN - OPUS4-5852 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER - TY - CONF A1 - Adam, Christian A1 - Vogel, Christian T1 - Technische Möglichkeiten der Phosphorrückgewinnung aus Klärschlammaschen T2 - VDI Wissensforum Fachkonferenz Klärschlammbehandlung, Technologien - Wertstoffrückgewinnung - Entwicklungen CY - Offenbach am Main, Germany DA - 2010-10-27 PY - 2010 AN - OPUS4-22400 LA - deu AD - Bundesanstalt fuer Materialforschung und -pruefung (BAM), Berlin, Germany ER -